Résumé du contenu de la page N° 1
EZ Connect
ADSL USB Modem
ADSL USB Modem
High-speed Internet access over existing phone lines
One RJ-11 ADSL port
Delivers USB plug-and-play installation
Supports full-rate DMT connection
(8 Mbps downstream, 1 Mbps upstream)
Supports econmical G.lite connection
(1.5 Mbps downstream, 512 Kbps upstream)
Graphic interface for ADSL connection management
User Guide
SMC7003-USB
Résumé du contenu de la page N° 2
Résumé du contenu de la page N° 3
EZ Connect ADSL USB Modem User Guide From SMC’s EZ Connect line of feature-rich SOHO solutions 6 Hughes Irvine, CA 92618 April 2001 Phone: (949) 707-2400 Pub. # 150552-102 R02
Résumé du contenu de la page N° 4
Information furnished by SMC Networks, Inc. (SMC) is believed to be accurate and reliable. However, no responsibility is assumed by SMC for its use, nor for any infringements of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of SMC. SMC reserves the right to change specifications at any time without notice. Copyright © 2001 by SMC Networks, Inc. 6 Hughes Irvine, CA 92618 All rights re
Résumé du contenu de la page N° 5
LIMITED WARRANTY Limited Warranty Limited Warranty Statement: SMC Networks, Inc. (“SMC”) warrants its products to be free from defects in workmanship and materials, under normal use and service, for the applicable warranty term. All SMC products carry a standard 90-day limited warranty from the date of purchase from SMC or its Authorized Reseller. SMC may, at its own discretion, repair or replace any product not operating as warranted with a similar or functionally equivalent product, durin
Résumé du contenu de la page N° 6
LIMITED WARRANTY IN FACT OR BY OPERATION OF LAW, STATUTORY OR OTHERWISE, INCLUDING WARRANTIES OR CONDITIONS OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. SMC NEITHER ASSUMES NOR AUTHORIZES ANY OTHER PERSON TO ASSUME FOR IT ANY OTHER LIABILITY IN CONNECTION WITH THE SALE, INSTALLATION, MAINTENANCE OR USE OF ITS PRODUCTS. SMC SHALL NOT BE LIABLE UNDER THIS WARRANTY IF ITS TESTING AND EXAMINATION DISCLOSE THE ALLEGED DEFECT IN THE PRODUCT DOES NOT EXIST OR WAS CAUSED BY CUSTOMER’S
Résumé du contenu de la page N° 7
COMPLIANCES FCC - Class B This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with instructions, may cause harmful interference to radio communications. However, there is no gua
Résumé du contenu de la page N° 8
COMPLIANCES Items (b) and (d) are indicated on the label. The Ringer Equivalence Number (REN) is used to determine how many devices can be connected to your telephone line. In most areas, the sum of the REN of all the devices on any one line should not exceed 5.0. If too many devices are attached, they may not ring properly. Industry Canada Required Information EQUIPMENT ATTACHMENTS LIMITATIONS To ensure that certified equipment is attached correctly and only to the networks of participating
Résumé du contenu de la page N° 9
COMPLIANCES EC Conformance Declaration - Class B SMC contact for these products in Europe is: SMC Networks Europe, Edificio Conata II, o a Calle Fructuós Gelabert 6-8, 2 , 4 , 08970 - Sant Joan Despí, Barcelona, Spain. This information technology equipment complies with the requirements of the Low Voltage Directive 73/23/EEC and the EMC Directive 89/336/EEC, and carries the CE Mark accordingly. It conforms to the following specifications: EMC: EN55022 (1988)/CISPR-22 (1995) Class B IEC 1000-4
Résumé du contenu de la page N° 10
COMPLIANCES Australia AS/NZS 3548 (1995) - Class B SMC contact for products in Australia is: SMC Communications Pty. Ltd. Suite 18, 12 Tryon Road, Lindfield NSW2070, Phone: 61-2-94160437 Fax: 61-2-94160474 x
Résumé du contenu de la page N° 11
TABLE OF CONTENTS 1 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1 Key Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-2 2 Hardware Installation . . . . . . . . . . . . . . . . . . . . . 2-1 Package Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-1 Description of Hardware . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-2 LED Functions . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Résumé du contenu de la page N° 12
TABLE OF CONTENTS System Information Tab . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-3 Configuration Tab . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-4 8 Uninstalling Modem Software . . . . . . . . . . . . . . .8-1 A Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . .A-1 You Cannot Connect to the Network . . . . . . . . . . . . . . . . . . . A-1 You Cannot Connect to the Internet . . . . . . . . . . . . . . . . . . . A-1 B Specifications . .
