Résumé du contenu de la page N° 1
™
Installation Guide
®
2075WC Wine Captain
®
and 2075WCOL Wine Captain
with Overlay
www.U-LineService.com
Phone (414) 354-0300 • FAX (414) 354-7905
Service & Parts Tech Lines Phone (800) 779-2547 FAX (414) 354-5696
OnlineService@U-Line.com
©2005 U-Line Corporation
02/2005
Résumé du contenu de la page N° 2
™ ® 2075WC/2075WCOL Wine Captain Contents 1 Follow Safety Precautions Exterior Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Cut-Out Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 IMPORTANT Product Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 PLEASE READ all instructions completely before Door Swing/Clearances Information . . . . . . . . . . . . . . 5 attempting to install or operate the unit. Reversing the Door. . . . . .
Résumé du contenu de la page N° 3
™ ® 2075WC/2075WCOL Wine Captain General Precautions 2 Inspect and Plan Use this appliance for its intended purpose only and follow these general precautions along with those listed You have received a carton containing your 2075WC or throughout this guide: ® 2075WCOL Wine Captain with a package inside containing a User Manual, a Product Registration Card WARNING and an Anti-Tip Bracket Installation Kit. 2075WCOL units are shipped with a cardboard-wrapped door and an SHOCK HAZARD — Electr
Résumé du contenu de la page N° 4
™ ® 2075WC/2075WCOL Wine Captain After all the protective coating has been removed from 3 Prepare Site the unit/door, clean all Stainless Steel surfaces with Claire Stainless Steel Polish and Cleaner or comparable product or a mild detergent and warm water solution and soft Your U-Line product has been designed for either free- cloth. Do NOT use abrasive cleaning agents. standing or built-in installation. When built-in, your unit does not require additional air space for top, sides or rear.
Résumé du contenu de la page N° 5
™ ® 2075WC/2075WCOL Wine Captain Product Dimensions Door Swing/Clearances Information Black, White and Wood Overlay units have a zero 25-3/8" 23-1/4" clearance for the door to open 90° (see Figure 3). Including Including Stainless Steel models require a minimum of 2-1/8" door Handle Handle clearance to accommodate the handle if the unit is installed next to a wall or similar type of structure. Wall Wall 2-1/8" Min. 34-1/8" 34-1/8" 21" 21" 23-15/16" 23-15/16" Black and White Stainless Steel 2
Résumé du contenu de la page N° 6
™ ® 2075WC/2075WCOL Wine Captain 2. Remove plastic screw plugs (3 each, top and bottom) 7. With bottom of door facing up, remove pivot plate from new hinge location. Do not discard (see Figure 6). (2 screws), flip over, and remount on opposite side of door (see Figure 9). Be sure angled side of plate faces center. Screw Plugs Figure 5 Figure 6 Figure 9 3. Remove top hinge (3 screws), reinstall hinge screw pin, 8. Holding door upright with top of door tilted forward, and remount on opposite
Résumé du contenu de la page N° 7
™ ® 2075WC/2075WCOL Wine Captain Side-By-Side Installation 4 Prepare Racks and Door Frame Instructions ® The U-Line Wine Captain is equipped with wood- For a complete refreshment center, install your 2075WC or trimmed wine racks that are coated at the factory with a 2075WCOL unit beside a U-Line Refrigerator, Ice Maker or clear vinyl sealer, which will adequately protect the wood Combo Model (see Figure 11 for typical cut-out). Note in normal usage. A final finish coat was not applied so
Résumé du contenu de la page N° 8
™ ® 2075WC/2075WCOL Wine Captain Staining Wood Trim a Different Overlay Frame Color (2075WCOL Units Only) 1. Remove each wine rack by sliding it out and up. See Frame Preparation Figure 12. An overlay frame covers the door frame to give a built-in 2. Remove and save screws securing wood trim to the appearance. Appropriate hardware and a copy of these racks. instructions will be included in the unit. 3. Apply Minwax Water-Based Wood Stain to wood with a synthetic foam brush. Stain must penet
Résumé du contenu de la page N° 9
