Instruction d'utilisation Paradyne Micro Interface Module MIM-2000F

Résumé du contenu de la page N° 1

MIM-2000F
Installation Instructions
Document Number MIM2-A2-GZ42-00
June 2005
Contents
Software and Firmware License Agreement ...................................................... 1
Product Documentation Online .......................................................................... 3
Unpacking and Inspecting the Equipment ......................................................... 3
Installing the MIM-2000F ................................................................................... 3

Résumé du contenu de la page N° 2

in the Product purchased from Paradyne or its authorized distributor or reseller under the following terms and conditions: 1. Ownership: The Software is the sole property of Paradyne and/or its licensors. The Licensee acquires no title, right or interest in the Software other than the license granted under this Agreement. 2. Licensee shall not use the Software in any country other than the country in which the Product was rightfully purchased except upon prior written notice to Paradyne and

Résumé du contenu de la page N° 3

Product Documentation Online Complete documentation for Paradyne products is available at www.paradyne.com. Select Support → Technical Manuals. To order a paper copy of a Paradyne document, or to speak with a sales representative, please call 1-727-530-2000. Unpacking and Inspecting the Equipment HANDLING PRECAUTIONS FOR ! STATIC-SENSITIVE DEVICES This product is designed to protect sensitive components from damage due to electrostatic discharge (ESD) during normal operation. When performin

Résumé du contenu de la page N° 4

 
  
  3. Slide the MIM-2000F firmly into place. Do not use excessive force. 4. Secure the MIM-2000F by tightening the fastening screws on the MIM faceplate with a flat-blade screwdriver. Installing and Cabling SFP Transceivers Both SFP copper and fiber optic transceivers may be installed in the MIM-2000F. The following SFP fiber optic transceivers are available: SFP-MMF – GigE SFP Multimode Fiber Optic Transceiver, Short Reach SFP-SMF10 – GigE SFP Single Mode Fiber O

Résumé du contenu de la page N° 5

LED Indicators Each port is associated with two LEDs: Lnk (Link) and Act (Active): Table 1. Front Panel LEDs LED State Indication Lnk (Link) Solid green Connection is established No illumination Connection is not established Act (Active) No illumination No data activity on the circuit Flashing amber Data is flowing through the circuit Regulatory Notices ! ! UNITED STATES – EMI NOTICE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to

Résumé du contenu de la page N° 6

! EUROPEAN REGULATORY COMPLIANCE The following regulatory compliance information applies to the MIM-2000F as installed in the 4929 DSLAM or BSX8000-5 Broadband Services Switch: This Class A product complies with European Norm EN55022. Warning: In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures to correct the situation. Warranty, Sales, Service, and Training Information Contact your local sales representative,