Instruction d'utilisation Stiga 8211-0546-02

Résumé du contenu de la page N° 1

STIGA PARK
2WD
110 Combi Pro
125 Combi Pro
8211-0546-02

Résumé du contenu de la page N° 2

2 1 1 2 3 4 5 6 7 8 C A B 2

Résumé du contenu de la page N° 3

10 9 1/3 12 11 D 14 13 24 Nm 45 Nm 3

Résumé du contenu de la page N° 4

EN ENGLISH 1 GENERAL 2 DESCRIPTION This symbol indicates WARNING. Seri- 2.1 General ous personal injury and/or damage to The cutting deck is intended for use on Stiga’s 2- property may result if the instructions wheel drive Park machines. are not followed carefully. The cutting deck is supplied in one of the follow- You must read these instructions for use ing versions: and the machine’s safety instructions • With manual adjustment of cutting height. carefully. • With electrical adjustment

Résumé du contenu de la page N° 5

EN ENGLISH 3.2 Belt 4.3 Mowing advice The cutting deck’s rear section should rest on the In order to achieve optimum mowing results, fol- floor (it should not be lifted or secured). low the advice below: Install the belt as follows: • Cut frequently. 1. Set the maximum cutting height. • Run the engine at full throttle. 2. Locate the belt around the machine’s belt pulley • The grass should be dry. (8:B). • Use sharp blades. 3. Tension the belt with the belt idler (8:A)B. The • Keep the undersid

Résumé du contenu de la page N° 6

EN ENGLISH 5.3 Service position 5.7 Wear protection 1. Activate the parking brake. There are two wear protection devices on the un- derside of the cutting deck to protect it. These can 2. Set the implement lifter in transport position. be replaced if necessary. 3. Set the highest cutting height. 4. If the deck has electrical cutting height adjust- ment, disconnect the cable from the machine. See fig. 7. 6 SPARE PARTS 5. Remove pins and washers. See fig. 2. 6. Hook the belt idler arm on the mou

Résumé du contenu de la page N° 7

www.stiga.com GGP Sweden AB · Box 1006 · SE-573 28 TRANÅS