™ ® 2075WC/2075WCOL Wine Captain 2. Typical routing dimensions Route notch in top corner of overlay frame as shown 3/4" are shown in Figure 14. (see Top and Side Views). Top of notch is entire depth of frame, front to back. Width: 13/16" 1-1/8" Depth: 1/8" 1-13/16" 2-1/4" Route notch in backside of top corner of overlay frame 11/16" (see Back and Side Views). (Ref.) Width: 13/16" 7/16" (Ref.) Depth: 1/8" Height: 1-17/32" from top edge of frame (less 1/8" for depth of notch on top of frame)
Résumé du contenu de la page N° 10
™ ® 2075WC/2075WCOL Wine Captain Installation Instructions Applying Foam Tape to Overlay Frame (If required) Preparing Door Gasket Note: Door is not attached. It is in a separate box inside the Inside Edge unit box and taped to the unit. 1. Lay door on a clean, flat surface with the gasket facing up. Door 2. Pull gasket completely out of the groove. Start in the Figure 16 middle and pull outward, Incorrect Correct moving toward the edge Figure 18 (see Figure 16). This may take some forc
Résumé du contenu de la page N° 11
™ ® 2075WC/2075WCOL Wine Captain Note: The door frame is designed with a slight amount of Door “play” to square it to the overlay frame. Tape Frame 6. Remove all traces of tape securing overlay frame to door frame. 7. Starting at the corners and working toward the center, push the door gasket back into place. Make sure gasket is seated on all four sides. Installing the Door IMPORTANT Pivot posts must be clean. Closers must also be clean and Overlay greased to ensure proper operation. Frame
Résumé du contenu de la page N° 12
™ ® 2075WC/2075WCOL Wine Captain 5 Adjust Door Checking Door Alignment Slotted Mounting The unit’s door is aligned at the factory before shipment. Holes However, its alignment could have been disturbed during Angled Edge Towards Center shipment or during overlay frame installation. of Door IMPORTANT Properly aligned, the door should be 1/8" below the top of the unit’s cabinet, NOT flush with the top (see Figure 23). Raise Lower Outside Outside Door Edge Door Edge Figure 25 1/8" 3. See Figure
Résumé du contenu de la page N° 13
™ ® 2075WC/2075WCOL Wine Captain 6 Prepare Power Supply 7 Level the Unit Electrical Specifications Leveling Information Note: It is recommended that the unit is level. CAUTION 1. Use a level to check the Check levelness of the Wine Level Electrical installation must observe all state and local ® Captain from front to codes. This unit requires connection to a grounded (three- back and from side to prong), polarized receptacle that has been placed by a side. Level should be qualified electr
Résumé du contenu de la page N° 14
™ ® 2075WC/2075WCOL Wine Captain 8 Install the Unit Anti-Tip Bracket Installation 1. Locate two Anti-Tip Brackets included inside the unit. 2. Place the unit into the area where it will be installed. Check the door, sides and top for a proper fit. Also test to make sure the door opens and closes freely. Line Marks Back Back Wall Front 3. Remove grill and place a mark on the floor at the front of Unit of Unit of the unit. Also place a mark on the floor in the center of the unit. See Figure 30
Résumé du contenu de la page N° 15
™ ® 2075WC/2075WCOL Wine Captain Installation Troubleshooting 9 Start-Up for the First Time Problem Q: Initial Start-Up The door remains open unless it is pushed closed. The unit is shipped with the control preset. No adjustments should be necessary at this time. For information about Solution A: Adjusting the Temperature Control, see the User Manual. The hinges should be self-closing when the door is open approximately 8". If this is not the case, make sure the Start-Up Troubleshooting clos
Résumé du contenu de la page N° 16
™ Who to Call Service Information If the need for service arises, contact the dealer from whom the unit was purchased. State the Model Number and Serial Number and explain the problem. The Model and Serial Number plate is located inside unit at upper right hand corner. If you need to locate a service company, you can go online at www.U-LineService.com and search for a service company by zip code. For more than four decades, U-Line has distinguished itself as the leader in built-in underco