Résumé du contenu de la page N° 1
NO POSTAGE
NECESSARY
IF MAILED
IN THE
UNITED STATES
BUSINESS REPLY MAIL
FIRST-CLASS MAIL PERMIT NO. 8390 LONG BEACH, CA
DENSO SALES CALIFORNIA, INC.
3900 VIA ORO AVENUE
LONG BEACH CA 90810-9969
OPERATION MANUAL
CLASSIC PLUS 14 and CLASSIC PLUS 26
READ THIS MANUAL CAREFULLY FOR INSTRUCTIONS ON CORRECT
DENSO SALES CALIFORNIA, INC.
INSTALLATION AND USAGE, AND READ ALL SAFEGUARDS.
3900 Via Oro Avenue ~
‘
SECCION EN ESPANOL
Long Beach CA 90810-1868
SECTION EN
Résumé du contenu de la page N° 2
LIMITED WARRANTY DENSO SALES CALIFORNIA, INC. ("DENSO") warrants its MOVINCOOL Products only to the extent stated in its official written warranties. Unless otherwise specifically provided in writing by DENSO, DENSO warrants to end- user that the Products shall be free of defects in materials or workmanship and will function in accordance with DENSO's published specifications under ordinary in- tended use and service for a period of twelve (12) months after delivery to the end- user; provided, h
Résumé du contenu de la page N° 3
OPERATION MANUAL CLASSIC PLUS 14 and CLASSIC PLUS 26
Résumé du contenu de la page N° 4
ii
Résumé du contenu de la page N° 5
TABLE OF CONTENTS FOREWORD ............................................................................................ 1 Definition of Terms .......................................................................... 1 GENERAL WARNINGS & CAUTIONS .................................................... 2 INVENTORY & ASSEMBLY .................................................................... 3 Inventory........................................................................................... 3 Ass
Résumé du contenu de la page N° 6
iv
Résumé du contenu de la page N° 7
FOREWORD Congratulations on purchasing the MovinCool portable air conditioner. This manual explains how to assemble, install, operate, and maintain the MovinCool Classic Plus 14 and Classic Plus 26 portable air condi- tioning units. Please read this operation manual thoroughly to familiar- ize yourself with the features of the unit and to ensure years of reliable operation. You may also find it useful to keep this operation manual on hand for reference. Components and/or procedures are subject t
Résumé du contenu de la page N° 8
GENERAL WARNINGS & CAUTIONS • All electrical work, if necessary, should only be performed by qualified electrical personnel. Repair to electrical components by non-certified technicians may result in personal injury and/or damage to the unit. All electrical components replaced must be genuine MovinCool parts, purchased from an authorized reseller. • The proper electrical outlet for MovinCool units must be equipped with a UL approved ground-fault breaker to prevent electrical shock from the unit.
Résumé du contenu de la page N° 9
INVENTORY & ASSEMBLY Inventory After unpacking your MovinCool unit, please check to make sure you have the following items: ❏ Classic Plus 14 or Classic Plus 26 MovinCool Unit (1) ❏ Cool Air Outlet Ducts (2) ❏ Screws (8) ❏ Operation Manual/Warranty Card (1) NOTE: If any of these items were not included in the box or appear damaged, please contact your MovinCool reseller for replacement. COOL AIR OUTLET DUCTS SCREWS MOVINCOOL UNIT OPERATION MANUAL/ WARRANTY CARD 3
Résumé du contenu de la page N° 10
INVENTORY & ASSEMBLY Assembly CAUTION: Before assembling make sure the unit is on a flat, level surface and the casters are in the LOCKED position. (Both the Classic UNLOCKED Plus 14 and Classic Plus 26 MovinCool units have locking swivel LOCKED casters in the front only.) Install each cool air outlet duct using 4 screws each as shown. NOTE: Do not overtighten the screws when installing the cool air outlet ducts. This could damage the base on the cool air outlet duct assembly. COOL AIR OUTLET D
Résumé du contenu de la page N° 11
INSTALLATION Choosing and Installation Site CAUTION: Following are some precautions to consider before choosing your installation site. Please review carefully as improper installation may result in personal injury or damage to the unit. • Do not use the unit in areas where leakage of flammable gas may occur. • Do not use the unit in areas where it will be exposed to rain or water. • Do not use the unit in an atmosphere of excessively corrosive gas or vapor. • Do not use in areas where the temp
Résumé du contenu de la page N° 12
