Résumé du contenu de la page N° 1
SERIES II 20 amp powER CondIt IonERS
Résumé du contenu de la page N° 2
SERIES II 20 amp powER CondIt IonERS Furman Series II Features • SMP+ with extreme voltage shutdown • LiFT (Linear Filtering Technology) with zero ground contamination • Eight rear panel outlets and one front panel outlet • BNC connector on the rear panel allows you to attach any standard (12VAC 0.5 amp) gooseneck lamp to illuminate the rear of your rack • 20 amp rating, with circuit breaker • Three year limited warranty pL-pRo Series II additional Features • Two retractable, long-li
Résumé du contenu de la page N° 3
SERIES II 20 amp powER CondIt IonERS trusted over-voltage circuitry protects against I N T R O D U C T I O N all too frequent accidental connections to 208 or 240 VAC, by shutting off the incoming power Thank you for purchasing a Furman Series II until the over voltage condition is corrected. Power Conditioner, and Congratulations on [For E versions: Furman’s SMP+ clamps at 376 your choice. The Series II power conditioners VpK, (266 VAC RMS.)] feature Furman’s revolutionary Series Multi-
Résumé du contenu de la page N° 4
SERIES II 20 amp powER CondIt IonERS carefully before using. versions 100 – 120 VAC 50 Hz.) WA R N I N G 5. Route the power cord and other cables so To reduce the risk of electrical shock, do not that they are not likely to be walked on, tripped expose this equipment to rain or moisture. over, or stressed. Pay particular attention Dangerous high voltages are present inside the to the condition of the cords and cables at enclosure. Do not remove the covers. Refer the plugs, and the poin
Résumé du contenu de la page N° 5
SERIES II 20 amp powER CondIt IonERS 9. Do not attempt to service your Series II unit The PL-PRO D II features LED rack lights beyond what is described in this manual. All which produce virtually no heat and provide other servicing should be referred to qualified an extremely long life span. A dimmer control service personnel. for the rack lights allows the user to adjust the level of illumination. A rear mounted BNC ADDITIONAL F E A T U R E S jack accepts any standard (12VAC 0.5 amp)
Résumé du contenu de la page N° 6
SERIES II 20 amp powER CondIt IonERS O P E R AT I O N Furman GN-LED or GN-I). Simply slide the BNC plug over the socket and rotate clockwise Retractable Rack Lights, Rear panel Lamp until the connector snaps into the locked and dimmer Control: position. The rear rack lamp can be powered The PL-PRO II and PL-PRO D II utilize a on or off with the rear light power switch dimmer control for the two retractable front located on the far left of the front panel. panel light tubes. The di
Résumé du contenu de la page N° 7
SERIES II 20 amp powER CondIt IonERS current meter continually measures the total (1) If only the single leftmost (beneath the circuit AC load, within a typical tolerance of +/- 90V mark – 180V for E version) LED 0.5 amp. Because these meters feature true flashes, the input voltage is marginally R.M.S. technology, the current readings are accurate regardless of load conditions (capacitive, low. inductive or resistive). (2) If all of the LED’s on the voltmeter flash, the input
Résumé du contenu de la page N° 8
SERIES II 20 amp powER CondIt IonERS units, the Extreme Voltage indicator LED will light if the input voltage is above the extreme T R O U B L E S H O O T I N G G U I D E voltage cutoff, and power will not be applied 1.) Symptom: No power to the AC outlets. to the unit’s outlets. If the unit has been operating with an acceptable input voltage and possible Cause: Circuit breaker switch has subsequently that voltage exceeds 135V, it will tripped to the off position, due to excessive
Résumé du contenu de la page N° 9
SERIES II 20 amp powER CondIt IonERS be effectively reduced through use of low-pass DEFINITIONS filtering. SPIKE: This is a pulse of energy on the THREE YEAR LIMITED power line. Spikes can have voltages as WARRANTY high as 6000 volts. Though they are usually of very short duration, the energy they Furman Sound, LLC., having its principal place contain can be considerable, enough to of business at 1997 South McDowell Blvd., damage sensitive solid-state com
Résumé du contenu de la page N° 10
SERIES II 20 amp powER CondIt IonERS registration. Shipping charges to the Furman in the manner and for the period provided factory or to an authorized repair location must above. Manufacturer shall not have any other be prepaid by the Purchaser of the product. obligation with respect to the Products or Manufacturer shall, at its own expense, furnish any part thereof, whether based on contract, a replacement Product or, at Manufacturer’s tort, strict liability or otherwise. Under no opti
Résumé du contenu de la page N° 11
SERIES II 20 amp powER CondIt IonERS SpECIFICatIonS Current rating: 20 amps (“E” versions 16 amps) Operating Voltage: Make sure to pick up one of 90 to 140 VAC (“E” versions 180 to 280 VAC) Furman’s goosneck lights - Over Voltage Shutdown: 140 VAC typically (“E” versions 260 VAC typically, “J” ver- the perfect accesory for your sions 125 VAC typically) Series II unit. Voltmeter Accuracy: PL-PRO II only: ±2 VAC, calibrated with internal trimpot adjustments PL-PRO D II & PM-PRO II: ±1.5 VAC,
Résumé du contenu de la page N° 12
SERIES II 20 amp powER CondIt IonERS Furman Sound, LLC. 1997 South McDowell Blvd. Petaluma, California 94954-6919 USA Phone: 707-763-1010 Fax: 707-763-1310 Web: www.furmansound.com 111804-C E-mail: info@furmansound.com
