Instruction d'utilisation Omnitron Systems Technology FlexPoint Powered Chassis 4385

Résumé du contenu de la page N° 1

8 Omnitron Systems Technology, Inc. Omnitron Systems Technology, Inc.
Hot Attachment of Power Supplies:
1. Unpack the power supply carefully. Inspect for any damages. If any damage
is observed, do not use the power supply and call (949) 250-6510 to report
the damage immediately and request a replacement unit.
2. Attach the power supply to the chassis and reconnect the 48VDC power source
to the FlexPoint power supply.
3. Locate the 48VDC circuit breaker and switch the circuit breaker to the ON

Résumé du contenu de la page N° 2

2 Omnitron Systems Technology, Inc. 7 Safety Considerations Warning It is very strongly recommended that a replacement power supply unit be installed The operating description in this Instruction Manual is for use by qualified personnel only. To as soon as possible in order to prevent overheating of the chassis unit. avoid electrical shock, do not perform any servicing of this unit other than that contained in the operating instructions, unless you are qualified and certified to do so by Omnitr

Résumé du contenu de la page N° 3

6 Omnitron Systems Technology, Inc. Omnitron Systems Technology, Inc.3 Cabling and Power-Up: 1. Insure that both FlexPoint Chassis power supply switches are in the OFF TM FlexPoint Powered Chassis position. User’s Manual 2. Assure that the 48VDC circuit breaker can supply 3A of current per power supply. 3. Locate the 48VDC circuit breaker, and switch the 48VDC circuit breaker to the OFF position. GENERAL DESCRIPTION 4. Cut the power cable to the length required. 5. Strip approximately 3/8 of an

Résumé du contenu de la page N° 4

4 Omnitron Systems Technology, Inc. Omnitron Systems Technology, Inc. 5 8. Wiring methods used for the connection of the equipment to the primary CONTROLS AND INDICATORS power supply shall be in accordance with the National Electrical Code, ANSI/NFPA 70, and the Canadian Electrical Code, Part I, C22.1. LEDs Display: The Powered Chassis features two LEDs on the left front of the chassis, these LEDs display the status of the two power supplies. UNPACKING a. Visual Inspection: Inspect equipment in