Instruction d'utilisation Apple Processor

Résumé du contenu de la page N° 1

Xserve
Processor
Replacement Instructions
Follow the instructions in this sheet carefully. Failure to follow these instructions could
damage your equipment and void its warranty.
Note: Online instructions covering customer-installable parts are available at
http://www.info.apple.com/installparts/.
Tools Required
The only tool required for this procedure is a Phillips screwdriver.
Opening the Server
The server slides open from the front of the rack. The top cover remains in pl

Résumé du contenu de la page N° 2

4. If the server is in the locked position (the yellow security LED on the front panel is on), use the Allen key that came with the server to unlock it. 5. If the cable management arm is not in use, unplug all external cables except the power cord. 6. Touch the server’s metal case to discharge any static electricity. Important: Always ground yourself by touching the server’s case before you touch any parts or install any components inside the server. To avoid static electricity bu

Résumé du contenu de la page N° 3

9. Grasp the thumbscrews and slide the bottom housing forward part way to expose the two chassis levers. (Figure 2) 10. While depressing both levers, pull the bottom housing all the way forward and remove it from the rack. Figure 2 11. Place the bottom housing on a sturdy, flat surface and ESD mat. 12. Put on the ESD wrist strap. Xserve Processor - 3

Résumé du contenu de la page N° 4

Removing the Installed Processor 1. Release the latch on the heatsink duct (Figure 3), and remove the duct from the server. Figure 3 2. Release the three captive screws that secure the heatsink. (Figure 4) 3. Lift the heatsink straight up and remove it from the server. Figure 4 Xserve Processor - 4

Résumé du contenu de la page N° 5

4. Lift the processor straight up to disconnect it from the logic board and remove the processor from the server. (Figure 5) Figure 5 Installing the Replacement Processor 1. Position the replacement processor over its logic board connector and press down, being careful not to touch any chips on the board or processor. 2. Using the alcohol pad included with the replacement processor, clean off any used thermal grease from the MPU (Figure 6) and the bottom of the heatsink. Figure 6 Xs

Résumé du contenu de la page N° 6

3. Using the thermal grease included with the replacement processor, apply one dot of fresh grease to the middle of the MPU (or both MPUs if the server is a dual processor). WARNING: Before reinstalling the heatsink, you must be sure to apply thermal grease to the MPU. ­ 4. Spread the grease evenly across the MPU(s) to a thickness of approximately 1 mm. 5. Carefully align the posts on the heatsink with the holes in the processor card, and lower the heatsink straight down onto the

Résumé du contenu de la page N° 7

Closing the Server 1. Carefully slide the bottom housing back into the rack. 2. Tighten the front thumb screws to secure it. Warning: Never turn on the server unless all of its internal and external parts are in place and it is closed. Operating the server when it is open or missing parts can damage it or cause injury. Apple Computer, Inc. © 2002 Apple Computer, Inc. All rights reserved. This document is protected under U.S. Copyright Law and International Treaties, and no part of