Résumé du contenu de la page N° 1
CSMIM-T1
SN
MODEM 1-8 17-24 STAT S/U
9-16 ATTN TRAF
CONFIG
STATUS
CD TX RX A B C
1
2
3
4
SET UP
5
6
7
8
9
10
CONSOLE
MODEM 11
PORT
12
STATUS
13
14
15
16
CSMIM-T1 HARDWARE
17
18
19
INSTALLATION GUIDE 20
21
22
23
24
TEST LOS
SYNC
NETWORK
STATUS/
ALARMS
RED BLU
YEL
ON LINE
T1 NETWORK
INTERFACE
DROP/INSERT
INTERFACE
DI SYNC
ETHERNET
Résumé du contenu de la page N° 2
Résumé du contenu de la page N° 3
NOTICE Cabletron Systems reserves the right to make changes in specifications and other information contained in this document without prior notice. The reader should in all cases consult Cabletron Systems to determine whether any such changes have been made. The hardware, firmware, or software described in this manual is subject to change without notice. IN NO EVENT SHALL CABLETRON SYSTEMS BE LIABLE FOR ANY INCIDENTAL, INDIRECT, SPECIAL, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INC
Résumé du contenu de la page N° 4
FCC NOTICE This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protectio
Résumé du contenu de la page N° 5
Notice to Users of T1 Service The following instructions are provided to ensure compliance with the Federal Communications Commission (FCC) Rules, Part 68. 1.) All direct connections to T1 lines must be made using standard plugs and jacks. 2.) Before connecting the unit, you must inform the local telephone company of the following information: Port ID REN/SOC FIC USOC CSMIM-T1 6.0Y 04DU9-BN RJ48C (Network Port) 04DU9-DN 04DU9-1KN CSMIM-T1 (Drop 6.0P(XD) 04DU9-1ZN N/A and Insert Port) 04D
Résumé du contenu de la page N° 6
Equipment Attachment Limitations NOTICE: The Indusrty Canada label identifies certified equipment. This certification means that the equipment meets certain telecommunications network protective operational and safety requirements. The Industry Canada does not guarantee the equipment will operate to the user’s satisfaction. Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local telecommunications company. The eq
Résumé du contenu de la page N° 7
EXCLUSION OF WARRANTY AND DISCLAIMER OF LIABILITY WARRANTY. Except as may be specifically provided by 1. EXCLUSION OF Cabletron in writing, Cabletron makes no warranty, expressed or implied, concerning the Program (including Its documentation and media). CABLETRON DISCLAIMS ALL WARRANTIES, OTHER THAN THOSE SUPPLIED TO YOU BY CABLETRON IN WRITING, EITHER EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO IMPLIED WARRANTIES OF MERCHANTABLITY AND FITNESS FOR A PARTICULAR PURPOSE, WITH RESPE
Résumé du contenu de la page N° 8
viii CSMIM-T1 Hardware Installation Guide
Résumé du contenu de la page N° 9
TABLE OF CONTENTS CHAPTER 1 INTRODUCTION 1.1 General........................................................................................ 1-1 1.2 Organization of This Document................................................... 1-1 1.3 Document Conventions ............................................................... 1-2 1.4 Getting Help................................................................................. 1-3 1.5 CSMIM-T1 Overview ..........................................
Résumé du contenu de la page N° 10
Table of Contents 2.8.1 Invoking the Console Monitor........................................2-15 2.8.2 Self-Booting the CSMIM-T1 ..........................................2-15 2.8.3 Reloading EFS Key Value.............................................2-16 CHAPTER 3 ROM MONITOR COMMANDS 3.1 General ........................................................................................3-1 3.2 Commands...................................................................................3-3 3.
Résumé du contenu de la page N° 11
Table of Contents 5.3.1 Boot Error Report.......................................................... 5-10 5.3.2 Correcting CSMIM-T1 Parameters ............................... 5-13 5.3.2.1 Load Server Host Not Responding............... 5-14 5.3.2.2 UNIX Host on the LAN ................................. 5-14 5.3.2.3 Another CSMIM-T1 ...................................... 5-15 5.3.2.4 VAX VMS Load Host on the LAN ................. 5-16 5.4 CSMIM-T1 Dumps.......................................
