Instruction d'utilisation Hans Grohe Retroaktiv 06397XX0

Résumé du contenu de la page N° 1

Installation Instructions / Warranty
Retroaktiv
06127XX0
Retroaktiv
06126XX0
Retroaktiv
06397XX0

Résumé du contenu de la page N° 2

Retroaktiv Showerheads and Handshower Spray modes: full spray 3 Turbo massage Flow rate 2.5 gpm 06126XX0 Spray modes: full spray 3 Turbo massage Flow rate 2.5 gpm 06127XX0 Spray modes: full spray Flow rate 2.5 gpm 06397XX0 2

Résumé du contenu de la page N° 3

Showerhead Installation Remove the old showerhead: While holding the shower arm, remove the exist- ing showerhead by turning counter-clockwise with a wrench. Clean the threads on the shower arm with a wire brush. Install the new showerhead: Slide the boot onto the shower arm. Push it out of the way. Screw the showerhead onto the arm by hand. Finish tightening with a wrench, if desired. Turn on the water and check for leaks. Pull the boot down over the joint. Note: Retroaktiv 06397XX0 does

Résumé du contenu de la page N° 4

If the flow of water becomes noticeably less, remove and clean the screen washer. User Instructions Change the spray mode - models 06126XX0 and 06127XX0 only Push the selector lever until the indicator mark is next to the name of the desired spray function. There are 3 two spray modes: full spray and Turbo massage. full spray channels with TM Rubit! 3 Turbo massage channels selector lever Scale Removal TM Rubit Self Cleaning System TM The Retroaktiv showerheads and handshower use TM the Ru

Résumé du contenu de la page N° 5

If scale deposits are noticed on the spray face, pour about 3/” of a commercial scale remover, such as TM TM Lime-Away or CLR ,into a shallow dish. Dilute the remover according to the label instructions. Soak only the spray face in the solution for the amount of time specified on the label. Rinse the showerhead/handshower with clear water. Reinstall the showerhead/handshower. Turn on the water and allow it to flush for at least one minute. 5

Résumé du contenu de la page N° 6

Cleaning Recommendation for Hansgrohe Products Modern faucetry and shower products utilize a combination of materials to comply with the needs of the market with regard to design and functionality. To avoid damage, it is necessary to use some caution when cleaning. Damage caused by improper treatment is not covered under the Hansgrohe warranty. Cleaning Materials for Faucets and Showers • To remove lime scale, use only products made specifically for that purpose. Always follow the manufacture

Résumé du contenu de la page N° 7

THIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR: A. Conditions, malfunctions or damage not resulting from defects in material or workmanship. B. Conditions, malfunctions or damage resulting from (1) improper installation, improper maintenance, misuse, abuse, negligence, accident or alteration, or (2) the use of abrasive or caustic cleaning agents or “no rinse” cleaning products, or the use of the product in any manner contrary to the product instructions. C. Labor or other expense

Résumé du contenu de la page N° 8

  Hansgrohe, Inc. • 190 Bluegrass Lakes Parkway • Alpharetta, GA 3000 Tel. 770 360-9880 • Fax 770 360 9887 www.hansgrohe-USA.com US - Installation Instructions • Part No. 9096501-03 • Revised 0/2007