Résumé du contenu de la page N° 13
CHAPTER 1 INTRODUCTION The EZ Connect ADSL USB Modem provides high-speed Internet access over existing phone lines by making use of previously unused frequency bandwidth above the voice band. By placing ADSL signals above the frequency of the voice signal, ADSL service can coexist on the same line with your telephone service. ADSL is asymmetric in that it provides a higher data rate in the downstream (receive) direction than in the upstream (transmit) direction. Asymmetric operation is id
Résumé du contenu de la page N° 14
INTRODUCTION and other multimedia services requiring guaranteed Quality of Service (QoS). This device enables true telecommuting for the first time by providing complete access to Internet and corporate resources via multiprotocol encapsulation (including TCP/IP, Novell’s IPX, and Windows NetBEUI network protocols). Note: Since this modem supports both G.dmt and G.lite, it requires an external splitter to separate the traffic entering your premises into data and voice, and also to merge t
Résumé du contenu de la page N° 15
INTRODUCTION Supports Windows 98, Windows 98 Second Edition, and Windows 2000 Delivers USB plug-and-play installation and configuration 1-3
Résumé du contenu de la page N° 16
INTRODUCTION 1-4
Résumé du contenu de la page N° 17
CHAPTER 2 HARDWARE INSTALLATION Before installing the SMC ADSL USB Modem verify that you have all the items listed under “Package Contents.” If any of the items are missing or damaged, contact your local SMC distributor. Also be sure you have all the necessary cabling before installing the modem. Package Contents After unpacking the EZ Connect ADSL USB Modem, check the contents of the box to be sure you’ve received the following components: EZ Connect ADSL USB Modem (SMC7003-USB) 1 US
Résumé du contenu de la page N° 18
HARDWARE INSTALLATION Description of Hardware Setting up the EZ Connect ADSL USB Modem involves connecting the device’s cables and installing the driver software. Note that Windows 98, 98 SE, or 2000 should already be installed on the computer before installing the driver software. The following figure shows the components of this modem: Power LED (Green ) Data LED (Green) USB Port RJ-11 Port (Type-B) Figure 2-1. EZ Connect ADSL USB Modem 2-2
Résumé du contenu de la page N° 19
HARDWARE INSTALLATION LED Functions The EZ Connect ADSL USB Modem contains two LEDs on the top panel, one is marked “Data” and the other “Power”. The operational status of the modem is indicated by the LED conditions listed below. LED Status Description Data Flashing Indicates the modem is synchronizing its Green ADSL/ATM link with the head end. On Indicates an ADSL/ATM link has been Green established on the RJ-11 port. Power On Power is being supplied to the modem via the Green USB bus. P
Résumé du contenu de la page N° 20
HARDWARE INSTALLATION Note that to share Internet access on your network, you will need to install appropriate Internet-sharing software on one PC. The ADSL network must meet the following minimum requirements: ADSL service from your local telephone company or have access to an ADSL DSLAM (Digital Subscriber Line Access Multiplexer) PC configured with fixed IP address or dynamic IP address assignment via DHCP, Gateway server address, and DNS server address from your telephone company
