Instruction d'utilisation Scag Power Equipment STT

Résumé du contenu de la page N° 1

OPERATOR’S MANUAL
MODEL STT

 


  


 



   

 
  


 
 
 
 
   
  
  
  
 
  




  
 

     
 
 
  


 

 
 
PART NUMBER 03059

Résumé du contenu de la page N° 2

WARNING:
 
 
       
        
            
        
    
        
 

Résumé du contenu de la page N° 3

Section 1 GENERAL INFORMATION &          1.1 INTRODUCTION             )     
                       ! "#$%%#$&       

Résumé du contenu de la page N° 4

Section 2 SAFETY INFORMATION 2.1 INTRODUCTION
      2    %  *"$;< +,               0       0                             1   

Résumé du contenu de la page N° 5

Section 2 2.3 BEFORE OPERATION '9    $  CONSIDERATIONS (CONT'D)         6            "   '' ?    @    A    /     !       1     1       #       

Résumé du contenu de la page N° 6

Section 2 '8 "      2.4 OPERATION CONSIDERATIONS     (CONT'D) '> %          8 %           1                          > #     '6 

Résumé du contenu de la page N° 7

Section 2 2.6 SAFETY AND INSTRUCTIONAL DECALS WARNING DANGER INSTALL BELT COVER BEFORE SPINNING BLADE OPERATING MACHINE READ OPERATOR'S MANUAL 481039 KEEP CLEAR CONTACT CAN INJURE FORWARD 48071 R F REVERSE WARNING 481568 ROTATING BLADES AND BELTS KEEP HANDS, FEET & CLOTHING CLEAR KEEP ALL GUARDS IN PLACE SHUT OFF ENGINE & DISENGAGE BLADE CLUTCH BEFORE SERVICING IMPORTANT ADJUSTMENT CLEAR AREA OF DEBRIS BEFORE MOWING PROCEDURES USE CAUTION IN DIRECTING DISCHARGE CAUTION KEEP BYSTANDERS, CHILDREN

Résumé du contenu de la page N° 8

Section 3 SPECIFICATIONS 3.1 ENGINE
     
    ! "!#$%&'()& ! "!#%*&$+) ,- ! ".%%'#/!((') 0  ,-.%%'  ,

Résumé du contenu de la page N° 9

Section 3  3.3 TRACTOR (CONT'D)
     ! A        .,  (#'(0        2   (#&0         3.4 CUTTER DECK  A 

Résumé du contenu de la page N° 10

Section 4 7

Résumé du contenu de la page N° 11

Section 4 OPERATING INSTRUCTIONS
    
                CAUTION:  ! Do not attempt to operate this mower unless you have read this manual. Learn the location and      
 "  purpose of all controls and instruments before you    #  operate this mower. $      % # $  

Résumé du contenu de la page N° 12

Section 4 DUMP VALVE  !!  
 '     CONTROL LEVER    +        &   #   '     #             & % #  " #!  
'   &    & '    #   %       ' 

Résumé du contenu de la page N° 13

Section 4 - 8           ; 4.5 GROUND TRAVEL AND STEERING  4 <95 -IMPORTANT- = 8 %   # # 4  





 


 <=5  




 
 



 
 




 9 8 %    






 

Résumé du contenu de la page N° 14

Section 4

     #  #   !


 


    # #    



#     # , %  
 


 

      
 


   # #    
 
#      '    $


Résumé du contenu de la page N° 15

Section 4
 
4.7 HILLSIDE OPERATION $








. 


 



 


 




 WARNING: -      &    DO NOT operate on steep slopes. To check a slope,          attempt to back up it (with the cutter deck down). If the machine can back up the slope without the wheels slipping, reduce speed and use extreme = 8 %  #&

Résumé du contenu de la page N° 16

Section 4 ; +        4.10 REMOVING CLOGGED MATERIAL !            %       ROTATING BLADES > " #    NEVER PUT YOUR HANDS INTO THE DISCHARGE CHUTE FOR ANY REASON! Shut off the engine and <       &   remove the key and only then use a stick or similar @  !$@

Résumé du contenu de la page N° 17

Section 4 LANYARD PIN 4.13 ADJUSTING CUTTING HEIGHT  %&?    7/  >   76-/    #?      E WARNING: Do not adjust the cutting height with the mower blades rotating. Disengage the power to the cutter blades and then adjust cutting height. HEIGHT ADJUSTMENT PEDAL 390S0140 Figure 4-6 Adjusting Cutting Height 7 (     & - $      ?     

Résumé du contenu de la page N° 18

Section 5 TROUBLESHOOTING CUTTING CONDITIONS CAUSE CURE CONDITION Stringers - Occasional
     Blades of Uncut Grass                        Width of Deck ! " SGB020 Streaking - Strips of      Uncut Grass in Cutting Path #

Résumé du contenu de la page N° 19

Section 5 TROUBLESHOOTING (CONT'D) CAUSE CONDITION CURE Uneven Cut on Flat
      Ground - Wavy High-Low !    Appearance,  Scalloped Cut, or Rough Contour        &   '( " %   ) ) *"  !  ) *"       Width of Deck SGB020 U

Résumé du contenu de la page N° 20

Section 5 TROUBLESHOOTING (CONT'D) CAUSE CURE CONDITION Scalping - Blades
    Hitting Dirt or Cutting Very Close to
    the Ground   )     .  %    )   .