Instruction d'utilisation Snapper 6-3041

Résumé du contenu de la page N° 1

#6-3041 SNAPPERIZER KIT for
SNAPPER 21" STEEL DECK MOWERS
This kit will install on all 21” Steel Deck: Hi-Vac INSTALLING THE SNAPPERIZER
(Rolled under edge type of deck), “M” prefix and “F”
prefix Series Walk Behind Mowers. This kit will 1. Position the screen on underside and turn it until the
convert your SNAPPER 21" mower into an effective three studs on the screen go through the matching holes
in deck then secure with three split lockwashers and hex
pulverizer of leaves, pine straw, light tw

Résumé du contenu de la page N° 2

#6-3041 SNAPPERIZER KIT 3. Hook the ends of the springs over the tabs on the OPERATING HINTS bottom plate as shown. See Figure 3. After hooking the Before starting the engine, raise the mower deck into springs on the tabs, use pliers to squeeze each hook the highest cutting height (lowest notches) or in position closed over the tab. to allow maximum pulverizing with minimum of grass being cut. Run engine at top speed and low ground CLOSE ENDS WITH PLIERS speed for best results. If leaf build-u