Instruction d'utilisation Apple Mac Pro Bluetooth Cable

Résumé du contenu de la page N° 1

 Mac Pro
Bluetooth Cable
Replacement Instructions
Note: Follow these instructions carefully. Failure to do so could damage your equipment and
First Steps
void its warranty.
1 Shut down computer.
2 Wait 10 minutes.
Warning: Parts inside
computer can be very
hot. Allow computer
to cool down before
continuing.
3 Unplug all external
cables except power
cord.
4 Touch metal PCI cover
on back of computer.
5 Unplug power cord.
Opening the
Computer
1 Hold side access
panel and lift latch on
b

Résumé du contenu de la page N° 2

Removing the Installed Bluetooth Cable Before you can remove the Bluetooth cable, you must remove the processor tray. 1 Locate processor tray. 2 Press down and release 2 latches on front of processor tray. © 2009 Apple Inc. All rights reserved. 073-1256 Rev. A 2

Résumé du contenu de la page N° 3

3 Holding tray by latches, lift it out of computer. 4 Place tray DIMM side up on soft, clean cloth. 5 Locate Bluetooth cable. © 2009 Apple Inc. All rights reserved. 073-1256 Rev. A 3

Résumé du contenu de la page N° 4

6 Disconnect cable from Bluetooth card and backplane board. 7 Remove cable from computer. Installing the Replacement Bluetooth Cable 1 Connect cable to Bluetooth card and backplane board. 2 Holding processor tray by latches, lower it back into computer. 3 Make sure latches are closed flush with front of processor tray. © 2009 Apple Inc. All rights reserved. 073-1256 Rev. A 4

Résumé du contenu de la page N° 5

Closing the Computer 1 Replace access panel. Note: Make sure latch is up before you replace panel. If latch is down, panel will not seat correctly. 2 Push latch down to close and secure access panel. Warning: Never turn on computer unless all its internal and external parts are in place and it is closed. Operating computer when open or missing parts can cause damage or injury.  Apple Inc. © 2009 Apple Inc. All rights reserved. This document is protected under U.S. Copyright Law a