Résumé du contenu de la page N° 1
DIM-404
DIGITAL VIDEO CAMCORDER
ENGLISH
E
Instruction Manual
CANON INC.
CAMESCOPE ET LECTEUR VIDEO NUMERIQUES
FRANÇAIS
U.S.A. CANON U.S.A., INC. NEW JERSEY OFFICE
100 Jamesburg Road, Jamesburg, NJ 08831 USA
F
Mode d’emploi
CANON U.S.A., INC. CHICAGO OFFICE
100 Park Blvd., Itasca, IL 60143 USA
CANON U.S.A., INC. LOS ANGELES OFFICE
VIDEOCAMARA Y GRABADORA DIGITAL
ESPAÑOL
15955 Alton Parkway, Irvine, CA 92618 USA
Es
CANON U.S.A., INC. HONOLULU OFFICE Manual de Instrucciones
210 Ward Avenue, Suite 2
Résumé du contenu de la page N° 2
Important Usage Instructions WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE E THIS PRODUCT TO RAIN OR MOISTURE. WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK AND TO REDUCE ANNOYING INTERFERENCE, USE THE RECOMMENDED ACCESSORIES ONLY. COPYRIGHT WARNING: Unauthorized recording of copyrighted materials may infringe on the rights of copyright owners and be contrary to copyright laws. Digital Video Camcorder, ELURA10/ELURA20 MC systems This device complies with Part 15 of the FCC
Résumé du contenu de la page N° 3
Introduction IMPORTANT SAFETY INSTRUCTIONS In these safety instructions the word 10. Power Sources — The CA-400 Compact “product” refers to the Canon Digital Video Power Adapter should be operated only E Camcorder ELURA10A/ELURA20 MC A and from the type of power source indicated all its accessories. on the marking label. If you are not sure of the type of power supply to your 1. Read Instructions — All the safety and home, consult your product dealer or operating instructions should be read loca
Résumé du contenu de la page N° 4
18. Damage Requiring Service — EXAMPLE OF ANTENNA GROUNDING AS PER NATIONAL ELECTRICAL CODE Fig. 1 Disconnect this product from the wall E outlet and all power sources including ANTENNA LEAD IN WIRE battery, and refer servicing to qualified GROUND service personnel under the following CLAMP conditions: ANTENNA DISCHARGE a. When the power-supply cord or plug is UNIT (NEC SECTION 810-20) damaged. ELECTRIC SERVICE EQUIPMENT GROUNDING CONDUCTORS b. If any liquid has been spilled onto, or (NEC
Résumé du contenu de la page N° 5
Introduction Contents ~ For Playback ...~ Introduction Displaying Date, Time and Camera Data E (Data Code) ........................................75 Important Usage Instructions ....................2 Searching the Tape (Photo Search/ IMPORTANT SAFETY Date Search)........................................78 INSTRUCTIONS ..................................3 Returning to a Pre-Marked Position ........79 Thank you for Choosing a Canon ..............6 Introducing the ELURA10/ELURA20 MC................
Résumé du contenu de la page N° 6
Thank you for Choosing a Canon First, we’d like to thank you for Your camcorder is supplied with the purchasing this Canon camcorder. Its following accessories: E advanced technology makes it very Wireless Controller Two AA batteries easy to use — you will soon be making ELURA10: WL-D76 high-quality videos which will give you ELURA20 MC: WL-D75 pleasure for years to come. To get the most out of your new camcorder, we recommend that you read this manual thoroughly — there Lens cap and lens cap BP
Résumé du contenu de la page N° 7
Introduction Introducing the ELURA10/ELURA20 MC IEEE 1394 DV Terminal 10× Lens and 40× Digital E Zoom Using a DV cable, connect the ELURA10/ELURA20 From wide-angle to 10× MC to a PC equipped with telephoto—with a DV terminal and transfer unparalleled optical your original images to quality. The digital zoom your PC. magnifies this up to 40× for even more dramatic Extended Recording Time Function results. Record for 1.5×, 2× or 3× longer than when in SP mode – up to 4 hours on an Still Photos 80
Résumé du contenu de la page N° 8
Finding Your Way Around the ELURA10/ELURA20 MC E Record review button (p. 52)/ (Play/Pause) button (p. 25)/ – REC (record) SEARCH button MIX/SLIDE SHOW button (p. 52)/ (rewind) button (p. 25)/ (ELURA20 MC only) (p. 103) – CARD button (ELURA20 MC only) D.EFFECTS ON/OFF button (p. 102) (p. 61) INDEX SCREEN MIX/SLIDE SHOW ON/ (stop) button (p. 25)/ OFF REC PAUSE INDEX SCREEN button CARD D.EFFECTS (ELURA20 MC only) (p. 103) (LINE-IN) + REC (record) SEARCH button Self-timer b
Résumé du contenu de la page N° 9
Mastering the Basics CARD REC P.SCAN P.SCAN MOVIE MOVIE POWER OFF OFF POWER E Viewfinder focusing lever (p. 121) Finder release button (p. 126) Stereo microphone (p. 88) PHOTO button (p. 50, 98) Zoom control (p. 21) Viewfinder (p. 121, 126) Speaker (p. 28) POWER dial (p. 16, 35) ELURA10 ELURA20 MC Program selector (p. 53) Program AE (p. 53) Easy Recording P (p. 53) Grip belt (p. 121) SELECT dial (p. 28, 35) POWER dial lock lever (p. 20) POWER indicator (p. 16) ELURA10 : VCR, OFF, MOVIE : VCR
Résumé du contenu de la page N° 10
E Memory card compartment cover (ELURA20 MC only) (p. 95) Tally lamp (p. 45) Remote sensor (p. 43) Tripod/docking unit socket (p. 29, 32) Docking unit attachment terminal (p. 29) PHOTO button (p. 50, 98) Transmitter START/STOP button (p. 17) Zoom buttons (p. 21) MENU button (p. 36) Controller buttons (p. 36) START ZOOM /STOP PHOTOWT SELF TIMER button (p. 67) SET button (p. 36) SELF TIMER MENU D. EFFECTS ON/OFF button (p. 61) TV SCREEN button (p. 137) TV SCREEN SET DATA MIX BALANCE buttons (p.
