Instruction d'utilisation Revolabs Inc.200

Résumé du contenu de la page N° 1

TM
Revolabs Fusion Microphone System — LifeSize Team 200 Setup Guide
This setup guide will guide you through the steps needed to properly connect a
Revolabs Fusion Microphone System to a LifeSize Team 200 video codec.

Note: It is important to carefully follow these instructions in order and completely.
Otherwise your Fusion Microphone System and/or the video codec may not function
properly. Please read through these instructions completely before proceeding.
Contact Revolabs technic

Résumé du contenu de la page N° 2

Connecting the Cables 1. Place the RCA to 1/8” adapters on one end of each RCA cable 2. Connect a RCA audio cable between the RCA “CONF OUT” port on the Fusion and the blue 1/8” “LINE IN” port on the LifeSize Team 200. 3. Connect a RCA audio cable between the RCA “CONF IN” port on the Fusion and the green 1/8” “LINE OUT” port on the LifeSize Team 200. 4. Connect a Male RCA audio cable between the “ROOM OUT” port on the Fusion and the Amplified Speakers. 4 1 1 2 3 3 2 NOTE: You must

Résumé du contenu de la page N° 3

Configuring the LifeSize Team 200 Video Codec 1. Push the BLUE button on the remote control for SYSTEM MENU 2. Select ADMINISTRATOR PREFERENCES and enter password (if necessary) 3. Select AUDIO 4. Select LINE IN (no AEC) 5. Adjust ACTIVE MICROPHONE VOLUME to 10 6. Select VIDEO CALL AUDIO OUTPUT to LINE OUT 7. Select LINE IN TO LINE OUT as DISABLED (if using earlier than v4.0 of LifeSize firmware) 8. Depending on the LifeSize firmware version, either set Line Output to 10 (maximum) or