Résumé du contenu de la page N° 12
Table of Contents APPENDIX A PORT PIN/SIGNAL ALLOCATIONS A.1 General ....................................................................................... A-1 A.2 Console Port ............................................................................... A-1 A.3 Interface Ports............................................................................. A-2 A.4 Additional Cabletron Cables and Connectors ............................. A-3 xii CSMIM-T1 Hardware Installation Guide
Résumé du contenu de la page N° 13
CHAPTER 1 INTRODUCTION 1.1 GENERAL Welcome to the Cabletron Systems’ CSMIM-T1 Hardware Installation Guide. This guide provides procedures for the installation of the CSMIM-T1 into the Cabletron Systems Multi Media Access Center (MMAC), as well as information on configuring your communications server to load its operational software. Please read through this manual to familiarize yourself with the content and to gain an understanding of the features of the product. This
Résumé du contenu de la page N° 14
Chapter 1: INTRODUCTION • Chapter 5, Troubleshooting Procedures, provides Troubleshooting and diagnostic information. • Chapter 6, Modem Guide, describes modem features and setup. • Chapter 7, AT Commands and Registers, provides a listing of modem commands and parameters. • Appendix A, Port/Pin Signal Allocations, details the CSMIM-T1 port pinouts, and cabling information. 1.3 DOCUMENT CONVENTIONS The following conventions are used throughout this document: Note symb
Résumé du contenu de la page N° 15
Getting Help 1.4 GETTING HELP If you need additional support related to this device, or if you have any questions, comments, or suggestions concerning this manual, contact Cabletron Systems Technical Support: Phone (603) 332-9400 Monday – Friday; 8 A.M. – 8 P.M. Eastern Time CompuServe GO CTRON from any ! prompt Internet mail support@ctron.com FTP ctron.com (134.141.197.25) Login anonymous Password your email address BBS (603) 335-3358 Modem setting 8N1: 8 data b
Résumé du contenu de la page N° 16
Chapter 1: INTRODUCTION 1.5 CSMIM-T1 OVERVIEW The CSMIM-T1 is a dual-slot, Annex Software compatible system designed to reside in the MMAC series of hubs. The module takes the existing CSMIM2 core and adds enhanced processing power in the form of dual 486SXLC2-40 clock doubled processors. Both the main and secondary processors have been upgraded, which allows the main processor to control the MMAC network interfaces, while the second controls the serial ports. These processors have
Résumé du contenu de la page N° 17
CSMIM-T1 Front Panel 1.5.1 Software Information The CSMIM-T1 is shipped to our customers with software that provides network access to the following networks: • Novell Netware (IPX) • UNIX (TCP/IP) • Macintosh (AppleTalk) Refer to the software document set for a description of the supported software features. In addition to the standard software package, the CSMIM-T1 software distribution includes a number of T-1 specific commands and parameters that are used for configuration and a
Résumé du contenu de la page N° 18
Chapter 1: INTRODUCTION CSMIM-T1 SN 1-8 17-24 STAT S/U MODEM 9-16 ATTN TRAF CONFIG STATUS CD TX RX A B C 1 2 3 4 SET UP 5 6 7 8 9 10 CONSOLE 11 MODEM PORT 12 STATUS 13 14 15 16 17 18 19 20 21 22 23 24 TEST LOS SYNC NETWORK STATUS/ ALARMS RED BLU YEL ON LINE T1 NETWORK INTERFACE DROP/INSERT INTERFACE DI SYNC ETHERNET Figure 1-1 CSMIM-T1 Front Panel 1.6.1 Console Port The Console Port is used for system setup and diagnosti
Résumé du contenu de la page N° 19
CSMIM-T1 Front Panel 1.6.2 System LED Indicators There are 7 indicators to show system activity and status. ATTN The amber Attention LED is on when the module requires operator attention, and flashes when a problem is detected. STAT The green Status LED is ON after the module passes the core power-up diagnostics. This LED also flashes while the module is in a reset state. TRAF The green Traffic LED flashes when the module successfully transmits or receives data over the MM
Résumé du contenu de la page N° 20
Chapter 1: INTRODUCTION 1.6.4 T-1 Network Access There are two ports on the front panel that allow access to the T-1 network. The T-1 Network Interface Port is an 8-pin, RJ48C port that provides access for the digital T-1 line. The Drop/Insert Interface is also an 8-pin, RJ48C port, and provides connection to a local Private Branch Exchange (PBX), or other equipment, such as an ETWMIM equipped with a T-1 interface. In addition to these ports, there are 8 Status LEDs that p
