Résumé du contenu de la page N° 1
4-Cycle
Engine
OPERATOR’S MANUAL
Horizontal Crankshaft • Air-Cooled
For your convenience, enter
your engine model, spec
LH195SA/LH195SP (HSSK40-55)
and DOM numbers here.
LH318SA/LH358SA (HMSK80-110)
ENGINE
OH195SA/OH195SP (OHSK50-75) MODEL:
SPEC:
OH318SA/OH358SA (OHSK80-130)
DOM:
Visit our website at
www.TecumsehPower.com
Maintain Your
• Register your
TecumsehPower
Engine
ENGINE
• Maintenance Tips
• On-Line Parts
With Genuine
• Locate your nearest
TecumsehPower
TecumsehPower
Servicing De
Résumé du contenu de la page N° 2
Table of Contents Safety Definitions..............................................................................ii I. General Safety Precautions ............................................................. 1 II. How to Get Service .......................................................................... 3 III. Oil and Fuel Specifications............................................................... 4 IV. Before Starting Your Engine...........................................................
Résumé du contenu de la page N° 3
• NEVER fill fuel tank indoors. Fill fuel tank outdoors I. General Safety Precautions in a well-ventilated area. • DO NOT smoke while refueling tank. ! WARNING • Use only an approved red GASOLINE container Read equipment manufacturer’s manual and this to store and dispense fuel. TecumsehPower material thoroughly before using this engine. Failure to Company recommends purchasing gasoline in do so can result in serious injury or death. Consult your containers with a capacity of 2.5 gallons or
Résumé du contenu de la page N° 4
E. DO NOT Modify Engine To avoid serious injury or death, DO NOT modify engine in any way. Tampering with the governor setting can lead to a runaway engine and cause it to operate at unsafe speeds. NEVER tamper with factory setting of engine governor. ! WARNING Use of this engine on fun-carts, go-karts, or mini-bikes can result in serious injury or death. TecumsehPower Company manufactures the Power Sport line of engines for use in such applications. Consult your local Authorized TecumsehPowe
Résumé du contenu de la page N° 5
LOGON! II. How to Get Service 2083 For engine adjustments, repairs or warranty service NOT covered in this manual, contact your nearest Authorized TecumsehPower Servicing Dealer. Find them on our website at www.TecumsehPower.com or call TECUMSEHPOWER COMPANY TecumsehPower Company at 1-800-558-5402 for THIS ENGINE MEETS 1995-2005 CALIF & US EPA additional information. PHI APPLICABLE EMISSION REGULATIONS FOR SI SORE ENGINES EM LV195EA 361540D 04015AA0001 Visitourwebsiteatwww.TecumsehPower.c
Résumé du contenu de la page N° 6
III. Oil and Fuel Specifications Table 1. Recommended Oil A. Oil To operate your engine you need to use a clean, high TecumsehPowerRecommendedOilUsage quality, detergent oil. For recommended engine oil, see StraightGrade Table 1. In addition, you need to be sure the oil sump TecumsehPowerPartNo. contains the correct amount of oil to operate properly. For 730225AorSAE30W recommended oil sump capacity, see Table 2. MultiGrade TecumsehPowerPartNo. 730226AorSAE5W30orSAE10W NOTES TecumsehPower B
Résumé du contenu de la page N° 7
B. Filling Oil Sump OH318SA/OH358SA OH195SA/OH195SP I. Oil Fill Cap/Dipstick If your engine has an oil fill cap/dipstick go to step 1. If your engine does NOT have an oil fill cap/dipstick, see "II. Oil Fill Cap/Plug" instructions below. 1. Be sure engine is upright and level. 2. Unscrew oil fill cap/dipstick from oil filler tube and wipe dipstick clean. See Figures 8 and 9. 3. Screw oil fill cap/dipstick back into oil filler tube. Tighten securely. 4. Unscrew and remove oil fill cap/dipstic
Résumé du contenu de la page N° 8
STOP C. Check the Following Items NOTE Be sure equipment is in neutral before attempting to start (see equipment manufacturer’s instructions). 1. Be sure ignition switch on engine or equipment is in “ON”, “RUN” or “START” position. See Figures 10, 11 and 12. Or Insert ignition key, if present (see equipment Figure 10. Ignition Key manufacturer’s instructions) into ignition key slot in carburetor cover. DO NOT turn ignition key. Be sure ignition key snaps into place. See Figures 10 and 11.
