Résumé du contenu de la page N° 1
Single-bay NAS Server
NAS-1100
User’s Manual
Résumé du contenu de la page N° 2
Copyright (C) 2004 PLANET Technology Corp. All rights reserved. The products and programs described in this User’s Manual are licensed products of PLANET Technology, This User’s Manual contains proprietary information protected by copyright, and this User’s Manual and all accompanying hardware, software, and documentation are copyrighted. No part of this User’s Manual may be copied, photocopied, reproduced, translated, or reduced to any electronic medium or machine-readable form by any mean
Résumé du contenu de la page N° 3
TABLE OF CONTENTS Chapter 1 Introduction..................................................................................1 1.1 Package Contents ...........................................................................1 1.2 System Requirements ....................................................................1 1.3 Features ...........................................................................................1 1.4 Specification.....................................................
Résumé du contenu de la page N° 4
4.5.2 FTP Password.................................................................................................... 30 Chapter 5 Troubleshooting......................................................................... 31 4
Résumé du contenu de la page N° 5
Chapter 1 Introduction The typical installation of PLANET NAS-1100 can be completed in less than ten minutes without any additional configuration of other servers or clients on your network. With the features of a compact, economical and powerful storage server, the NAS-1100 fits your SOHO (Small Office or Home Office) or personal requirements. It functions as a file / FTP server and provides an easy way for LAN users to backup data or share files through Intranet and Internet. The NAS-1100
Résumé du contenu de la page N° 6
1.4 Specification Support Protocol TCP/IP, FTP, HTTP, SMB Standards IEEE 802.3, IEEE 802.3u LAN Connector RJ-45 Interface (10/100Mbps) LAN Speed 10/100 Mbps at half duplex 20/200 Mbps at full duplex LEDs PWR, LNK/ACT. HDD System Configuration Windows Base utility Web Browser (Internet Explorer, Netscape) Dimensions 220 x 60 x 132 mm (W x D x H) Weight 865g (without HDD) Operating Temperature: 0 ~ 40°C Humidity: 10 ~ 95%(non-condensing) Storage Temperature: -10 ~ 70°C Humidity: 10
Résumé du contenu de la page N° 7
Chapter 2 Hardware Installation Please refer to the steps below to install your HDD into NAS-1100: 1. Loosing the two screws on the rear panel by screwdriver or hands. 2. Grabbing the front panel and separate the HD holder from case. 3. Your HD jumper should be set to Master. Different Hard Disk has different jumper settings; please refer to your Hard Disk manual for correct setting. 4. Insert the IDE connector into the IDE socket of the Hard Disk. Make sure the pin 1 on the cable is
Résumé du contenu de la page N° 8
5. Push the power connector into the power socket of HD as shown. The power cable is designed to go in one way, so you shouldn't have any problems. 6. Secure the Hard Disk with the screws we provided. 7. Push the Hard disk and HD holder back into the box and secure it with the two screws. 4
Résumé du contenu de la page N° 9
Chapter 3 Setup Wizard The Setup Wizard guides you to finish the initial installation of NAS-1100, and the basic configurations for Network. Please follow the steps as below. 1. Insert the CD-ROM into the CD-ROM drive to initiate the autorun program. Once completed a menu screen will appear. 2. Click on “Setup Wizard” hyper link to initiate the program. If the menu screen is not shown, you can click the “Start” button and choose “Run”. When the box appears, enter “E:\Utility\setup.exe” (
Résumé du contenu de la page N° 10
? ONLY use the power adapter supplied with the NAS-1100. Otherwise, the product may Note: be damaged. 4. Connect NAS-1100 to your switch or hub and make sure the LNK/ACT LED is light on. 6
Résumé du contenu de la page N° 11
5. Press “Next” to start the scan. 6. The Setup Wizard will scan available NAS-1100 in your network. 7
Résumé du contenu de la page N° 12
7. The screen will show you the available NAS-1100. Please select the device you want to setup and click “Next” to continue. Note: There will be two status of the “Reachable?” field. Reachable Status Action Yes NAS-1100 network setting is compatible Creating two shortcuts to access with your LAN. and setup the NAS-1100. No NAS-1100 network setting is not compatible Set a new IP address to NAS-1100 with your LAN. and creating two shortcuts to access and setup the NAS-1100. 8. If t
Résumé du contenu de la page N° 13
9. The NAS-1100 installation is completed. This dialog box prompts you that setup wizard will add two shortcuts on you desktop, you can configure more advance settings by click those shortcuts. Please press “OK”. 10. Please click “OK” to open the shortcut or “Cancel” to finish the setup wizard without opening shortcut. 11. You will find two shortcuts on your desktop. You can start to use NAS-1100 or setup further settings by clicking on the respective buttons. Note1: the abo
Résumé du contenu de la page N° 14
must run the Setup Wizard again to create new shortcuts. Note 2: the Setup Wizard will detect your HD content, but only for the first partition. It is recommended that do not partition the HD. To use the storage space of NAS-1100, you can double click on the “Access My Network HD - NAS-1100” icon. A dialog box will pop up and ask for username/password. There are three pre-defined accounts available: all: able to read and write all folders in NAS-1100 power: able to read and write the
Résumé du contenu de la page N° 15
Chapter 4 Configuration The NAS-1100 provides a web-based configuration interface and you can simply access it by double click on the “Setup My Network HD – NAS-1100” icon on desktop. A dialog box will pop up and ask for username/password. The default user name and password are both “admin”. 4.1 Home On this screen, you can see the general information of your NAS-1100 including Host Name, IP address, and Firmware Version. You can also access other configuration screens here. 11
Résumé du contenu de la page N° 16
Options Description Status Host Name The identification of the NAS-1100 showing on the “My Neighborhood”. IP Address IP Address of this NAS-1100. Version Firmware version. Check and repair MS-DOS file system Show HDD file When the NAS-1100 does not shut down properly (such as power off the device by system status unplugging the power adapter), the NAS-1100 will automatically check and repair MS-DOS file system to ensure the system integrity. Please wait for system completing this pr
Résumé du contenu de la page N° 17
Options Description Host Name The identification of the NAS-1100 showing on the “My Network Neighborhood”. IP Address IP Address of this NAS-1000. HD used (%) The usage percentage of HDD. Up-time The estimate time of system operating period. Version Current firmware version. Samba Users The number of users who is accessing the NAS-1100 from “My Network Neighborhood”. You can have max five online users to access NAS-1100 at the same time. FTP Users The number of users who is connec
Résumé du contenu de la page N° 18
4.2.1 Host Name Setting Parameters Description Host Name Identification of NAS-1100 represents on “My Network Neighborhood”. Work Group The name of the workgroup which NAS-1100 is located. Description Brief description of the NAS-1100. 14
Résumé du contenu de la page N° 19
4.2.2 IP Address Setting Parameters Description IP Address Designate the NAS-1100’s IP Address. This IP Address should be unique in your network. The default IP Address is 192.168.1.1. Subnet Mask Specify a Subnet Mask for your LAN segment. The default value is 255.255.255.0. Gateway Specify the gateway IP in your network. DNS Server This is the ISP’s DNS server IP address that they gave you; or you can specify your own preferred DNS server IP address. 4.2.3 Superuser/Password Set
Résumé du contenu de la page N° 20
Parameters Description Superuser name The administrative user name to access the web interface of NAS-1100. Old Password Enter the old password here. New Password Enter the new password here. Confirm Password Please enter the new password here again to confirm. 4.3 Administration In this screen, you can manage the NAS-1100 with some useful tools. 16
