Instruction d'utilisation Snapper WALK BEHIND MOWER

Résumé du contenu de la page N° 1

DEALER SET-UP INSTRUCTIONS for SNAPPER
21" REAR DISCHARGE COMMERCIAL WALK BEHIND MOWERS

This SNAPPER Walk Behind Mower uses a handle engine control bail system to kill the engine for the SAFETY
of the operator. These mowers are designed for quick set-up. The checklist on Page 4 should be filled out by
the dealer as the items are checked off and/or performed and the Consumer/Operator Product Registration card
filled out and sent to the Customer Service department at SNAPPER when complete

Résumé du contenu de la page N° 2

IMPORTANT: This mower is shipped with the recycling plug installed. The plug must be removed if the mower is operated with grass catcher. DO NOT start or operate this mower without the plug or the entire grass catcher in place. STEP 9: With grass catcher and catcher frame assembly upside down (plastic bottom turned up), insert bag frame assembly into catcher as shown in Figure 4. Fasten "C" shaped plastic edge strip located on front of bag around frame assembly on all four

Résumé du contenu de la page N° 3

NOTES ___________________________________________________________________ ___________________________________________________________________ ___________________________________________________________________ ___________________________________________________________________ ___________________________________________________________________ ___________________________________________________________________ ___________________________________________________________________ __________

Résumé du contenu de la page N° 4

DEALER PRE-SALE CHECKLIST for SNAPPER 21" REAR DISCHARGE COMMERCIAL WALK BEHIND MOWERS The following must be accomplished prior to sale. Refer to the previous pages in this instruction for detailed set-up instructions. Review this checklist with purchaser. Check ( √ ) items actually performed and signed on checklist. SET-UP CHECKLIST _____ FOAM SHIPPING BLOCK removed from cutting blade. _____ UPPER HANDLE & LOWER HANDLE secured in place and hardware tightened securely. _____ OPERATOR