Résumé du contenu de la page N° 1
® Models RCS-M2000T
RCS-M2000U
PORTABLE AIR CONDITIONER
OPERATION MANUAL
IMPORTANT NOTICE:
To avoid damage and voiding your warranty, place the unit in its upright
position for a minimum of two hours before operating.
For best results, and more enjoyment from your new FREECOM portable
air conditioning unit, please read this instruction manual
carefully and save for future reference.
0A9471 (Revised 11/97)
Résumé du contenu de la page N° 2
Résumé du contenu de la page N° 3
FEATURES Thank you for purchasing the FREECOM RCS-M2000 Portable Air Conditioner. The RCS-M2000 series Portable Air Conditioner is designed with many state-of-the art features: • Quiet, durable caster wheels allow for easy movement and instant spot cooling in any room. • Convenient, electronic operation panel enables one-touch control of all functions. • Provides clean, fresh, air conditioned, dehumidified air. • Automatic, oscillating louvers provides air distribution over a wide area . • Low-n
Résumé du contenu de la page N° 4
TRES IMPORTANT Pour éviter les risques d'incendie ou de choc électrique, n'exposez pas l'appareil à la pluie ou à l'humidité. En cas de panne, faites appel au service après-vente qualifié pour effectuer des réparations sur cet appareil. Votre climatiseur contient un réfrigérant qui passe d'une phase gazeuse à une phase liquide au moyen d'un compresseur. Il doit être utilisé en position verticale. Si pour une raison quelconque vous deviez le coucher sur le coté, ne le remettez en route que deux h
Résumé du contenu de la page N° 5
Résumé du contenu de la page N° 6
PRODUCT PARTS A B C D E G REAR VIEW H I M FRONT VIEW F E L K A. Control Panel B. Horizontal Air Louver (up and down) J C. Air Outlet D. Vertical Air Louver (left to right) E. Built-in Handle F. Air Filter G. Condensate Water Tank H. Power Cord I. Plug J. Caster Wheels K. Power Cord Wrap L. Exhaust Vent and Duct Hose Opening M. Exhaust Ducting Kit 6
Résumé du contenu de la page N° 7
THE CONTROL PANEL 6 7 1 2 4 5 3 1. POWER ON/OFF Easy push-button control switch to turn the unit ON and OFF. 2. MODE There are four different fan speed settings: • FAN—Fan only (no cooling) • HI—High fan speed with cooling setting • ME—Medium fan speed with cooling setting • LO—Low fan speed with cooling setting. 3. THERMO CONTROL The Thermo Control automatically defaults to a temperature of approximately 75ÞF when the unit is started. Adjust left button for colder air and right button for warme
Résumé du contenu de la page N° 8
Résumé du contenu de la page N° 9
Résumé du contenu de la page N° 10
Résumé du contenu de la page N° 11
Résumé du contenu de la page N° 12
MAINTENANCE AND CLEANING Emptying Condensate Water Tank When the condensate water tank is full, the “FULL TANK” indicator light will flash,the unit will sound several initial warning beeps, and the unit will automatically turn off. NOTE: If emptying water tank before “full tank” alert, press “POWER ON/OFF” button to stop unit if it is operating. 1. Unplug power cord from outlet. Allow unit to remain off for 3-5 minutes. 2. Grasp the condensate water tank handle opening and carefully pull water t
Résumé du contenu de la page N° 13
Résumé du contenu de la page N° 14
Résumé du contenu de la page N° 15
STORAGE NOTE: Optional storage cover available for model M2000T/U (Part # RRG9723-55-1). For information about ordering a storage cover, consult your Freecom Dealer. 1. Press “POWER ON/OFF” button to stop unit if it is operating. Unplug power cord from outlet. 2. Remove and empty condensate water tank. See “Emptying Condensate Water Tank” under “MAINTENANCE AND CLEANING.” 3. Remove plug from condensate tube (inside water tank compartment) and drain water. Replace plug tightly onto end of tube.
Résumé du contenu de la page N° 16
TROUBLESHOOTING Before contacting a dealer or qualified service technician, please read and check the following: PROBLEM SOLUTION Unit does not turn on. 1. Make sure city power supply is normal. 2. Check plug is correctly installed into outlet. 3. Check fuses and household breaker switches. 4. Remove electrical plug from outlet. Check electri- cal cord and plug for damage. 5. Check to be sure water tank is installed properly into unit. 6. Check that plug is secure and in place on con- densate tu
