Résumé du contenu de la page N° 1
10/100Base-TX USB
100Base-FX
1000Base-X 10/100/1000 USB 10/100Base-TX USB
100Base-FX
LACT PWR
PWR USB
LACT FD LACT FD
DPXLACTPWR
PWR
LACT
1000Base-X 10/100/1000 USB
CBFFG
100Base-X 1000Base-X
USB
DPXLACTPWR
PWR LNK DPX
LNK USB
1000Base-X 1000Base-X
USB
CFBRM
1 2
PWR
LNK USB
LNK
CFBRM
FBRM1xxx-1xx & BFFG1xxx-1xx
Chassis & Stand-Alone Remotely Managed
Devices
Manual
33345, Revision D
Résumé du contenu de la page N° 2
Résumé du contenu de la page N° 3
Résumé du contenu de la page N° 4
Résumé du contenu de la page N° 5
Transition Networks Table of contents Section I: ..................................................................................................................................................................1 Product Description ................................................................................................................................................1 General description.............................................................................................
Résumé du contenu de la page N° 6
Transition Networks Table of contents, continued Section Vlll: ...........................................................................................................................................................82 Troubleshooting ....................................................................................................................................................82 Troubleshooting problem and corrective action table.................................................
Résumé du contenu de la page N° 7
Transition Networks Trademark, copyright information, and about this manual Trademark All trademarks and registered trademarks are the property of their respective owners. Copyright © 2008 Transition Networks: All rights reserved. No part of this work may be restrictions reproduced or used in any form or by any means—graphic, electronic, or mechanical—without written permission from Transition Networks. Printed in the U.S.A. About this This manual is designed to help you f
Résumé du contenu de la page N° 8
Transition Networks Caution and warnings Definitions Cautions indicate that there is the possibility of poor equipment performance or damage to the equipment. The symbol below identifies cautions Warnings indicate that there is the possibility of injury to person. Cautions and Warnings appear here and may appear throughout this manual where appropriate. Failure to read and understand the information identified by the symbol could result in poor equipment performance, damage to th
Résumé du contenu de la page N° 9
Transition Networks Section I: Product Description In this section These are the topics: Topic See Page General description 2 Product features 3 Management methods 4 Hardware description 5 FBRM/BFFG13xx-1xx fiber-to-fiber gigabit models 13 Redundant SFBRM1040-140 models 15 24-Hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600 1
Résumé du contenu de la page N° 10
Section I: FBRM/BFFG Product Description Transition Networks General description Design and The FBRM and BFFG Devices are designed as standalone models, and also as slide- configuration in Devices for the Point System chassis. These Devices can be managed through SNMP via the Focal Point software (free), Web-based management, Local SNMP, and USB interfaces. The CFBRM and CBFFG (chassis Devices), and SFBRM and SBFFG (standalone Devices) are designed to manage Devices remotely through
Résumé du contenu de la page N° 11
Transition Networks Section I: FBRM/BFFG Product Description Product features Supported The following is a list of the major FBRM and BFFG Device supported features: features • Remote Management via OAM (IEEE 802.3ah) and IP-based management • AutoCross • Transparent Link pass-through with automatic link restoration • Far end fault detection on fiber ports • OAM IEEE 802.3ah • Auto-Negotiation (enable/disable) • Force 10 Mbs or 100 Mbs speed (non-gigabit models only) • Force ha
Résumé du contenu de la page N° 12