INSTALLATION (cont.) Moving the Unit Unlock the casters and push the MovinCool unit from the front panel edge to a flat, level surface and set the casters back to the LOCKED position. FRONT PANEL EDGE UNLOCKED LOCKED 6
Résumé du contenu de la page N° 13
INSTALLATION (cont.) Plugging in the Unit • Check the prongs and surface of the power cord plug for dust/dirt. If dust and/or dirt are present, wipe off with a clean, dry cloth. • Check the power cord, plug and prongs for damage or excess play. If any damage or excess play is found, contact your MovinCool reseller for repair. • For the Classic Plus 26 model, fully insert plug into the A/C outlet and rotate clockwise until it locks in place. WARNING: • If the power cord or plug is damaged, repai
Résumé du contenu de la page N° 14
FEATURES Both models feature: • An electronic control panel which allows the user to control the unit’s operation easily. • Dual fan speeds (either High or Low) in both COOL and Fan Only modes. •A digital display that indicates the temperature SET POINT (either Fahrenheit or Celsius) in which the COOL Mode will operate. This is also the local temperature the unit will try to maintain. The Temperature Set Point can be adjusted by the SET TEMP buttons (▼/▲). •A condensate drain TANK FULL indicat
Résumé du contenu de la page N° 15
OPERATION Control Panel Before operating the unit, it is important to familiarize yourself with the basic controls located on the control panel. SET TEMP FAN ON/OFF COOL ON/OFF Classic Plus ➀ COOL ON/OFF Activates/deactivates the COOL mode/ Button turns the unit off. ➁ FAN ON/OFF Activates/deactivates the HIGH or LOW Buttons fan mode. ➂ SET TEMP Increases/decreases the temperature Buttons (▼/▲) set point. ➃ TANK FULL LED Flashes when the drain tank is full. ➄ SET POINT Indicates the current temp
Résumé du contenu de la page N° 16
OPERATION (cont.) Operating in COOL Mode The unit can be operated in COOL mode by pressing the COOL ON/OFF button (LED illuminates). NOTE: In COOL mode the unit can only be turned off by pressing the COOL ON/OFF button again, not by pressing the fan buttons. ➀ Change the fan speed by pressing the HIGH or LOW fan buttons. ➁ Change the temperature set point by pressing the SET TEMP buttons (▼/▲). NOTE: When turning the unit on, the temperature set point and fan speed are determined by the last ope
Résumé du contenu de la page N° 17
OPERATION (cont.) Operating Modes Both Classic Plus models operate in 2 modes, FAN Only and COOL. When in FAN Only mode the unit circulates the surrounding air. When in COOL mode, the compressor is engaged and cool air is circulated. ■ COOL Mode Both models will operate in FAN Only mode for approximately 120 seconds before the compressor engages (compressor time delay program is 120 + 10 seconds). ■ Temperature Control The room temperature thermistor allows the unit to switch auto- matically bet
Résumé du contenu de la page N° 18
OPERATION (cont.) Emptying the Drain Tank During COOL mode, condensate will accumulate in the drain tank. When the drain tank becomes full, the FULL TANK LED will flash and the unit will shut off automatically. NOTE: If you want to empty the drain tank, while the unit is in operation, press the COOL ON/OFF button to turn the unit off. ➀ Pull the drain tank from the unit. ➁ Remove the cap and empty the CAP drain tank. ➂ Replace the cap and return the drain tank to the unit. ➃ Press the COOL ON/OF
Résumé du contenu de la page N° 19
OPERATION (cont.) DRAIN PUMP KIT (Optional) (Classic Plus 14 model ONLY) A drain pump kit (CPK-3) is available to allow continuous operation and to eliminate the need for a drain tank. • When the water collects to level (A) in the pump reservoir, the drain pump begins to operate A and discharge the water. B NOTE: The compressor will not operate while the drain pump is discharging water. • When the water level drops below level (B), the drain pump stops, and the compressor will restart. NOTE: If
Résumé du contenu de la page N° 20
OPERATION (cont.) DRAIN PUMP KIT (Optional) (Classic Plus 26 model ONLY) A drain pump kit (CPK-4) is available to allow continuous operation and to eliminate the need for a drain tank. • When the water collects to level (A) in the pump reservoir, the drain pump begins to operate A and discharge the water. B • When the water level drops below level (B), the drain pump stops, and the compressor will restart. NOTE: If for any reason the water level exceeds that of level (A) in the pump reservoir, a
