Instruction d'utilisation TRENDnet Wireless Access Point

Résumé du contenu de la page N° 1

Quick Installation Guide
TEW-450APB

Résumé du contenu de la page N° 2

Table of Contents Table of Contents English ...................................................................................................... 1 1. Before You Start ................................................................................. 1 2. Install Hardware ................................................................................. 2 3. Configure the Access Point ................................................................ 3 Troubleshooting ......................

Résumé du contenu de la page N° 3

1. Before You Start Package Content TEW-450APB Quick Installation Guide External Power Adapter User’s Guide CD-ROM 1 x 2dBi Detachable Antenna Installation Requirements A web browser such as Internet Explorer (5.5 or higher) or Netscape Navigator (4.7 or higher). A computer with a network adapter properly installed. A network Switch or Hub with an available network LAN port. A RJ-45 network cable. Application 108Mbps 802.11g Wireless Access Point (TEW-450APB) Notebook with 108Mbps Workstat

Résumé du contenu de la page N° 4

2. Install Hardware Note: Locate an optimum location for the Access Point. The best place for the Access Point is usually at the center of your wireless network. Please connect the computer configuring the TEW-450APB to the same switch/hub. 1. Connect a RJ-45 cable from the Switch/Hub to the LAN port of the Access Point and then connect the 2dBi Detachable Antenna. 2. Connect the AC Power Adapter to the Access Point and then to a

Résumé du contenu de la page N° 5

3. Configure the Access Point Note: It is recommended that you configure the Access Point from a wired computer. Before the Access Point can be configured, a Static IP address must be assigned ton your computer's network adapter in the subnet of 192.168.1.x. Since the Access Point's default IP address is 192.168.1.100, make sure no other network devices are assigned an IP address of 192.168.1.100. (Refer to the Troubleshooting section on how to configure TCP/IP settings on your PC) Fo

Résumé du contenu de la page N° 6

4. Click Next. 5. Enter a new password for your Access Point, verify the new password, and then click Next. (If a new password is not entered, the default password admin will be used. 6. Enter a SSID for your Access Point and then click Next. 4 English

Résumé du contenu de la page N° 7

7. Enable Encryption if needed and then click Next. 8. Click Restart. 9. Click Close. Your installation is now complete. For detailed information regarding the TEW-450APB's configuration and advanced settings, please refer to the Troubleshooting section, User's Guide CD-ROM, or Trendnet's website at http://www.trendnet.com. 5 English

Résumé du contenu de la page N° 8

Troubleshooting Q1: How do I configure TCP/IP settings on my computer? 1. Go into the Control Panel and double- click the Network Connections icon, right-click the Local Area Connection icon and then click Properties. 2. Click Internet Protocol (TCP/IP) and then click Properties. Then click on Use the following IP address, and make sure you assign your network adapter an IP address in the subnet of 192.168.1.x. Q2: I specified the IP address http://192.168.1.100 in my Internet Brow

Résumé du contenu de la page N° 9

Q4: After I successfully configured the Access Point to meet my network settings, I can not connect to my network using wireless computers. A4: If you have a DHCP server in your network, you need to go into TCP/IP settings again and re-select "Obtain an IP address automatically" to allow the PC to regain an IP address from your DHCP server. Q5: All the settings are correct, but I can not make a wireless connection to the Access Point. A5: First, double check that the WLAN light on the Access

Résumé du contenu de la page N° 10

Certifications This equipment has been tested and found to comply with FCC and CE Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received. Including interference that may cause undesired operation. Este equipamento opera em caráter secundário, isto é, não tem direito a proteção contra interferência prejudicial, mesmo de estações do mesmo tipo, e não pode causar interferência a sis

Résumé du contenu de la page N° 11

TRENDnet Technical Support . US Canada Toll Free Telephone: 1(866) 845-3673 24/7 Tech Support . . . . . Europe (Germany France Italy Spain Switzerland UK) Toll Free Telephone: +00800 60 76 76 67 English/Espanol - 24/7 Francais/Deutsch - 11am-8pm, Monday - Friday MET Worldwide Telephone: +(31) (0) 20 504 05 35 English/Espanol - 24/7 Francais/Deutsch - 11am-8pm, Monday - Friday MET Product Warranty Registration Please take a moment to register your product online. Go to TRENDn