Résumé du contenu de la page N° 1
Shuffle Songs
Backlight
iH3 IB v1.fh10 1/10/07 3:33 PM Page 1
Music
Photos
Extras
Settings
Questions? Visit www.ihomeaudio.com
Résumé du contenu de la page N° 2
iH3 IB v1.fh10 1/10/07 3:33 PM Page 2 Table of Contents Quick Start ........................................................................................................................................................................1 Controls and Indicators / iH3Display .............................................................................................................................2 Using the iH3 ...................................................................................
Résumé du contenu de la page N° 3
line out line out clock a am antenna am time zone time zone DC 15V 1100mA DC 15V 1100mA iH3 IB v1.fh10 1/10/07 3:33 PM Page 3 quick start 1:power 2:antenna 3:inserts Select the dock insert from Attach AC adaptor cable to Snap AM antenna into provided the chart below for your iPod® jack on back of the iH3 and stand, then plug antenna cable model and place insert in dock. plug the other end into a into socket on back of iH3. Never dock an iPod without wall socket. Move antenna 12” away. an ins
Résumé du contenu de la page N° 4
iH3 IB v1.fh10 1/10/07 3:33 PM Page 4 Controls and Indicators AM/FM Select Button Dock Radio Button Sleep Button Volume Wheel Set Wheel iPod Button
iPod radio am/fm sleep volume Alarm On/Off Button alm. on/off alm. set wake-to alm. reset Alarm Set Button power off Alarm Reset/Power Off Button snooze/dimmer Wake-To Button Snooze/Dimmer Button Clock Adjust Button Time Zone Button Line Out Jack DST Switch Line in Jack AC Adaptor Jack DC 15V 1100mA DST line out
Résumé du contenu de la page N° 5
iH3 IB v1.fh10 1/10/07 3:33 PM Page 5 Using the iH3 Connect iH3 to Power Source a) Plug the AC adaptor cable into the AC Adaptor Jack and the other end into a standard 120v wall socket. The iH3 does not operate on batteries. Setting the Clock a) Press and hold the Time Zone Button until the display flashes. b) Turn the Set Wheel to select your time zone. c) Press the Time Zone Button again. The clock will display the current time in your time zone. d) To adjust the time for Daylight Saving
Résumé du contenu de la page N° 6
iH3 IB v1.fh10 1/10/07 3:33 PM Page 6 Using the iH3 Radio Setting up Antennas a) Snap AM loop antenna into provided stand, then plug antenna cable into AM Loop Antenna socket on back of unit. Move antenna 12” away from unit for best reception. b) Extend FM Antenna (on back of unit) fully for best reception. Do not strip, alter or attach to other antennas. Tuning and Playing the Radio a) Press the Radio Button to select radio play mode. b) Press the AM/FM Select Button to select AM or FM
Résumé du contenu de la page N° 7
iH3 IB v1.fh10 1/10/07 3:33 PM Page 7 Replacing iH3 Backup Batteries Install/Replace Backup Battery The iH3 uses a backup battery system to provide continuous alarm operation and clock settings in the event of a power failure. If the Battery Low Icon located on the left of the display is flashing, it is time to replace the backup batteries. Please make sure the AC adaptor is connected, otherwise all settings may be lost during battery replacement. Open the battery compartment cover located on t
Résumé du contenu de la page N° 8
iH3 IB v1.fh10 1/10/07 3:33 PM Page 8 A Consumer Guide to Product Safety When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in these instructions and on the unit. 1. Water a
Résumé du contenu de la page N° 9
iH3 IB v1.fh10 1/10/07 3:33 PM Page 9 Troubleshooting Possible Problem Solution Symptom iH3 does not turn on AC adaptor isn't plugged into a working wall socket Plug the AC adaptor into a working wall socket and plug the or not plugged into the power supply jack on back connector into the supply jack on the unit of the unit iH3 doesn’t respond iH3 requires a reset If unit is plugged in and doesn't respond, try resetting the unit by following these steps: a) remove iPod from dock b) unplug unit
Résumé du contenu de la page N° 10
iH3 IB v1.fh10 1/10/07 3:33 PM Page 10 Troubleshooting Symptom Possible Problem Solution Sound is distorted Volume level is set too high Decrease the volume Sound source is distorted If the iPod original sound source (MP3) is old or of poor quality, distortion and noise are easily noticed with high-power speakers. Try a different audio source such as a music CD. If you are using an external sound source like older generation of iPod or iPod Shuffle, try reducing the output volume on the device
Résumé du contenu de la page N° 11
iH3 IB v1.fh10 1/10/07 3:33 PM Page 11 Solucionando problemas Síntoma Causa Solución El adaptador de corriente AC no está conectado a Conecte el adaptador de corriente a un tomacorriente que funcione La unidad no un tomacorriente que funcione o no está conectado y a la parte posterior de la unidad enciende en la parte posterior de la unidad La unidad no La unidad debe ser reprogramada Si la unidad está conectada y no responde, pruebe reprogramarla responde siguiendo estos pasos: a) Quite el iPo
Résumé du contenu de la page N° 12
iH3 IB v1.fh10 1/10/07 3:33 PM Page 12 Solucionando problemas Síntoma Causa Solución La unidad recalienta Esto es normal Apague la unidad o baje el volumen luego de largos períodos de uso a alto volumen No puede La línea de salida no está diseñada para La señal de salida require amplificación. Utilice parlantes u otra escuuchar los auriculares. Los parlantes necesitan una fuente clase de aparto amplificado. auriculares/parlant de alimentación es que están conectados a la ficha de salida “line o
Résumé du contenu de la page N° 13
iH3 IB v1.fh10 1/10/07 3:33 PM Page 13 Limited 90-Day Warranty Information Home Products, a division of SDI Technologies Inc. (hereafter referred to as SDI Technologies), warrants this product to be free from defects in workmanship and materials, under normal use and conditions, for a period of 90 days from the date of original purchase. Should this product fail to function in a satisfactory manner, it is best to first return it to the store where it was originally purchased. Should this fail t
