Résumé du contenu de la page N° 1
YTH22V46
Owner's Manual
532 43 33-16 Rev. 2
Résumé du contenu de la page N° 2
SAFETY RULES Safe Operation Practices for Ride-On Mowers DANGER: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROW ING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. • Slow down before turning. WARNING: In order to prevent ac ci den tal • Never leave a running machine unattended. Always starting when setting up, trans port ing, turn off blades, set parking brake, stop engine, and ad just ing or making repairs,
Résumé du contenu de la page N° 3
SAFETY RULES Safe Operation Practices for Ride-On Mowers III. CHILDREN Tragic accidents can occur if the operator is not alert to GENERAL SERVICE the presence of children. Children are often attracted to • Never operate machine in a closed area. the ma chine and the mowing activity. Never assume that • Keep all nuts and bolts tight to be sure the equipment children will remain where you last saw them. is in safe working condition. • Keep children out of the mowing area and in the watchful
Résumé du contenu de la page N° 4
PRODUCT SPECIFICATIONS CUSTOMER RESPONSIBILITIES Gasoline Capacity 2.50 Gallons • Read and observe the safety rules. and type: Unleaded Regular • Follow a regular schedule in maintaining, caring for and using your tractor. Oil Type (API-SG-SL): SAE 30 (above 32°F) SAE 5W-30 (below 32°F) • Follow the instructions under “Maintenance” and “Stor- age” sec tions of this own er’s manual. Oil Capacity: w/Filter: 64 oz. w/o Filter: 60 oz. Spark Plug: Champion QC12YC WARNING: This tractor
Résumé du contenu de la page N° 5
UNASSEMBLED PARTS Slope Sheet Key (1) Oil Drain Tube (2) Keys ASSEMBLY Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping purposes. TOOLS REQUIRED FOR ASSEMBLY A socket wrench set will make assembly easier. Stan dard LABEL wrench sizes are listed. (1) 1/2" wrench Tire pressure gauge (2) 7/16" wrenches Utility knife Pliers When right or left hand is mentioned in this man ual, it means when you are in the operating po si tion (se
Résumé du contenu de la page N° 6
ASSEMBLY ✓CHECKLIST NOTE: You may now roll your tractor off the skid. Follow the BEFORE YOU OPERATE YOUR NEW TRAC TOR, WE instructions below to remove the tractor from the skid. WISH TO ASSURE THAT YOU RECEIVE THE BEST PERFORMANCE AND SATISFACTION FROM THIS W ARNING: Before start ing, read, un der stand and fol low QUALITY PRODUCT. all in struc tions in the Op er a tion section of this man u al. Be sure tractor is in a well-ventilated area. Be sure the area in PLEASE REVIEW THE FOLLOWING
Résumé du contenu de la page N° 7
OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their meaning. FAST SLOW REVERSE NEUTRAL HIGH LOW CHOKE IGNITION SWITCH ENGINE ON ENGINE START PARKING BRAKE MOWER HEIGHT MOWER LIFT ENGINE OFF REVERSE OPERATION SYSTEM (ROS) CLUTCH/BRAKE LIGHTS ON BATTERY CRUISE CONTROL FUEL REVERSE FORWARD PEDAL 15 15 ATTACHMENT DANGER, KEEP HANDS ATTACHMENT SLOPE HAZARDS KEEP AREA CLEAR CLUTCH DISENGAGED CLUTCH ENGAGED AND FEET AWAY (SEE SAF
Résumé du contenu de la page N° 8
OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. P H G E B D F A K C M J L Fig. 3 Our tractors conform to the applicable safety standards of the American National Standards Institute. (A) ATTACHMENT LIFT LEVER - Used to raise and lower (H) LIGHT SWITCH - Turns the headlights on an
Résumé du contenu de la page N° 9
OPERATION The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye dam age. Always wear safety glass es or eye shields while operating your tractor or per form ing any ad just ments or repairs. We rec om mend standard safety glasses or a wide vision safety mask worn over spectacles. ENGINE - HOW TO USE YOUR TRAC TOR • Move throttle control (D) between half and full speed (fast) position. TO SET PARKING BRAKE (See Fig. 4) NOTE: Failur
Résumé du contenu de la page N° 10
OPERATION TO USE CRUISE CONTROL (J) (See Fig. 7) TO ADJUST GAUGE WHEELS (See Fig. 9) The cruise control feature can be used for forward travel Gauge wheels are prop er ly ad just ed when they are slight ly only. off the ground when mower is at the desired cutting height in operating position. Gauge wheels then keep the deck in prop- er position to help prevent scalping in most terrain conditions. K NOTE: Adjust gauge wheels with tractor on a flat level surface. • Adjust mower to desired cu
Résumé du contenu de la page N° 11
OPERATION TO TRANSPORT (See Figs. 3 and 11) REVERSE OPERATION SYSTEM (ROS) When pushing or towing your tractor, be sure to disengage Your tractor is equipped with a Reverse Operation System transmission by placing freewheel control in free wheel ing (ROS). Any attempt by the operator to travel in the reverse po si tion. Free wheel control is located at the rear drawbar direction with the attachment clutch engaged will shut off of tractor. the engine unless ignition key is placed in the R
