Instruction d'utilisation Packard Bell Compaesseo 400

Résumé du contenu de la page N° 1

Packard Bell
Compasseo 300 & 400
Disassembly Manual

Résumé du contenu de la page N° 2

Table of Contents Overview ................................................................................................................................................ 1 Disassembly Instructions......................................................................................................................... 1 Reassembly Instructions ......................................................................................................................... 1 Required Tools ...............

Résumé du contenu de la page N° 3

1 Overview This document contains step-by-step disassembly instructions for the Packard Bell Compasseo. The instructions are illustrated where necessary with images of the part that is being removed or disassembled. Packard Bell reserves the right to make changes to the product without notice. Disassembly Instructions When disassembling the system unit, follow these general rules: Turn off the power using the battery switch. Disconnect the adapter. Remove the SD or MMC card from the device.

Résumé du contenu de la page N° 4

2 Opening the Case To open the case, do as follows: 1. Remove the two screws at the bottom of the Compasseo. Fig. 1 Bottom of the Compasseo. 2. Remove the four rubbers from the holes at the back. 3. Then remove the four screws from the same holes. 4. Lift and take away the rear cover. Fig. 2 The back of the Compasseo The Speaker Remove the speaker by following the steps below: 1. Disconnect the battery cable from the mainboard. 2. Disconnect the speaker cable from the mainboard (see the square i

Résumé du contenu de la page N° 5

3 3. Remove the two screws that secure the speaker to the antenna holder (see the circles in Fig. 3). Fig. 3 Speaker screws and cable connector. The Antenna Perform the following steps to remove the antenna: 1. Disconnect the GPS antenna from the Mainboard (see the circle to your right in Fig. 4). 2. Slide the GPS antenna upwards out of its holder. Fig. 4 The GPS antenna and cable connector. The Antenna Holder To remove the antenna holder, follow the steps below: 1. Remove the screw that secures

Résumé du contenu de la page N° 6

4 2. Lift the antenna holder from the mainboard. Fig. 5 The screw that keeps the antenna holder in place. The GPS Module Follow these steps to remove the GPS module: 1. Disconnect the GPS cable from the Mainboard (see the square in Fig. 6). 2. Remove the two screws of the GPS module (See the circles in Fig. 6). 3. Lift the module from the mainboard. 4. Disconnect the cable from the GPS module. Fig. 6 The GPS module, cable connector and screws.

Résumé du contenu de la page N° 7

5 The Mainboard Follow the steps below to remove the mainboard: 1. Unlock the flat cable lock upwards (see the square in Fig. 7). 2. Take the flat cable out of the connector. 3. Lift the mainboard from the casing. Fig. 7 The flat cable socket on the mainboard The LCD Panel Follow the steps below to remove the LCD panel: 1. Slightly bend the two clips that hold the LCD panel (see the circles in Fig. 8). 2. Take out the LCD panel. Fig. 8 LCD panel and front cover.

Résumé du contenu de la page N° 8

6 Notice The information in this document is subject to change without notice. This document contains information protected by copyright. No part of this document may be photocopied or reproduced in any form or by any means without prior written consent from Packard Bell B.V. PACKARD BELL B.V. SHALL NOT BE HELD LIABLE FOR TECHNICAL OR EDITORIAL ERRORS OR OMISSIONS CONTAINED HEREIN; NOR FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE FURNISHING, PERFORMANCE, OR USE OF THIS MATERIAL. Co