Instruction d'utilisation MTD 588Q

Instruction d'utilisation pour le dispositif MTD 588Q

Dispositif: MTD 588Q
Catégorie: Tondeuse
Fabricant: MTD
Dimension: 4.56 MB
Date d'addition: 2/12/2014
Nombre des pages: 16
Imprimez l'instruction

Téléchargez

Comment utiliser?

Notre objectif consiste à vous assurer le plus rapide accès au contenu de l'instruction d'utilisation du dispositif MTD 588Q. En utilisant l'aperçu en ligne vous pouvez parcourir le sommaire et passer à la page où vous trouverez la résolution de votre problème avec MTD 588Q.

Pour votre confort

Si regarder l'instruction MTD 588Q directement sur la page n'est pas confortable pour vous, vous pouvez profiter de deux solutions possibles:

  • Exploration au mode de plein écran - pour analyser l'instruction d'une manière commode (sans l'avoir téléchargée sur votre ordinateur) vous pouvez utiliser le mode d'exploration en plein écran. Pour démarrer l'exploration de l'instruction MTD 588Q en plein écran, utilisez le bouton Plein écran.
  • Téléchargement sur l'ordinateur - vous pouvez aussi télécharger l'instruction MTD 588Q sur votre ordinateur et la sauvegarder dans vos ressources. Si vous n'avez pas envie de gaspiller votre espace disque, vous pouvez toujours télécharger cette instruction du ManualsBase dans l'avenir.
MTD 588Q Manuel d'utilisation - Online PDF
Advertisement
« Page 1 of 16 »
Advertisement
Version imprimée

Beaucoup de gens préfèrent de lire les documents dans la version imprimée et non pas sur l'écran. L'option d'impression de l'instruction est aussi prévue et vous pouvez en profiter en cliquant le lien ci-dessus - Imprimez l'instruction. Il n'est pas nécessaire d'imprimer toute l'instruction MTD 588Q - on peut choisir des pages. Economisez le papier.

Résumés

Vous trouverez ci-dessous les annonces des contenus qui se trouvent sur les pages suivantes de l'instruction de MTD 588Q. Si vous voulez parcourir rapidement le contenu des pages suivantes de l'instruction, vous pouvez en profiter.

Résumés du contenu
Résumé du contenu de la page N° 1

Operator’s Manual
21” Rotary Mower
Model 588Q
Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest-cov-
ered, brush-covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting applicable
local or state laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator. In the State
of California the above is required by law (Section 444

Résumé du contenu de la page N° 2

TABLE OF CONTENTS Content Page Content Page Important Safe Operation Practices 3 Service & Adjustments 11 Slope Gauge 6 Maintaining Your Lawn Mower 12 Assembling Your Lawn Mower 7 Troubleshooting 13 Know Your Lawn Mower 9 Illustrated Parts List 14 Operating Your Lawn Mower 10 Warranty 16 FINDING MODEL NUMBER This Operator’s Manual is an important part of your new lawn mower. It will help you assemble, prepare and maintain the unit for best performance. Please read and understand what it says.

Résumé du contenu de la page N° 3

SECTION 1: IMPORTANT SAFE OPERATION PRACTICES WARNING: This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury. When you see this symbol—HEED ITS WARNING. WARNING: Engine exhaust, some of its constituents, and certain vehicle components

Résumé du contenu de la page N° 4

immediately and the blade will stop rotating within 3. Do not mow on wet grass. Unstable footing could three seconds. cause slipping. 9. Mow in daylight or good artificial light; walk, not run. 10. Stop the blade when crossing gravel drives, Children walkways or roads. Tragic accidents can occur if the operator is not alert to 11. If the equipment should start to vibrate abnormally, the presence of children. Children are often attracted to stop the engine and check immediately for the the

Résumé du contenu de la page N° 5

10. Never over fill fuel tank. Fill tank to no more than ½ 4. Mower blades are sharp and can cut. Wrap the inch below bottom of filler neck to provide space for blade or wear gloves, and use extra caution when fuel expansion. servicing them. 11. Replace gasoline cap and tighten securely. 5. Keep all nuts, bolts, and screws tight to be sure the 12. If gasoline is spilled, wipe it off the engine and equipment is in safe working condition. equipment. Move unit to another area. Wait 5 6. Never ta

Résumé du contenu de la page N° 6

FOLD ON DOTTED LINE, REPRESENTING A 15° SLOPE SIGHT AND HOLD THIS LEVEL WITH A VERTICAL TREE A POWER POLE A CORNER OF A BUILDING OR A FENCE POST 15° WARNING Do not mow on inclines with a slope in excess of 15 degrees (a rise of approximately 2-1/2 feet every 10 feet). A riding mower could overturn and cause serious injury. If operating a walk-behind mower on such a slope, it is extremely difficult to maintain your footing and you could slip, resulting in serious injury. Operate RIDING mowers u

Résumé du contenu de la page N° 7

SECTION 3: ASSEMBLING YOUR LAWN MOWER Removing Unit From Carton  Remove staples, break glue on top flaps, or cut Lower Handle tape at carton end and open carton. Handle  Remove loose parts if included with unit (i.e., Upper Bracket operator’s manual, etc.) Handle  Cut along corners, lay the carton down flat, and remove all packing material.  Roll or slide unit out of carton and check carton thoroughly for loose parts. Loose Parts in Carton Grass Bag  Rear Wheels  Hardware Pack Fi

Résumé du contenu de la page N° 8

 After moving the hairpin clip, insert the carriage  With the spark plug wire disconnected and bolt, from the hardware pack, in the upper hole on grounded, hold the blade control handle against the the handle mounting bracket and secure with upper handle, and pull the rope out of the engine. plastic wing nut from the hardware pack. See  Slip the rope through the rope guide as shown Figure 4. Repeat on the other side. below. Tighten the wing nut holding the rope guide  Fasten the cable t

