Instruction d'utilisation Frigidaire 316259359

Résumé du contenu de la page N° 1

30" GAS RANGE INSTALLATION INSTRUCTIONS
(For Models with Sealed Top Burners)
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
If the information in this manual is not followed
exactly, a fire or explosion may result causing property
damage, personal injury or death.
FOR YOUR SAFETY: Refer to your serial plate for
applicable agency certification
— Do not store or use g

Résumé du contenu de la page N° 2

30" GAS RANGE INSTALLATION INSTRUCTIONS (For Models with Sealed Top Burners) Important Notes to the Installer Never leave children alone or unattended 1. Read all instructions contained in these installation in the area where an appliance is in use. As children grow, instructions before installing range. teach them the proper, safe use of all appliances. Never leave 2. Remove all packing material from the oven compartments the oven door open when the range is unattended. before connecting the g

Résumé du contenu de la page N° 3

30" GAS RANGE INSTALLATION INSTRUCTIONS (For Models with Sealed Top Burners) A. Locate the Bracket Using the Template - (Bracket may Before Starting be located on either the left or right side of the range. Use Tools You Will Need the information below to locate the bracket if template is For leveling legs and Anti-Tip Bracket: not available). Mark the floor or wall where left or right side of the range will be located. If rear of range is against the  Adjustable wrench or channel lock plier

Résumé du contenu de la page N° 4

10-1/2" 15" 7" 23" 11-1/2" 30" GAS RANGE INSTALLATION INSTRUCTIONS (For Models with Sealed Top Burners) C. Level and Position Range - Level range by adjusting the 4. Connect the range to the gas supply. (4) leveling legs with a wrench. Note: A minimum clearance NOTE: To prevent leaks use pipe joint sealant on all male of 1/8" is required between the bottom of the range and the (outside) pipe threads. leveling leg to allow room for the bracket. Use a spirit level to check your adjustments. Slid

Résumé du contenu de la page N° 5

30" GAS RANGE INSTALLATION INSTRUCTIONS (For Models with Sealed Top Burners) the 1/2" flare union adapter with an adjustable wrench before tightening the gas supply fitting and/or appliance conduit (Refer to Fig. 4e). d) Install flare union adapter to external manual shut-off valve. e) Attach appliance conduit to flare union on shut-off valve. f) Make sure service shut-off valve on pressure regulator is in the "ON" position (See Fig. 4f). g) Check for leaks. Turn the gas supply on to the range

Résumé du contenu de la page N° 6

30" GAS RANGE INSTALLATION INSTRUCTIONS (For Models with Sealed Top Burners) Grounding Instructions 5. Read these electrical connection details first The power cord of this appliance is equipped with a then connect electricity to range. 3-prong (grounding) plug which mates with a standard Before servicing, disconnect electrical 3-prong grounding wall receptacle to minimize the possibility supply at circuit breaker, fuse or power cord. of electric shock hazard from this appliance. The customer

Résumé du contenu de la page N° 7

30" GAS RANGE INSTALLATION INSTRUCTIONS (For Models with Sealed Top Burners) Test to verify if “LOW” setting should be adjusted 7. Electric Ignition Surface Burners a. Push in and turn control to LITE until burner ignites. Operation of electric igniters should be checked after range b. Push in and quickly turn knob to LOWEST POSITION. and supply line connectors have been carefully checked for c. If burner goes out, reset control to OFF. leaks and range has been connected to electric power. d. R

Résumé du contenu de la page N° 8

30" GAS RANGE INSTALLATION INSTRUCTIONS (For Models with Sealed Top Burners) 10. Air Shutter-Oven Burner 12.Make Sure Range is Level. Level the range by placing a level horizontally on an oven rack. Check diagonally from front to back, then level the range by either adjusting the leveling legs or by placing shims under the corners of the range as needed. 13. After installation is complete, make sure all controls are left in the OFF position. Care, Cleaning and Maintenance Refer to the Use & Car