Instruction d'utilisation Belkin A F5D7633

Résumé du contenu de la page N° 1

Technical Support Information
How To Enable Wireless Bridging Between A F5D7633 And A F5D7130 |
Connect the Access Point to an available Ethernet Socket on the Router. Open you Internet Browser and then
type ‘192.168.2.254’ into the address bar. The Access Point Configuration Utility will then be displayed.
Select the heading ‘Channel and SSID’ (located under ‘Wireless’) from the menu on the left hand side of your
Browser. If you are prompted to log in click ‘Submit’. If you have entered a Pas

Résumé du contenu de la page N° 2

Technical Support Information Select the heading ‘Security’ (located on the left menu bar). If you have enabled Wireless Security in the F5D7633 please ensure that these settings are duplicated in the F5D7130. Once complete click ‘Apply changes’. Once the changes have applied click ‘Logout’ (located in top right hand side of the Belkin Utility). Enter ‘192.168.2.1’ in to the Address Bar of your Browser. The Router Configuration page will now be displayed. Select the heading ‘Channel and SSID’

Résumé du contenu de la page N° 3

Technical Support Information Remove the power from the F5D7130, disconnect the Ethernet Cable and then re-apply the power back to the F5D7130. Once complete please wait until all the lights on the F5D7130 have stabilised. Select the heading ‘Wireless Bridge’ (Located under ‘Wireless’) from the menu on the left hand side of your Browser. Set the ‘Bridge Mode’ to ‘Auto’ (If this already enabled select disable, click ‘Apply Changes’ and then select ‘Auto’ again). The F5D7130 will now be display