Résumé du contenu de la page N° 9

IMPORTANT: Make sure cable is routed to the outside of Rear Discharge Door the handle so that it is not in the way when attaching the grass catcher. • Lift the rear discharge door on the mower.  Place the hooks, found on both sides of the grass catcher frame, over the chute door pivot rod at the rear of the mower. Release the rear discharge door. Grass Catcher See Figure 9.  To remove the grass catcher, lift the rear discharge door on the mower, lift the grass catcher up and off the piv

Résumé du contenu de la page N° 10

SECTION 5: OPERATING YOUR LAWN MOWER Recoil WARNING: Read, understand, and follow all Starter instructions and warnings on the machine and in this manual before operating. NOTE: You must service the engine with oil and gasoline before starting the mower for the first time. Check oil and gasoline levels and fill up as necessary Fuel Valve for subsequent starts. Gas & Oil Fill-Up  Check oil level and add oil if necessary. Follow Choke Lever relevant instructions in the engine manual for thi

Résumé du contenu de la page N° 11

Bagging Grass Clippings WARNING: If the mower strikes a foreign You can use the grass catcher bag to collect clippings object, stop the engine. Remove spark plug while you are operating the mower. wire from the spark plug and thoroughly inspect for any damage. Repair the damage promptly  Attach grass catcher following instructions on page before restarting and operating the mower. 8 of this manual. Grass clippings will automatically collect in the bag as you run the mower.  Operate the

Résumé du contenu de la page N° 12

 Attach the new flap and new rod to deck, bending  Remove the blade and the adapter from the the ends of the new rod over to secure to deck. crankshaft. Rear Discharge Door Blade Adapter Handle Bracket Blade Bell Support Handle Hex Bolt Bracket Rear Flap Figure 15 Figure 14 Sharpening the Blade  The blade can be sharpened with a file or on a Blade Care grinding wheel. Do not attempt to sharpen the blade while it is still on the mower. WARNING: When removing the cutting  Follow the orig

Résumé du contenu de la page N° 13

Wheels Off-Season Storage  Lubricate the wheels and bearings, if so equipped, The following steps should be taken to prepare your at least once a season with light oil or engine oil. lawn mower for storage. Also, if the wheels are removed for any reason,  Clean and lubricate mower thoroughly as described lubricate the surface of the pivot arm axle and the in the lubrication instructions. inner surface of the wheel with light oil. IMPORTANT: We do not recommend the use of a Rear Dischar

Résumé du contenu de la page N° 14

SECTION 9: PARTS LIST MODEL 588Q 68 2 1 13 14 12 6 7 11 8 9 10 31 49 22 16 34 19 32 20 64 21 18 24 35 33 45 46 67 15 25 39 23 36 49 69 49 37 43 42 49 40 60 50 59 61 55 40 62 49 57 47 56 58 66 14

Résumé du contenu de la page N° 15

Model 588Q Ref. Ref. Part No. Part Description Part No. Part Description No. No. 1. 749-1092A Upper Handle 687-02031 Handle Bracket Assembly — LH 2. 747-1161A Control Handle 36. 710-1652 TT Screw 1/4-14 x.625 6. 720-0279 Handle Knob 37. 710-0216 Hex Screw 3/8-16 x 0.75 7. 710-1205 Rope Guide 39. 687-02039 Pivot Bar Assembly — RH 8. 710-1174 Carriage Bolt 5/16-18 x 2” 687-02040 Pivot Bar Assembly — LH 9. 736-0451 Shoulder Washer.320 ID x.930 OD 40. 738-0507B Shoulder Screw 10. 720-0284 Wing N

Résumé du contenu de la page N° 16

MANUFACTURER’S LIMITED WARRANTY FOR: The limited warranty set forth below is given by MTD LLC with e. MTD does not extend any warranty for products sold or respect to new merchandise purchased and used in the exported outside of the United States, its possessions United States, its possessions and territories. and territories, except those sold through MTD’s authorized channels of export distribution. “MTD”warrants this product against defects in material and f. Replacement parts that are no


Instructions pareilles
# Instruction d'utilisation Catégorie Téléchargez
1 MTD (111-112-036) Manuel d'utilisation Tondeuse 492
2 MTD (121-942-002) Manuel d'utilisation Tondeuse 90
3 MTD 021 Manuel d'utilisation Tondeuse 57
4 MTD 030 thru 062 Manuel d'utilisation Tondeuse 78
5 MTD 030 Series Manuel d'utilisation Tondeuse 115
6 MTD 020 Manuel d'utilisation Tondeuse 43
7 MTD 020 Series Manuel d'utilisation Tondeuse 36
8 MTD 022 Manuel d'utilisation Tondeuse 41
9 MTD 050 thru 062 Manuel d'utilisation Tondeuse 124
10 MTD 060 Series Manuel d'utilisation Tondeuse 128
11 MTD 070 Thru 088 Manuel d'utilisation Tondeuse 58
12 MTD 08M Manuel d'utilisation Tondeuse 12
13 MTD 080 Thru 099 Manuel d'utilisation Tondeuse 73
14 MTD 100 Series Manuel d'utilisation Tondeuse 150
15 MTD 11-093R000 Manuel d'utilisation Tondeuse 13
16 2Wire 7-1/4 Inch Circular Saw 94245 Manuel d'utilisation Tondeuse 3
17 Agilent Technologies E4371A Manuel d'utilisation Tondeuse 0
18 Agilent Technologies E4370A Manuel d'utilisation Tondeuse 3
19 Agilent Technologies E4374A Manuel d'utilisation Tondeuse 1
20 Adams 22 Manuel d'utilisation Tondeuse 1