Section I: FBRM/BFFG Product Description Transition Networks Management methods Management The FBRM and BFFG Devices support the following management methods: • USB CLI (Command Line Interface) • Telnet • MMU (Management Module Unit) chassis web-based • IP-based (web-based directly to the Device) USB USB management requires a direct connection to the Device via a computer. This method is used to set up initially or to troubleshoot Devices in the field. Telnet Telnet
Résumé du contenu de la page N° 13
Transition Networks Section I: FBRM/BFFG Product Description Hardware description Front panel The front panel of the CFBRM10xx-1xx Devices has the following ports and LEDs: CFBRM Ports Front Panel LEDs • Power (one) One RJ-45 auto-sensing of 10Base or 10/100Base-TX UTP • RJ-45 port (two) connections One 100Base-FX/LX/BX fiber either SC or ST connectors • LACT (one) • DPX (one) One USB • USB (one) Figure 1: Chassis CFBRM10xx-1xx Device Front Panel Note: The LEDs an
Résumé du contenu de la page N° 14
Section I: FBRM/BFFG Product Description Transition Networks Hardware description, continued Front panel The front panel of the CFBRM 1040-140 Devices has the following ports and LEDs: CFBRM Ports Front Panel LEDs • Power (one) 100Base-FX SFP port • Link/Active 10/100 Base-T copper port • Speed • Duplex (one) One USB • USB (one) Figure 2: CFBRM1040-100 Front Panel Note: The LEDs and ports are the same on the SFBRM1040-140 standalone models. Continued on next pa
Résumé du contenu de la page N° 15
Transition Networks Section I: FBRM/BFFG Product Description Hardware description, continued Front panel The front panel of the CFBRM13xx-1xx Devices has the following ports and LEDs: CFBRM Gbit Ports Front Panel LEDs • Power (one) One 100 Base-T • Fiber-Port Link (one) One 1000Base-FX/LX/BX fiber either SC or ST connectors • Fiber-Port Link (one) One USB • USB (one) SC Connector SC Connector Fiber Fiber USB Port 100Base-T 1000Base-X PWR LNK LNK USB Power USB LED LED Fiber L
Résumé du contenu de la page N° 16
Section I: FBRM/BFFG Product Description Transition Networks Hardware description, continued Front panel The front panel of the CBFFG10xx-1xx Devices has the following ports and LEDs: CBFFG Gbit Ports Front Panel LEDs • Power (one) 1000Base-SX/LX/BX fiber SC port • Link/Active 10/100/1000Base-T copper port • Speed • Duplex (one) One USB • USB (one) Figure 4: CBFFG10xx-1xx Device Front Panel Note: The LEDs and ports are the same on the SBFFG10xx-1xx standalone mode
Résumé du contenu de la page N° 17
Transition Networks Section I: FBRM/BFFG Product Description Hardware description, continued Front panel The front panel of the CBFFG1040-1xx Devices has the following ports and LEDs: CBFFG Gbit Ports Front Panel LEDs • Power (one) 1000Base SFP port • Link/Active 10/100/1000Base-T copper port • Speed • Duplex (one) One USB • USB (one) SFP Port Duplex/Link Speed USB Port Power 1000Base-X 10/100/1000 USB Link Active USB LED RJ45 Port Figure 5: CBFFG1040-1xx Device Front P
Résumé du contenu de la page N° 18
Section I: FBRM/BFFG Product Description Transition Networks Hardware description, continued Front panel The front panel of the CBFFG13xx-1xx Devices has the following ports and LEDs: CBFFG Gbit Ports Front Panel LEDs • Power (one) Two 1000Base-FX/LX/BX fiber either SC or ST connectors • Fiber-Port Link (two) • Duplex (one) One USB • USB (one) Figure 6: Chassis CBFFG13xx-1xx Device Front Panel Note: The LEDs and ports are the same on the SBFFG13xx-1xx standalone
Résumé du contenu de la page N° 19
Transition Networks Section I: FBRM/BFFG Product Description Hardware description, continued Front panel The front panel of the SFBRM1040-140 redundant Devices has the following ports SFBRM and LEDs: Ports Front Panel LEDs • Power (one) 1000Base SX/LX SFP ports (2 and 3) • Link/Active • Duplex 10/100/1000Base-T copper port (1) • Speed • Duplex (one) One USB • USB (one) Figure 7: CBFFG1040-140 Device Front Panel Continued on next page 24-Hour Technical Support:
Résumé du contenu de la page N° 20
Section I: FBRM/BFFG Product Description Transition Networks Hardware description, continued Rear panel On the standalone SFBRM and SBFFG Devices only, the rear panel consists of a (standalone) power-barrel connector for connecting power via a power adaptor. See Figure 8. Figure 8: SFBRM/SBFFG 1xxx-1xx Device Real Panel (Standalone Only) Note: The Point System chassis powers the CFBRM and CBFFG chassis Devices. 12
