Résumé du contenu de la page N° 1
Installation Instructions / Warranty
Solaris² E Allegro² E Metro² E
04170XX0 04183XX0 04196XX0
Allegro² E
Solaris² E Metro² E
04184XX0
04171XX0 04197XX0
Résumé du contenu de la page N° 2
Trim, 3- and 4-Hole Roman Tub Sets Solaris² E 04171XX0 Allegro² E 04184XX0 Metro² E 04197XX0
Résumé du contenu de la page N° 3
Solaris² E 04170XX0 Allegro² E 04183XX0 Metro² E 04196XX0 Installation Considerations • The 4-Hole Roman Tub Set trim kits require rough 06646000. The 3-Hole trim kits require rough 06607000. The roughs are not included. • The rough must be installed and the mounting surface complete and made watertight before installation of this trim kit. • The elbow for the handshower incorporates a check valve to prevent back siphonage. This check valve should be removed and inspected yearly. • The flo
Résumé du contenu de la page N° 4
Installation - 3-Hole Trim Kits If you are using a 4-Hole set, please turn to page 6 Install the Handles Remove the plaster shields from the hot and cold valves and the spout tee. Install the handle escutcheons. Install the white plastic snap connectors and the screws. Push the handle down firmly over the snap connectors. Install the Spout Remove the brass plug from the tee. 4
Résumé du contenu de la page N° 5
Push the spout sealing ring firmly into the spout tee. Install the spout escutcheon. Press the spout over the spout tee. Install and tighten the screw with a 3 mm Allen wrench. CAUTION: do not overtighten the screw or the o- rings on the diverter will deform, which will cause a leak. Turn on the water and check all connections for leaks. 5
Résumé du contenu de la page N° 6
Installation - 4-Hole Trim Kits Install the Handles Remove the plaster shields from the hot and cold valves and the spout tee. Install the escutcheons. Install the white plastic snap connectors and screws. Push the handle down firmly over the snap connector. Install the Diverter and Spout Remove the brass plug from the tee. 6
Résumé du contenu de la page N° 7
Install the pin on the diverter. Press the diverter firmly into the spout tee until it is fully seated. Turn the pin so that the hole faces the rear of the spout. Install the spout escutcheon. Firmly press the spout over the tee and diverter. Tighten the screw with the included 3 mm Allen wrench. CAUTION: do not overtighten the screw or the o- rings on the diverter will deform, which will cause a leak. Install the pull rod. The threaded end of the pull rod must go into the hole in the
Résumé du contenu de la page N° 8
Install the Handshower (4-hole models only) Install the check valve in the elbow, with the arrow pointing in the direction of the water flow. Remove the plaster shield from the handshower holder. Pull out on the handshower hose. Install the handshower holder escutcheon. Install the elbow. Place the screen washer in the elbow. Install the handshower and guide it into the holder. 8
Résumé du contenu de la page N° 9
Handshower User Instructions To change spray modes, push the selector lever until the desired spray is achieved. Rain AIR selector lever Balance AIR Whirl AIR Scale Removal The Raindance E 100 Air 3-jet handshower incor- porates the Quick Clean™ cleaning system. If scale deposits are noticed in the spray channels, turn the water on lightly and rub the spray channels with a finger or a sponge. 9
Résumé du contenu de la page N° 10
If scale deposits are noticed on the spray face, pour about 3/4” of a commercial scale remover, such as Lime-Away™ or CLR™ ,into a shallow dish. Dilute the remover according to the label instructions. Soak only the spray face in the solution for the amount of time specified on the label. Rinse the handshower with clear water. Reinstall the handshower. Turn on the water and al- low the handshower to flush for at least one minute. 10
Résumé du contenu de la page N° 11
Replacement Parts 6 1 1 7 11 10 8 9 4 5 1 1 4 3 1 aerator 13956XX0 spout escutcheon 97779XX0 3 sealing ring 8851000 4 snap connector 94184000 5 diverter 96775000 6 diverter knob 98707XX0 7 handshower 850 XX1 8 check valve 94074000 9 handshower escutcheon 97159XX0 10 elbow 8071XX0 11 screen washer 9446000 1 screw 97660000 11
Résumé du contenu de la page N° 12
Cleaning Recommendation for Hansgrohe Products Modern lavatory faucets, kitchen faucets, and showers consist of very different materials to comply with the needs of the market with regard to design and functionality. To avoid damage and returns, it is necessary to consider certain criteria when cleaning. Cleaning Materials for Faucets and Showers Acids are a necessary ingredient of cleaning materials for removing lime, however please pay attention to the follow- ing points when cleaning fauce
Résumé du contenu de la page N° 13
Limited Lifetime Consumer Warranty This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”). This warranty is limited to Hansgrohe products which are purchased by a consumer in the United States after March 1, 1996, and installed in either the United States or Canada. WHO IS COVERED BY THE WARRANTY This warranty extends to the original consumer purchaser only. This warranty is non-transferable. WHAT IS COVERED BY THE WARRANTY This warran
Résumé du contenu de la page N° 14
THIS PRODUCT. HANSGROHE SHALL NOT BE LIABLE TO PURCHASER OR ANY PERSON FOR ANY INCIDENTAL, SPECIAL, OR CONSEQUENTIAL DAMAGES, ARISING OUT OF BREACH OF THIS WARRANTY OR ANY IMPLIED WARRANTY (INCLUDING MERCHANTABILITY). Some States do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may have other rights which vary from State to State. You may be requir
Résumé du contenu de la page N° 15
15
Résumé du contenu de la page N° 16
Hansgrohe, Inc. • 1490 Bluegrass Lakes Parkway • Alpharetta, GA 30004 Tel. 770-360-9880 • Fax 770-360-9887 www.hansgrohe-usa.com US - Installation Instructions • Part No. 9046601 • Revised 03/008