Résumé du contenu de la page N° 9
6 7 8 9 6 8 7 9 10 12 10 5 5 13 12 4 13 3 3 1 2 1 4 2 OH318SA/OH358SA OH195SA/OH195SP 10 6 8 7 9 6 8 7 9 10 11 11 12 5 5 12 4 3 3 13 4 13 1 1 2 2 LH195SA/LH195SP LH318SA/LH358SA Figure 14. 4-Cycle Snow Engine Components 181-1275-14 4-Cycle • Snow King Engine Page 7
Résumé du contenu de la page N° 10
E. Filling Fuel Tank An adult should fuel this engine. Front View WARNING NEVER allow children to refuel this engine. Gasoline (fuel) vapors are highly flammable and can explode. Fuel vapors can spread and be ignited by a spark or flame many feet away from engine. To prevent injury or death from fuel fires, follow these instructions: 1. Stop engine and allow it to cool before refueling. Bottom View 2. Be sure engine is outdoors and in a well-ventilated area. 3. Clean area around fuel fill
Résumé du contenu de la page N° 11
V. Starting Your Engine To avoid serious injury or death, an WARNING STOP adult should start this engine. Only allow children to start engine if an adult has determined STOP SLOW RUN FAST CHOKE PRIMER they are experienced and capable of such operation. If you are unable to start this engine WARNING after following instructions in this Figure 18. Typical Engine Symbols manual, contact your Authorized TecumsehPower Servicing Dealer. To avoid serious burn injuries or damage to your engine, DO
Résumé du contenu de la page N° 12
A. Engines with Electric Starters If you have a recoil starter, see “B. Engines with Recoil Fuel Tank Starters” instructions on page 13. Some electric starters are equipped WARNING Turn Valve with a 120V AC Three-Wire Power Clockwise To Cord and Plug designed to operate on a 120V AC “OFF” Position household current. It must be properly grounded at all times to avoid the possibility of injury or death from Fuel Valve “OPEN” electrical shock. Position Shown a. Determine if your house wir
Résumé du contenu de la page N° 13
5. Move engine speed control to “FAST” position. See Figures 21 and 22. 6. Set choke control to “FULL CHOKE” position (see STOP equipment manufacturer’s instructions). See Figure 24 on page 12. Afterward, continue reading instructions STOP SLOW RUN FAST CHOKE PRIMER below. 7. Hold the primer bulb in for one full second each time Figure 21. Typical Engine Symbols you press it. See Figure 23. • Make sure you cover vent hole with your thumb. • Repeat twice for a total of three primes. 1. Engi
Résumé du contenu de la page N° 14
STOP STOP STOP 1 LH195SA/LH195SP 2 3 1 STOP 2 3 STOP OH318SA/OH358SA STOP 1 2 STOP 3 OH195SA/OH195SP 1 STOP STOP 2 STOP 3 STOP STOP LH318SA/LH358SA 1. “NO CHOKE” Position 2. “1/2 CHOKE” Position 3. “FULL CHOKE” Position Figure 24. Choke Control Positions Page 12 4-Cycle • Snow King Engine 181-1275-14 STOP STOP STOP
Résumé du contenu de la page N° 15
B. Engines with Recoil Starters If you have an electric starter, see “A. Engines with Electric Fuel Tank Starters” instructions on page 10. DO NOT pull starter rope with engine CAUTION Turn Valve running. Doing so may VOID YOUR Clockwise To WARRANTY. “OFF” Position 1. To avoid carbon monoxide poisoning, be sure engine is outdoors in a well-ventilated area. Fuel Valve “OPEN” Position Shown 2. Be sure fuel valve, if present (see equipment manufac- turer’s instructions) is open and all switc
Résumé du contenu de la page N° 16
When pulling starter rope, the rope WARNING can unexpectedly jerk back toward engine causing serious injury. To avoid this risk, carefully follow these instructions: 7. Grasp starter cord handle. See Figure 29. a. Pull rope out slowly until you feel drag. b. Without allowing the rope to retract, continue pulling rope with one rapid full arm stroke. c. Return rope slowly to original position. NOTES Following the instructions listed in the steps above avoids potential damage to the recoil me
Résumé du contenu de la page N° 17
STOP VI. Stopping Your Engine and Short-Term Storage Stop engine according to equipment manufacturer’s instructions. To avoid unsupervised operation of WARNING an engine, especially by children, NEVER leave it unattended when it is running. Always turn off the engine after use and remove ignition key, if provided. Failure to do so may lead to serious injury or Figure 30. Ignition Key death. NEVER store engine with fuel in the WARNING fuel tank inside a building with potential sources of
Résumé du contenu de la page N° 18
B. After Engine is Stopped To prevent possible freeze-up of engine CAUTION controls, follow instructions with engine 5 STOPPED, listed below. 1. Wipe all snow and moisture from engine control lever 4 and choke areas. 2. Move equipment control, if present (see manufacturer’s instructions), engine control lever or ignition switch 3 back and forth several times and leave control in “STOP” or “OFF” position. See Figure 33. STOP 3. Move engine choke back and forth several times and 2 1 leave in
Résumé du contenu de la page N° 19
VII. Maintenance To avoid serious injury or death, an WARNING adult should perform maintenance on this engine. Only allow children to perform maintenance if an adult has determined they are experienced and capable of such operation. To prevent accidental starting when WARNING working on equipment, always: • Carefully disconnect spark plug wire and keep it away from spark plug. See Figures 35 and 36. • Keep the disconnected spark plug wire securely away from metal parts where arcing Figure
Résumé du contenu de la page N° 20
I. Oil Fill Cap/Dipstick If your engine has an oil fill cap/dipstick go to step 1. If your engine does NOT have an oil fill cap/dipstick, see "II. Oil Fill Cap/Plug" instructions on page 20. 1. Carefully disconnect spark plug wire and keep it away from spark plug. See Figures 38 and 39. See “G. Avoid Accidental Starts” instructions on page 2. Afterward, continue reading instructions below. • Keep the disconnected spark plug wire securely away from metal parts where arcing Figure 38. Disco
