Résumé du contenu de la page N° 1
3-232-025-42 (2)
CD Radio
Cassette-Corder
GB
GB
Operating Instructions page 2
ES
ES
Manual de instrucciones página 2
CFD-G70
CFD-G70L
© 2001 Sony Corporation
Résumé du contenu de la page N° 2
About this manual Warning The instructions in this manual are for the CFD- To prevent fire or shock hazard, G70 and CFD-G70L. Before you start reading, do not expose the player to rain check your model number. The CFD-G70L is the or moisture. model used for illustration purpose. To avoid electrical shock, do not Note open the cabinet. Refer The name of the switch to turn on/off this player is servicing to qualified personnel indicated as below: only. “OPERATE”: CFD-G70L “POWER”: CFD-G70 Informat
Résumé du contenu de la page N° 3
Basic Operations Table of contents Basic Operations Playing a CD .................................................. 4 Listening to the radio ...................................... 6 Playing a tape ................................................. 8 Recording on a tape ...................................... 10 The CD Player Using the display .......................................... 12 Locating a specific track ............................... 12 Playing tracks repeatedly (Repeat Play) ..........
Résumé du contenu de la page N° 4
Basic Operations Playing a CD 3 1, 2 Connect the supplied mains lead (see page 20). 1 Press ZPUSH OPEN/CLOSE down to open the CD compartment and place the CD on the CD compartment. With the label side up 2 Close the lid of the CD compartment. 3 Press u (N on the remote). Display The player turns on (direct power- on) and plays all the tracks once. Track number Playing time GB 4
Résumé du contenu de la page N° 5
Basic Operations Use these buttons for additional operations OPERATE (or POWER) u ., > x ZPUSH OPEN/CLOSE VOLUME –, + To Press adjust the volume VOLUME +, – (VOL +, – on the remote) stop playback x pause playback u (X on the remote) Press the button again to resume play after pause. go to the next track > go back to the previous track . remove the CD ZPUSH OPEN/CLOSE turn on/off the player OPERATE (or POWER, see page 2) About CD-Rs/CD-RWs This player is compatible with CD-Rs/CD-RWs but playback
Résumé du contenu de la page N° 6
Listening to the radio 2 1 Connect the supplied mains lead (see page 20). 1 Press RADIO BAND•AUTO Display PRESET until the band you want appears in the display (direct power- on). Each time you press the button, the band changes as follows: CFD-G70: “FM” t “AM” CFD-G70L: “FM” t “MW” t “LW” 2 Hold down TUNE + or – until the frequency digits begin to change in the display. The player automatically scans the Indicates an FM stereo radio frequencies and stops when it broadcast finds a clear station.
Résumé du contenu de la page N° 7
Basic Operations Use these buttons for additional operations OPERATE (or POWER) MODE VOLUME –, + Tips To Press • If the FM broadcast is adjust the volume VOLUME +, – (VOL +, – on the noisy, press MODE until remote) “Mono” appears in the display and the radio will turn on/off the radio OPERATE (or POWER, see page 2) play in monaural. • If you need to change the To improve broadcast reception AM/MW tuning interval, see page 20. Reorient the aerial for FM. Reorient the player itself for AM or MW/LW
Résumé du contenu de la page N° 8
Playing a tape 21 Connect the supplied mains lead (see page 20). 1 Press xZ to open the tape With the side you want to play facing upward compartment and insert a recorded tape. Use TYPE I (normal) tape only. Close the compartment. Display 2 Press N. The player turns on (direct power-on) and starts playing. GB 8
Résumé du contenu de la page N° 9
Basic Operations Use these buttons for additional operations OPERATE (or POWER) xZ X m, M VOLUME –, + To Press adjust the volume VOLUME +, – (VOL +, – on the remote) stop playback xZ fast-forward or rewind the tape M or m pause playback X Press the button again to resume play after pause. eject the cassette xZ turn on/off the player OPERATE (or POWER, see page 2) GB 9
Résumé du contenu de la page N° 10
Recording on a tape 3 1 Connect the supplied mains lead (see page 20). With the side you want to 1 Press xZ to open the tape record on facing upward compartment and insert a blank tape. Use TYPE I (normal) tape only. 2 Select the program source you want to record. Display To record from the CD player, insert a CD (see page 4) and press x on the CD section. To record from the radio, tune in the station you want (see page 6). GB 10
Résumé du contenu de la page N° 11
Basic Operations 3 Press z to start recording (N is depressed automatically). Use these buttons for additional operations OPERATE (or POWER) xZ X MODE Tips • Adjusting the volume or the To Press audio emphasis (see page 18) will not affect the stop recording xZ recording level. pause recording X • CFD-G70L only: If the Press the button again to resume MW/LW programme makes recording. a whistling sound after you've pressed z in step 3, turn on/off the player OPERATE (or POWER, see page 2) press M
Résumé du contenu de la page N° 12
The CD Player Using the display Locating a specific track You can check information about the CD using the display. You can quickly locate any track on a CD using the number buttons on the remote. DISPLAY ENT MEMORY You can also find a specific point in a track while playing a CD. Number buttons ., > Checking the total track number and playing time Press DISPLAY ENT•MEMORY in stop mode. Total playing To locate Press time a specific track directly the number button of the track. Total track a poi
Résumé du contenu de la page N° 13
The CD Player Note You cannot locate a specific track if “SHUF” or Playing tracks “PGM” is lit in the display. Turn off the indication by pressing x. repeatedly (Repeat Play) Tip You can play tracks repeatedly in normal, When you locate a track numbered over 10, press shuffle or programme play modes (see pages >10 first, then the corresponding number buttons. 14 - 15). Example: To play track number 23, press >10 first, then 2 and 3. ., > u x MODE 1 Press x. “Cd” appears in the display. 2 Proceed
Résumé du contenu de la page N° 14
Playing tracks repeatedly (Repeat Play) (continued) Playing tracks in To cancel Repeat Play random order (Shuffle Play) Press MODE until “REP” disappears from the display. You can play tracks in random order. u x On the remote • Use N instead of u. • When you’ve selected “REP 1”, select the track by pressing the number buttons. MODE 1 Press x. “Cd” appears in the display. 2 Press MODE until “SHUF” appears in the display. 3 Press u to start shuffle play. To cancel Shuffle Play Press MODE until “S
Résumé du contenu de la page N° 15
The CD Player On the remote 1 Press x. Creating your own 2 Press MODE until “PGM” appears in the programme (Programme Play) display. 3 Press the number buttons for the tracks you want to programme in the order you want. You can arrange the playing order of up to 4 Press N. 20 tracks on a CD. ., > u x To cancel Programme Play Press MODE until “PGM” disappears from the display. To check the order of tracks before play Press DISPLAY ENT•MEMORY. Every time you press the button, the track number appe
Résumé du contenu de la page N° 16
The Radio If a station cannot be preset automatically Presetting radio stations You need to preset a station with a weak signal manually. You can store radio stations into the player’s memory. You can preset up to 30 radio 1 Press RADIO BAND•AUTO PRESET to stations (CFD-G70), 20 for FM and 10 for select the band. AM in any order or 40 radio stations (CFD- 2 Tune in a station you want. G70L), 20 for FM and 10 for MW and LW in 3 Hold down DISPLAY ENT•MEMORY any order. for 2 seconds. 4 Press PRESET
Résumé du contenu de la page N° 17
The Radio On the remote 1 Press BAND until the band you want appears in Playing preset radio the display. stations 2 Press the number button to tune in a stored station. To tune in a preset station over 10, press >10 Once you've preset the stations, use PRESET first, then the corresponding number buttons. + or – on the player or the number buttons (Example: To tune in a preset station 12, press on the remote to tune in to your favourite >10 and 1 first, and then press 2.) stations. PRESET –, + R
Résumé du contenu de la page N° 18
The Audio Emphasis Reinforcing the bass sound Selecting the audio Press POWER DRIVE WOOFER to select emphasis (SOUND/POWER DRIVE or in the display. is more effective. When the WOOFER/GAME Xpand) POWER DRIVE WOOFER function works, the button lights up. You can adjust the audio emphasis of the To return to normal sound, press the button sound you are listening to. You can also until the indication disappears from the enjoy the live presence sound from a game display. machine, etc., using the GA
Résumé du contenu de la page N° 19
The Timer The Timer To cancel the sleep function Press OPERATE (or POWER) to turn off Falling asleep to music the power. You can set the player to turn off automatically after 10, 20, 30, 60, 90, and Note 120 minutes, allowing you to fall asleep When you are playing a tape using this function: while listening to music. If the tape length of one side is longer than the set time, the player will not go off until the tape reaches the end. SLEEP 1 Play the music source you want. 2 Press SLEEP to dis
Résumé du contenu de la page N° 20
Setting Up Choosing the power sources You can use the AC power or batteries as a power source. AC IN 3 Battery compartment 1 to the mains Changing the AM/MW tuning 1 Connecting the mains lead interval Insert one end of the supplied mains The AM/MW tuning interval is preset as lead to the AC IN socket located at the follows at the factory: rear of the player, and the other end to Argentine and Brazilian models: 10 kHz the mains. Other models: 9 kHz Brazilian model only: Adjusting If you need to c
