Résumé du contenu de la page N° 1
OWNER’S
INSTRUCTIONS
AW0500
AW0500A
WINDOW-TYPE
ROOM AIR CONDITIONER
( Cool )
E F DB68-00968A(2)
Résumé du contenu de la page N° 2
Safety Precautions The following safety precautions must be taken when using your air conditioner. 1 The unit must be plugged into an independent circuit. The air conditioner must be installed in accordance with national wiring regulations and safety regulations wherever applicable. 2 Some installation locations may require installation of a short circuit breaker or grounding. 3 If the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufa
Résumé du contenu de la page N° 3
Contents PREPARING YOUR AIR CONDITIONER Safety Precautions ......................................................................................... 2 Description of Each Component .................................................................... 4 Getting Started ............................................................................................... 5 OPERATING YOUR AIR CONDITIONER Cooling Your Room .........................................................................
Résumé du contenu de la page N° 4
Description of Each Component Air inlet (Outside) Air outlet Air inlet (Inside) Air Filter (Inside) Ventilation Switch Air flow direction adjustable lever Power plug (Be sure to check the voltage before installation.) Thermostat control Selector E-4
Résumé du contenu de la page N° 5
Getting Started You have just purchased a Samsung window-type room air conditioner which should be installed following your Owner’s Instructions. Your Owner's Instructions contain much valuable information on using your air conditioner. Please take the time to read them as they will help you take full advantage of the unit's features. E-5
Résumé du contenu de la page N° 6
Cooling Your Room You must select the COOL mode if you wish to adjust the: Cooling temperature Fan speed when Cooling 1 Turn the SELECTOR and set it to “ HI COOL ” , “ MED COOL ” or “ LOW COOL ”. Result: The air conditioner starts up in cool mode. N No otte e You can change modes at any time. N No otte e 27˚C~23˚C (81˚F~ 73˚F) 2 Turn the THERMOSTAT control to the desired position. Possible temperatures: Can be set between 18°C(64°F) and 29°C(84°F). Result: The air conditioner starts c
Résumé du contenu de la page N° 7
Ventilating Your Room If the air in your room is stale, you can ventilate the room using the Fan feature. 1 If you wish to discharge stale air, push the ventilation switch on the front of the unit to the right and open position( ). Result: The air inside the room circulates and stale air is discharged outside. Otherwise, push the ventilation switch to the left and closed position( ) . Result: The air simply circulates inside the room. 2 Turn the SELECTOR and set it to “HI FAN” or “L
Résumé du contenu de la page N° 8
Power Failure Here are a few recommendations that you should follow when using your air conditioner. If a power failure occurs, set the SELECTOR to OFF. When the power comes back on, wait five minutes before turning the unit back on. Temperature and Humidity Range The following table indicates the temperature and humidity ranges within which the air conditioner can be used. If the air conditioner is used at... Then... Higher temperature The automatic protection feature may be triggered and the a
Résumé du contenu de la page N° 9
Cleaning Your Air Conditioner Be sure to clean the air filter periodically to maintain the air conditioner in the best condition for a long period of time. When cleaning the air conditioner, turn it off and pull out IMPORTANT the power plug. Hold the air filter handle, pull it slightly forward, and then pull it out to the 1 right side. 2 Remove the dust on the air filter using a vacuum cleaner and brush. 3 Insert the air filter back into its original position. 4 Wipe the surface of the unit with
Résumé du contenu de la page N° 10
Solving Common Problems Before contacting an authorized service center, perform the following simple checks. They may save you the time and the expense of an unnecessary call. Problem Explanation / Solution Check for a power failure. The air conditioner does not operate at all. Check the voltage. (See the technical specifications) Check the power plug for disconnection. Check to see whether the SELECTOR is placed in the "OFF" position. (Set it to the desired position.) Check to se
Résumé du contenu de la page N° 11
Technical Specifications Model Power Supply Cooling Capacity(BTU/h) AW0500 5000 115V~, 60Hz AW0500A Design and specifications are subject to change without notice. E-11
Résumé du contenu de la page N° 12
Installation Before installation, please read the INSTALLATION instructions, then follow the procedures in order after considering the installation area and drain hose. C CA AU UT TIIO ON N ♦ The manufacturer does not assume responsibility for accident or injury caused by an incorrectly installed air conditioner. If you are unsure about installation, contact an installation specialist. Checkpoints prior to installation 1 Check the cabinet and front grille of the unit for any defects such as scr
Résumé du contenu de la page N° 13
Window installation Tools needed Philips head screwdriver Ruler or tape measure Adjustable wrench Pencil Scissors Parts furnished Type Name of part Q’ty Type Name of part Q’ty Type Name of part Q’ty Long wood screw (5X16) Top support channel Window filler panel(Right) A 7 D 1 G 1 Screw (4X10) Adhesive seal strip Window filler panel(Left) B 9 E 1 H 1 Window bracket Window gasket C 2 F 1 1 Install the top support channel with three Type B screws provided. Top support channel
Résumé du contenu de la page N° 14
Installation (Cont.) 4 Attach the seal strip to the window. 4-1 Cut the adhesive-backed foam seal strip gasket to the window width. 4-2 Remove the backing from the seal strip and attach the strip to the underside of the bottom window. Install the drain plug. (The unit does not require any separate drain system. 5 Rear However, a separate drain plug can be installed if needed.) Rubber Cap Cooling capacity Noise Drain system installed Decreased Decreased Without drain system installed Incre
Résumé du contenu de la page N° 15
7 Extend the window filler panels. Type “A” screws 7-1 Secure the window brackets to the stool using the Type A screw at each side. 7-2 Secure the top mounting channel to the bottom sash with the Type A screw in the center. 7-3 Extend the window filler panels into the window sash tracks on both sides. When the window is pulled down, the window should rest on the unit just behind the window filler panel frames. 7-4 Slide the window filler panels outward until they touch the sides Window bracke
Résumé du contenu de la page N° 16
Installation (Cont.) Removal of the Front Grille If you need to remove the front grille for replacement, follow the steps below. 1 Hold the air filter handle, pull it slightly forward, and then pull it out to the right side. N N N No o o otttte e e e Remove the shipping tape before pulling out the air filter, if necessary. Remove the screw below the control panel that holds the grille in place. 2 Remove two knobs on the lower right hand section by pulling them forward. 3 Disassemble the front
Résumé du contenu de la page N° 17
Memo E-17
Résumé du contenu de la page N° 18
YOUR SAMSUNG ROOM AIR CONDITIONER WARRANTY Limited Warranty to Original Purchaser Samsung will repair or replace, at our option, this product if found defective within the warranty period beginning from the original date of purchase. This Samsung Product is warranted by SAMSUNG ELECTRONICS CANADA Inc. against manufacturing defects in materials or workmanship for the period specified. Labor Parts 1 Year (Carry in) 1 Year Limited 5-Years Compressor Warranty Within one year of purchase Samsung Ele
