Instruction d'utilisation Ultra electronic MAGICARD 300

Résumé du contenu de la page N° 1

www.ultramagicard.com


300 & Sprinter dye-film installation guide






1




To remove the dye-film carrier turn the “Dzus”

fastener ring a quarter turn counter-clockwise,

the dye film carrier can then be removed.















2
Notches




Remove the roll of dye film from its wrapper

and slide it over the bottom feed core.


Also fit an empty take up roll over the top core.





Important:-

Ensure the two locating notches are

Résumé du contenu de la page N° 2

www.ultramagicard.com 300 & Sprinter dye-film installation guide 4 It may be necessary to turn the take-up spool drive gear to ensure the two notches in the spool locate correctly with the locking pins. Manually turn the Spur Gear until the notches on the spool engage with the locking pins. 5 Turn the 'Dzus' Fastener 1/4 turn clockwise to lock in place. Lay the ring flat against the panel

Résumé du contenu de la page N° 3

www.ultramagicard.com 300 & Sprinter dye-film installation guide 7 Avoid touching the tip of the thermal printhead with your hands. Feed the leading edge of the dye film over the top of the Thermal Printhead and beneath the guide bar, stick the leading edge on the dye film to the take up spool with the white label provided. 8 Wind the dye film on a couple of turns to ensure it is centra

Résumé du contenu de la page N° 4

www.ultramagicard.com 300 & Sprinter dye-film installation guide Special Note: How to fit UR3 Continuous Resin Dye Film and UR10 Single Colour Dye Film Before fitting the continuous resin black thermal transfer film dye film or the UR10 single colour dye film a small modification must be carried out on the take-up spool spigot before operating the printer. As this dye film has no panels the optical sensors are inoperative, so for correct operation it is