Instruction d'utilisation CyberData SPA-9000

Résumé du contenu de la page N° 1

Setting Up the CyberData Speakers
with Linksys SPA-9000
1.0 Setting Up the Linksys SPA-9000
To set up the Linksys SPA-9000:
1.1 Run a Cat 5 cable from a POE/Ethernet hub to the Internet port on the SPA-9000.
1.2 Run a second Cat 5 cable from a PoE/Ethernet hub to the Ethernet port on the SPA-9000.
1.3 Plug in a computer/laptop, a Linksys phone, and a CyberData speaker to the PoE/Ethernet
hub.
1.4 Adjust the IP address of the computer/laptop so that it is on the same network as the SPA-9000

Résumé du contenu de la page N° 2

Figure 1. Linksys—SIP Diagram 3.0 Setting up the Speaker for Multicast To set up the speaker for Multicast: 3.1 If you are using CyberData speakers as MGROUPS, complete step 1.1 through step 1.13. 3.2 Go to Voice => SIP and make a note of the multicast address and port number for page groups (default is 224.168.168.168, port 34567). 3.3 Go to the Speaker Setup on the webpage for the speaker and select MGROUPS and DHCP. 3.4 After the speaker reboots, get the IP address by activating the DTMF

Résumé du contenu de la page N° 3

3.9 Select page groups as the page target (see Figure 2). Figure 2. Linksys—Multicast Diagram 4.0 Setting up the Paging Server To set up the paging server: 4.1 If you are connecting the CyberData Paging Server product to CyberData speakers so that you can have more than one paging zone (Figure 3), complete step 1.1 through step 1.13. 4.2 Go to the web configuration page for the Paging Server and set it up as a SIP endpoint with the following: ● Username (extension number) ● Password (make sur

Résumé du contenu de la page N° 4

Figure 3. Linksys—Paging Server Diagram 4.3 Go to the web configuration for the speaker and select MGROUPS. 4.4 In the MGROUPS Setup page, match the multicast address and port number combination that you put in the Paging Server for the paging zone that you want for the speaker. 4.5 Dial the Paging Server's extension from the SIP phone. Note Enter a two-digit DTMF tone for the paging zone and initiate the page.