Résumé du contenu de la page N° 1
MCPN750A CompactPCI
Single Board Computer
Installation and Use
MCPN750A/IH5
September 2001 Edition
Résumé du contenu de la page N° 2
© Copyright 2001 Motorola, Inc. All Rights Reserved. Printed in the United States of America. Motorola and the stylized M logo are registered trademarks of Motorola, Inc. PowerPC is a registered trademark of International Business Machines and is used by Motorola Inc. under license from IBM Corporation. CompactPCI is a registered trademark of PCI Industrial Computer Manufacturers Group. All other product or service names mentioned in this document are trademarks or registered trademarks of the
Résumé du contenu de la page N° 3
Safety Summary The following general safety precautions must be observed during all phases of operation, service, and repair of this equipment. Failure to comply with these precautions or with specific warnings elsewhere in this manual could result in personal injury or damage to the equipment. The safety precautions listed below represent warnings of certain dangers of which Motorola is aware. You, as the user of the product, should follow these warnings and all other safety precautions necessa
Résumé du contenu de la page N° 4
Flammability All Motorola PWBs (printed wiring boards) are manufactured with a flammability rating of 94V-0 by UL-recognized manufacturers. EMI Caution This equipment generates, uses and can radiate electromagnetic energy. It may cause or be susceptible to electromagnetic interference (EMI) if not ! installed and used with adequate EMI protection. Caution Lithium Battery Caution This product contains a lithium battery to power the clock and calendar circuitry. Danger of explosion if battery i
Résumé du contenu de la page N° 5
CE Notice (European Community) This is a Class A product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take ! adequate measures. Warning Motorola Computer Group products with the CE marking comply with the EMC Directive (89/336/EEC). Compliance with this directive implies conformity to the following European Norms: EN55022 “Limits and Methods of Measurement of Radio Interference Characteristics of Information Technology Equi
Résumé du contenu de la page N° 6
Limited and Restricted Rights Legend If the documentation contained herein is supplied, directly or indirectly, to the U.S. Government, the following notice shall apply unless otherwise agreed to in writing by Motorola, Inc. Use, duplication, or disclosure by the Government is subject to restrictions as set forth in subparagraph (b)(3) of the Rights in Technical Data clause at DFARS 252.227-7013 (Nov. 1995) and of the Rights in Noncommercial Computer Software and Documentation clause at DFA
Résumé du contenu de la page N° 7
Contents About This Manual Summary of Changes...............................................................................................xviii Overview of Contents ..............................................................................................xviii Comments and Suggestions .....................................................................................xviii Conventions Used in This Manual.............................................................................xix CHAPT
Résumé du contenu de la page N° 8
CHAPTER 2 Startup and Operation Introduction ............................................................................................................... 2-1 Applying Power......................................................................................................... 2-1 Memory Maps............................................................................................................ 2-3 Processor Memory Map ......................................................................
Résumé du contenu de la page N° 9
CHAPTER 4 CNFG and ENV Commands Overview....................................................................................................................4-1 CNFG - Configure Board Information Block............................................................4-2 ENV - Set Environment .............................................................................................4-3 Configuring the PPCBug Parameters .................................................................4-3 CHAPTER 5 Remo
Résumé du contenu de la page N° 10
ISA DMA Channels .................................................................................. 6-10 Interval Timers .......................................................................................... 6-11 Real-Time Clock/NVRAM/Watchdog Timer Function ................................... 6-11 Replacing Lithium Batteries ..................................................................... 6-12 Hot Swap Control Circuitry ..................................................................
Résumé du contenu de la page N° 11
TMCPN710 Transition Module COM1 Connector (J6)...................................7-19 TMCPN710 Transition Module COM2 Connector (J8)...................................7-20 TMCPN710 Transition Module COM3 Header (J11) ......................................7-20 TMCPN710 Transition Module COM4 Header (J14)......................................7-21 TMCPN710 Transition Module 10BaseT/100BaseTx Connector (J13) ..........7-22 TMCPN710 Transition Module USB Connectors (J10, J12) ........................
Résumé du contenu de la page N° 12
xii
Résumé du contenu de la page N° 13
List of Figures Figure 1-1. MCPN750A Base Board Block Diagram................................................1-2 Figure 1-2. MCPN750A Switches, Headers, Connectors, Fuses, LEDs ...................1-9 Figure 1-3. TMCPN710 Connector and Header Locations .....................................1-12 Figure 1-4. MCPN750A/TMCPN710 Serial Ports 1 and 2 .....................................1-14 Figure 1-5. TMCPN710 Serial Ports 3 and 4...........................................................1-15 Figure 1
Résumé du contenu de la page N° 14
xiv
Résumé du contenu de la page N° 15
List of Tables Table 1-1. Startup Overview ......................................................................................1-3 Table 1-2. Installing a PIM on the TM-PIMC-0001 Transition Module .................1-27 Table 2-1. Processor Default View of the Memory Map ...........................................2-3 Table 2-2. Classes of Reset and Effectiveness.........................................................2-10 Table 3-1. Debugger Commands ............................................
Résumé du contenu de la page N° 16
Table 7-25. PMC I/O Modules 1 and 2 (PIM1 and PIM2) - PMC I/O Connector Pin Assignments..................................................................... 7-36 Table A-1. MCPN750 Specifications ...................................................................... A-1 Table B-1. Motorola Computer Group Documents ................................................. B-1 Table B-2. Manufacturers’ Documents ................................................................... B-2 Table B-3. Related Sp
Résumé du contenu de la page N° 17
About This Manual This manual, MCPN750A CompactPCI Single Board Computer Installation and Use (MCPN750A/IH5) provides general information, hardware preparation and installation instructions, operating instructions, firmware information, functional descriptions, and pin assignments for the MCPN750A family of Single Board Computers. In addition, sufficient information is also provided for the two transition modules manufactured by Motorola for use with the MCPN750A (TMCPN710 and TM-PIMC- 000
Résumé du contenu de la page N° 18
Summary of Changes The following is a list of changes made since the last release of this manual. Date Changes Replaces 09/01 Updated table of model numbers Previously listed model numbers. preceeding this section. Reinserted information left out of IH4 version of manual, which included information on MCPN750A, the TMCPN710 and the TM-PIMC-0001, instead of the earlier MCPN750. Also, included J8 jumper settings for Stand- Alone operation. 07/00 68-pin .08 Series Subminature D PMC I/O 68-pin
Résumé du contenu de la page N° 19
Chapter 4, CNFG and ENV Commands, provides an explanation of two of the more important PPCBug configuration commands: CNFG and ENV. Includes information on how to configure the VMEbus and PCI bus environments using the ENV command. Chapter 5, Remote Start Via the PCI Bus, provides a description of the remote start capability that is available via the PCI bus using PPCBug commands. Chapter 6, Functional Description, provides a description of the major components and functionality of the MCP
Résumé du contenu de la page N° 20
In all your correspondence, please list your name, position, and company. Be sure to include the title and part number of the manual and tell how you used it. Then tell us your feelings about its strengths and weaknesses and any recommendations for improvements. Conventions Used in This Manual The following typographical conventions are used in this document: bold is used for user input that you type just as it appears; it is also used for commands, options and arguments to commands, and nam
