Résumé du contenu de la page N° 1
3-263-561-31 (2)
CD Radio
Cassette-Corder
GB
GB
Operating Instructions page 2
ES
ES
Manual de instrucciones página 2
CFD-E90
CFD-E90L
© 2004 Sony Corporation
Résumé du contenu de la page N° 2
About this manual Warning The instructions in this manual are for the CFD- To prevent fire or shock hazard, E90 and CFD-E90L. Before you start reading, do not expose the player to rain check your model number. The CFD-E90L is the or moisture. model used for illustration purpose. To avoid electrical shock, do not Note open the cabinet. Refer The name of the switch to turn on/off this player is servicing to qualified personnel indicated as below: only. “OPERATE”: CFD-E90L “POWER”: CFD-E90 Warning
Résumé du contenu de la page N° 3
Basic Operations Table of contents Basic Operations Playing a CD .................................................. 4 Listening to the radio ...................................... 6 Playing a tape ................................................. 8 Recording on a tape ...................................... 10 The CD Player Using the display .......................................... 12 Locating a specific point in a track .............. 12 Playing tracks repeatedly (Repeat Play) ................
Résumé du contenu de la page N° 4
Basic Operations Playing a CD 3 1, 2 Connect the supplied mains lead (see page 23). 1 Press ZPUSH OPEN/CLOSE down to open the CD compartment and place the CD on the CD compartment. With the label side up 2 Close the lid of the CD compartment. 3 Press u. Display The player turns on (direct power-on) and plays all the tracks once. Track number Playing time GB 4
Résumé du contenu de la page N° 5
Basic Operations Use these buttons for additional operations u x ZPUSH OPEN/CLOSE VOLUME +, – Jog dial OPERATE (or POWER) To Do this adjust the volume Press VOLUME +*, – (VOL +, – on the remote). stop playback Press x. pause playback Press u*. Press the button again to resume play after pause. go to the next track Turn the jog dial clockwise. (On the remote, press >.) go back to the previous track Turn the jog dial counterclockwise. (On the remote, press ..) remove the CD Press ZPUSH OPEN/CLOSE.
Résumé du contenu de la page N° 6
Listening to the radio 12 Connect the supplied mains lead (see page 23). Display 1 Press RADIO•BAND•AUTO PRESET until the band you want appears in the display (direct power- on). Each time you press the button, the band changes as follows: CFD-E90: “FM” t “AM” CFD-E90L: “FM” t “MW” t “LW” 2 Hold down TUNE + or TUNE – until Indicates an FM stereo broadcast the frequency digits begin to change in the display. The player automatically scans the radio frequencies and stops when it finds a clear stat
Résumé du contenu de la page N° 7
Basic Operations Use these buttons for additional operations OPERATE (or POWER) MODE VOLUME +, – Tips To Press • If the FM broadcast is adjust the volume VOLUME +*, – noisy, press MODE until (VOL +, – on the remote) “Mono” appears in the display and the radio will turn on/off the radio OPERATE (or POWER, see page 2) play in monaural. • If you need to change the AM/MW tuning interval, * VOLUME + has a tactile dot. see page 24. To improve broadcast reception Reorient the aerial for FM. Reorient th
Résumé du contenu de la page N° 8
Playing a tape 1 2 Connect the supplied mains lead (see page 23). 1 Press xZ to open the tape With the side you want to play facing you compartment and insert a recorded tape. Use TYPE I (normal) tape only. Close the compartment. Display 2 Press n. The player turns on (direct power-on) and starts playing. GB 8
Résumé du contenu de la page N° 9
Basic Operations Use these buttons for additional operations OPERATE (or POWER) VOLUME +, – m, M xZ X To Press adjust the volume VOLUME +*, – (VOL +, – on the remote) stop playback xZ fast-forward or rewind the tape m or M pause playback X Press the button again to resume play after pause. eject the cassette xZ turn on/off the player OPERATE (or POWER, see page 2) * VOLUME + and n have a tactile dot. GB 9
Résumé du contenu de la page N° 10
Recording on a tape 1 3 Connect the supplied mains lead (see page 23). With the side you want to 1 Press xZ to open the tape record on facing you compartment and insert a blank tape. Use TYPE I (normal) tape only. 2 Select the programme source you want to record. Display To record from the CD player, insert a CD (see page 4) and press x on the CD section. To record from the radio, tune in the station you want (see page 6). GB 10
Résumé du contenu de la page N° 11
Basic Operations 3 Press z to start recording (n is depressed automatically). Use these buttons for additional operations OPERATE (or POWER) MODE n xZ X Tips To Press • Adjusting the volume or the stop recording xZ audio emphasis (see page 18) will not affect the pause recording X recording level. Press the button again to resume • If the AM/MW/LW recording. programme makes a turn on/off the player OPERATE (or POWER, see page 2) whistling sound after you've pressed z in step 3, press MODE to sel
Résumé du contenu de la page N° 12
The CD Player Using the display Locating a specific point in a track You can check information about the CD using the display. You can quickly find a specific point in a track while playing a CD. DISPLAY m M Checking the total track number and playing time Press DISPLAY in stop mode. Total playing time To locate Press a point while listening to M (forward) or m Total track the sound (backward) while number playing and hold down until you find the point. Checking the remaining time (On the remote
Résumé du contenu de la page N° 13
The CD Player To cancel Repeat Play Press MODE until “REP” disappears from Playing tracks the display. repeatedly (Repeat Play) You can play tracks repeatedly in normal, shuffle or programme play modes (see page 14). Jog dial u x MODE 1 Press x. “Cd” appears in the display. 2 Proceed as follows: To repeat Do this a single track 1 Press MODE until “REP 1” appears. 2 Turn the jog dial to select the track that you want to repeat. 3 Press u. all the tracks 1 Press MODE until “REP ALL” appears. 2 Pre
Résumé du contenu de la page N° 14
Playing tracks in Creating your own random order (Shuffle Play) programme (Programme Play) You can play tracks in random order. You can arrange the playing order of up to 20 tracks on a CD. u x MODE ENTER Jog dial u x MODE 1 Press x. “Cd” appears in the display. 1 Press x. 2 Press MODE until “SHUF” appears in “Cd” appears in the display. the display. 2 Press MODE until “PGM” appears in 3 Press u to start shuffle play. the display. To cancel Shuffle Play 3 Turn the jog dial to select the track yo
Résumé du contenu de la page N° 15
The CD Player To cancel Programme Play Press MODE until “PGM” disappears from the display. To check the order of tracks before play Press ENTER. Every time you press the button, the track number appears in the programmed order. To change the current programme Press x once if the CD is stopped and twice if the CD is playing. The current programme will be erased. Then create a new programme following the programming procedure. Tips • You can play the same programme again, since the programme is sa
Résumé du contenu de la page N° 16
The Radio If a station cannot be preset automatically Presetting radio stations You need to preset a station with a weak signal manually. You can store radio stations into the player’s memory. You can preset up to 30 radio 1 Press RADIO•BAND•AUTO PRESET to stations (CFD-E90), 20 for FM and 10 for select the band. AM in any order or 40 radio stations (CFD- 2 Tune in a station you want. E90L), 20 for FM and 10 for MW and LW in 3 Hold down ENTER for 2 seconds. any order. 4 Select the preset number
Résumé du contenu de la page N° 17
The Radio Playing preset radio stations Once you've preset the stations, use the jog dial on the player or PRESET + , – on the remote to tune in to your favourite stations. RADIO BAND AUTO PRESET Jog dial 1 Press RADIO•BAND•AUTO PRESET to select the band. 2 Turn the jog dial to tune in the stored station. On the remote 1 Press BAND until the band you want appears in the display. 2 Press PRESET + , – to tune in a stored station. GB 17
Résumé du contenu de la page N° 18
The Audio Emphasis Selecting the audio emphasis (MEGA BASS) You can adjust the audio emphasis of the sound you are listening to. MEGA BASS Reinforcing the bass sound Press MEGA BASS. “MEGA BASS” appears in the display. To return to normal sound, press the button again. GB 18
Résumé du contenu de la page N° 19
The Timer The Timer 3 Press ENTER. Setting the clock The clock starts from 00 seconds. “– –:– –” indication appears in the display until you set the clock. Tip CLOCK/SLEEP/TIMER The time display system: CFD-E90: 12-hour system ENTER Jog dial CFD-E90L: 24-hour system Before you set the clock, connect the power source (see page 23). 1 Hold down CLOCK/SLEEP/TIMER until “CLOCK” appears in the display. The hour digit flashes. 2 Turn the jog dial to set the current hour. Then press ENTER. The minute d
Résumé du contenu de la page N° 20
4 Set the timer to the hour and the Waking up to music minutes you want the music to go off. (Do as step 3.) You can wake up to music or a radio programme at a preset time. Make sure you 5 Select the music source (“Cd” or have set the clock (“Setting the clock” on “RAdIO”) by turning the jog dial, then page 19). press ENTER. CLOCK/SLEEP/TIMER 6 Turn the jog dial to set the volume, then STANDBY ENTER Jog dial press ENTER. 7 Press STANDBY. The indication lights up and the power goes off. At the p
