Instruction d'utilisation Snapper 1695295

Résumé du contenu de la page N° 1

Light Kit
Installation
Part No. 1695295
For Axion and 150Z Zero Turn Models
Instructions
1
1
2
2 4
4
5
3
3
6
Kit Contents:
Ref. Part No. Qty. Description
1 N/A 2 NUT, Hex, 5/16-18
2 N/A 2 LOCKWASHER, 5/16
3 N/A 2 CARRIAGE BOLT, 5/16-18 x 1
4 1726801 2 HEADLIGHT ASSEMBLY,
7
(Includes Ref. Nos. 1, 2, & 3)
5 1716951 1 SWITCH, Headlight
6 2172434 2 CLIP, Wire
7 1726796 1 HARNESS, Wire
Figure 1. Contents
WARNING
B
Before beginning any service work turn off the
PTO, set the parking brake, turn off

Résumé du contenu de la page N° 2

Installation Instructions Light Kit D C B A B C A E Figure 3. Switch Installation A. Control Panel Figure 4. Switch Wire Connections B. Key(s) A. Wire, Red w/Blue C. Cover Plug B. Wire, Green w/Black D. Switch, Headlight C. Wire Harness, Main E. Wires, Red w/Blue and Green w/Black 5. Remove key(s) (B, Figure 3) from control panel (A). 6. Lift seat to gain access to engine compartment. 7. Remove and discard cover plug (C, Figure 3) from control panel (A). 8. Install switch (D, Figure 3) into ho

Résumé du contenu de la page N° 3

Light Kit Installation Instructions Note: The side of the headlight wire harness with the ribbed plastic cover (C, Figure 6) connects to the left side light. The side of the headlight wire harness with the braided cover goes to the right side light. D 13. Connect harness plug (B, Figure 6) to the back of the E headlight (A). Make sure the connector is fully seat- C ed into the light. 14. Slide wire clip (D) onto the back side of bracket (E) as shown. Push down to secure. B 15. Slide headlight

Résumé du contenu de la page N° 4

Installation Instructions Light Kit NOTES Form No. 1734309 Revision:00 TP 200-4583-00-AT-SN MANUFACTURING, INC. Briggs & Stratton Yard Power Products Group Copyright © 2007 Briggs & Stratton Corporation 500 N Spring Street / PO Box 997 Milwaukee, WI USA. All Rights Reserved Port Washington, WI 53074-0997 USA 4