Instruction d'utilisation Air Oasis 9

Résumé du contenu de la page N° 1

Troubleshooting Guide
Problem Reason Solution
Unit does not turn on. 1. Power Cord 1. Check to make sure
power cord is plugged
in or properly connect-
ed to HVAC unit.
2. Check to make
2. AHPCO™ Cell
sure UV lamp within
AHPCO™ Cell in
plugged in completely.
3. Make sure exposed
3. Indicator Light Not
end of black fiber optic
Induct 9
Working
cord is exposed to the
UV light.
Owner’s
Manual
This Manual Includes:
• Warranty
• Safety Warnings
• Installation Instructions
• Operating Instruc

Résumé du contenu de la page N° 2

Introduction Step 3 The air you breathe is filled with thousands of particles of air pollution. Some of the pollutants like dust and lint are large enough to be visible to the naked eye, but pol- Remove three (3) wing-nuts secur- lutants such as pollen, smoke, germs, bacteria, etc., are microscopic in size. Your ing the AHPCO Cell in place. Then Air Oasis™ Induct ACT™ air purifier has been designed to destroy these invisible slide the AHPCO Cell up and out of pollutants and provide your h

Résumé du contenu de la page N° 3

Induct 9 Installation Instructions Step 1 Tear out the cutout template and trace the rectangle onto the ductwork. Step 2 Drill holes at each corner of the rectangle. trace the rectangle onto the ductwork.

Résumé du contenu de la page N° 4

If you do not have a hole saw tear this page off and cut the circle out. Then place on the ductwork in desired position and trace the rectangle. Drill holes as indicated and then use a jig saw or metal cutting snips to cut out the circle. Step 3 Insert unit into pre-cut hole. Cut Out Step 4 Drill the metal tapping screws in to hold unit in place.

Résumé du contenu de la page N° 5

Read all instructions carefully before operating Step 4 your air purifier. Plug the power cord into an electrical outlet. You may optionally have an electrician wire the air purifier to your HVAC unit so that the air purifier only Table of Contents operates when your HVAC fan is running. Once the unit is plugged in the Introduction 1 indicator light should glow to indicate the AHPCO Cell is working properly. Safety Instructions and Cautions 2 Warranty 3 Maintenance and Customer Service 4 In

Résumé du contenu de la page N° 6

Warranty Maintenance and Customer Service If you require any additional information or have problems with your Air Oasis ap- Air Oasis gives you the following limited warranty for this product only if it was origi- pliance, you may call Air Oasis customer service at: nally purchased for residential or commercial use but, not resale from Air Oasis or 1-800-936-1764 an Air Oasis Authorized Retail Dealer. Please have your serial and model numbers, found on bottom of the unit, handy Air Oasis will