Résumé du contenu de la page N° 11
Mastering the Basics Powering Your Camcorder Before operating your camera, you will need to use the power adapter to: E Provide power from an AC outlet or Charge a battery pack • The power adapter converts current from a household power socket (100–240 V AC, 50/60 Hz) to the DC current used by your camera. • If the adapter is used next to a TV, it may cause bars to appear on the TV — move the adapter away from the TV or the antenna cable. Connecting the camera to an AC outlet 3 1 4 2 Use the p
Résumé du contenu de la page N° 12
P.SCAN MOVIE Charging and attaching the battery packs E 2 POWER OFF B B A A 1 1 Charge indicators 4 3 Your battery pack was partially charged before it left the factory. It should have enough power for you to check that your camera is working properly. However, you must charge the battery pack fully if you want it to power the camera for more than a few minutes. The power adapter supplied with your camcorder can hold two battery packs and is capable of charging them one after another. Additional
Résumé du contenu de la page N° 13
Mastering the Basics E • The adapter can charge a single battery pack from either side, A or B. If you attach two battery packs, charging begins from the battery you first attach to the adapter, or, if the batteries are already attached to the adapter when you plug it into an AC outlet, from the side labeled “A”. • When powering your camcorder from an AC outlet, you do not need to remove battery packs attached to the adapter, but charging will not take place until you remove the DC coupler from
Résumé du contenu de la page N° 14
PUSH Loading a Cassette OPEN / EJECT OPEN / EJECT E Only use videocassettes marked with the D logo.* Loading and unloading 1. Make sure that you have attached a power source. 2. Slide the OPEN / EJECT 5 switch upwards to release the cassette compartment cover. • Pull the cover fully open (while holding the button upwards) and wait a couple of seconds for the cassette compartment to open automatically. • The confirmation beep sounds when the cassette cover fully opens. 3. Load or unload the casse
Résumé du contenu de la page N° 15
Mastering the Basics Protecting tapes from accidental erasure E REC SAVE REC SAVE To protect your recording from accidental erasure, slide the tab on the cassette so that it exposes the hole. (This switch position is usually labeled SAVE or ERASE OFF.) If you load this cassette and put the camera in record pause mode ( 16), “THE TAPE IS SET FOR ERASURE PREVENTION” is displayed for approx. 4 seconds and then the v mark flashes in the display. The camera also shows the above phrase if you accident
Résumé du contenu de la page N° 16
P.SCAN Basic Recording E 3 1 P MOVIE 4, 5 Before you start recording Have you completed the following steps? • Attached a power source ( 11). • Removed the lens cap ( 121). • Chosen the display: viewfinder ( 121) or LCD screen ( 22) • Extended the viewfinder ( 121) /adjusted the LCD screen ( 22) • When you’re using the viewfinder, fully close the LCD or rotate the LCD so that it faces the same direction as the lens ( 24). You may also want to install the backup battery ( 124) in order to set the
Résumé du contenu de la page N° 17
Mastering the Basics 3. Slide the program selector to [. • This selects the camera’s Easy Recording program. It allows you to simply E point and shoot without making any manual adjustments ( 55). 4. Press and release the start/stop button once to begin recording. • For still image recording to a cassette, see p. 50. 5. Press and release the start/stop button again to pause recording. • The camera returns to record pause mode and PAUSE reappears in the display. • You can stop and restart recordi
Résumé du contenu de la page N° 18
Changing the recording mode E Choose from 4 recording modes: SP (standard play), 1.5× SP, 2× SP or 3× SP. • Only SP and LP modes are available when the camcorder is set to CARD PLAY mode. Recording times (this example uses an 80-minute tape) Standard recording Extended recording SP LP SP LP 1.5× SP 2× SP 3× SP 80 min. (120 min.) (160 min.) (240 min.) In SP and LP modes, image data is compressed twice as much as in SP and LP modes when being recorded to a tape. You can’t add sound (audio dubbing)
Résumé du contenu de la page N° 19
Mastering the Basics About SPand LPmodes E • The image quality of recordings done in SP or LP modes will be lower than that of those done in SP or LP modes. • A cassette recorded in SP or LP mode cannot be played back on a camcorder not equipped with that mode. • The recording mode might not appear in the display correctly if you switch to SP or LP while the camcorder is connected to another digital video device. • When the recording mode is changed to SP or LP, the camcorder modifies the image
Résumé du contenu de la page N° 20
Confirmation/Warning beeps E The camera’s short operation confirmation beeps are indicated by ` in the illustrations. Beeps sound upon certain camera operations such as when you turn the camera on, during the self-timer countdown, right before the camera’s automatic shut-off, and also upon any unusual condition of the camera. Beeps are not recorded on the tape. CARD CARD MOVIE P.SCAN VCR REC PLAY SYSTEM BEEP••••••••ON ( 35) To turn the beep off, open the menu and select SYSTEM. Then select BE