Résumé du contenu de la page N° 12
OPERATION TO START ENGINE (See Fig. 3) BEFORE STARTING THE ENGINE When starting the engine for the first time or if the engine CHECK ENGINE OIL LEVEL has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine. The engine in your tractor has been shipped, from the • Be sure freewheel control is in the transmission en gaged factory, already filled with sum mer weight oil. position. • Check engine oil with tractor on level ground. • Sit on seat in operat
Résumé du contenu de la page N° 13
OPERATION PURGE TRANSMISSION MOWING TIPS • Mower should be properly leveled for best mowing CAUTION: Never engage or disengage performance. See “TO LEVEL MOWER HOUSING” in freewheel lever while the engine is the Service and Adjustments section of this manual. run ning. • The left hand side of mower should be used for trim- ming. • Drive so that clippings are discharged onto the area To ensure proper operation and performance, it is rec om- that has been cut. Have the cut area to the righ
Résumé du contenu de la page N° 14
MAINTENANCE BEFORE EVERY EVERY EVERY EVERY EVERY BEFORE MAINTENANCE EACH 8 25 50 100 SEASON STORAGE SCHEDULE USE HOURS HOURS HOURS HOURS Check Brake Operation Check Tire Pressure T Check Operator Presence & ROS Systems R Check for Loose Fasteners A Check/Replace Mower Blades 3 C T Lubrication Chart 0 Check Battery Level 4 R Clean Battery and Terminals Clean Debris Off Steering Plate 5 Check Transaxle Cooling Check Mower Levelness Check V-Belts Check Engine Oil Level Change Engine Oil (with oil
Résumé du contenu de la page N° 15
MAINTENANCE BLADE CARE TRACTOR For best results mower blades must be kept sharp. Re place Always observe safety rules when per form ing any bent or damaged blades. main te nance. CAUTION: Use only a replacement blade ap- BRAKE OPERATION proved by the manufacturer of your tractor. If tractor requires more than five (5) feet to stop at highest Using a blade not approved by the manu- speed in high est gear on a level, dry concrete or paved facturer of your tractor is hazardous, could surface
Résumé du contenu de la page N° 16
MAINTENANCE OIL DRAIN VALVE V-BELTS Check V-belts for deterioration and wear after 100 hours CLOSED of operation and replace if necessary. The belts are not AND ad just able. Re place belts if they begin to slip from wear. LOCKED POSITION TRANSAXLE COOLING DRAIN The transmission fan and cooling fins should be kept clean YEL LOW CAP TUBE to assure proper cooling. Do not attempt to clean fan or transmission while engine Fig. 16 is running or while the transmission is hot. To prevent pos- •
Résumé du contenu de la page N° 17
MAINTENANCE MUFFLER DECK WASHOUT PORT (See Fig. 19) Inspect and replace corroded muffler and spark arrester (if Your tractor’s deck is equipped with a washout port on equipped) as it could create a fire hazard and/or damage. its surface as part of its deck wash system. It should be utilized after each use. IN-LINE FUEL FILTER (See Fig. 17) 1. Drive the tractor to a level, clear spot on your lawn, near The fuel filter should be replaced once each season. If fuel enough to a water spigot f
Résumé du contenu de la page N° 18
SERVICE AND ADJUSTMENTS WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SER VICE OR AD JUST MENTS: • Depress brake pedal fully and set parking brake. • Place attachment clutch in “DISENGAGED” position. • Turn ignition key to “STOP” and remove key. • Make sure the blades and all moving parts have completely stopped. • Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. IMPORTANT: IF AN ATTACHMENT OTHER THAN THE TO REMOVE MOWER (See Fig.
Résumé du contenu de la page N° 19
SERVICE AND ADJUSTMENTS • ATTACH MOWER SIDE SUSPENSION ARMS (A) TO • Insert end of link (E) into hole in front mower bracket CHASSIS - Position hole in arm over pin (B) on outside and secure with washer and retainer spring (J). of tractor chassis and secure with retainer spring. E • Repeat on opposite side of tractor. A J F H B Fig. 23 • Hook end of clutch cable spring (Q) into hole in idler arm (R). Fig. 21 • Push clutch cable housing guide (P) into bracket, slide • ATTACH REAR LIFT LINKS (C
Résumé du contenu de la page N° 20
SERVICE AND ADJUSTMENTS • If adjustment is necessary, see step in Visual Adjust- TO LEVEL MOWER ment instructions above. Make sure tires are properly inflated to the PSI shown on • Recheck measurements, adjust if necessary until both tires. If tires are over or under inflated, it may affect the sides are equal. appearance of your lawn and lead you to think the mower is not adjusted properly. FRONT-TO-BACK ADJUSTMENT (See Figs. 28 & 29) VISUAL SIDE-TO-SIDE ADJUSTMENT (See Fig. 26) IMPORTANT:
