Instruction d'utilisation Toyota 250-3642

Résumé du contenu de la page N° 1

1994 TOYOTA TRUCK WITH 4 CYL. ENGINE
THROTTLE LEVER ADAPTOR PACKAGE
250-3642
1. Remove the throttle shaft nut and lock washer from the throttle shaft. Install
the Throttle Lever Bracket. Reinstall the lock washer and hex nut. NOTE:
Start the nut by hand to prevent cross-threading. Do not over tighten.
2. Install the Snap-in adapter from the cruise control kit onto the cruise control
cable. NOTE: A minimum of 1/8" of the cruise control cable must be exposed
past the end of the snap-in adaptor. Se

Résumé du contenu de la page N° 2

Connect cruise control cable to the throttle lever using bead chain and the 5. eyelet connector from the cruise kit. Secure the eyelet connector to the throttle lever using the two plain washers and self-locking pin provided in the throttle adaptor kit. See Figure 2. Figure 2 6. Insure that the cruise control cable is not holding the throttle open in any way and allows freedom of movement without possibility of binding or hanging up. PRINTED IN THE USA ALL RIGHTS RESERVED