Résumé du contenu de la page N° 1
Any Surface
24 inches
(61 cm)
24 inches
(61 cm)
Any Surface
®
SUMMIT
PLATINUM D4 / D6
BUILT-IN NG GAS GRILL INSTALLATION GUIDE
THIS GAS APPLIANCE IS DESIGNED
FOR OUTDOOR USE ONLY.
42370
LOCATING YOUR GRILL
®
When determining a suitable location for your Summit gas grill installation, give attention to concerns such as exposure to wind, proximity to traffi c paths, and
®
keeping any gas supply lines as short as possible. Never locate the Summit gas grill in a garage, breezeway, shed, under
Résumé du contenu de la page N° 2
2 BUILT-IN CUTOUT DIMENSIONS GENERAL CONSTRUCTION DETAILS 1 ® Summit Built-In unit and all other accessory units should be on site before construction begins. All dimensions have a tolerance of plus or minus (+/-) / 4 inch.The grill frame rests directly on the Island Structure top fi nished surface. Make sure this surface is level. Do not support the grill from the bottom. If the supporting structure is going to have an electrical outlet for a rotisserie, it should be on the left side of the st
Résumé du contenu de la page N° 3
3 PARTS LIST 4B Left Door - 1 Lid - 1 Right Door - 1 Cookbox - 1 Warming Rack - 1 ™ Warm-Up Rack - 1 OR 6B Lid - 1 Right Enclosure Panel - 1 Cookbox - 1 Left Enclosure Panel - 1 Front Frame Rail - 1 Rear Frame Rail - 1 Front Vent Panel - 1 Rear Panel Assembly- 1 Rear Vent - 1 Bottom Shelf - 1 42370_NG BIinstll.indd 3 9/23/05 11:08:17 AM
Résumé du contenu de la page N° 4
4 PARTS LIST (CONTINUED) Wrench - 1 ® Flavorizor Bars - 2 Sets x10 Sheet Metal Screws - 3 Plastic Anchors - 3 Stainless Steel Cooking Grates - 2 4B 1/2 inch Bolts (1/4 x 20 x 1/2 inch Bolt) - 8 6B - 3 #10-32 x 1/4 inch Steel Screws - 5 Bottom Tray - 1 Nylon Washer - 8 1/2" Flare Gasket - 2 Catch-Pan Holder - 1 3/8" Flare Gasket - 2 Catch-Pan - 1 Handle - 2 Disposable Drip Pans - 2 Handle Hardware - 4 Rotisserie - 1 Hinge Pin- 2 Hair Pin Cotter- 2 Rotisserie Motor - 1 Corrugated gas line
Résumé du contenu de la page N° 5
5 EXPLODED VIEW - PLATINUM D4 ® 5340501 - Summit Platinum D4 NG Built-In 091905 1 2 3 38 39 4 40 5 41 42 6 43 7 44 45 8 46 9 47 10 48 11 49 50 51 12 52 13 53 14 54 15 55 16 56 17 18 57 19 58 20 21 59 22 23 60 24 61 25 26 27 62 63 64 65 66 28 67 29 68 30 69 31 70 32 71 33 72 34 73 35 74 75 36 76 37 77 42370_NG BIinstll.indd 5 9/23/05 11:08:23 AM
Résumé du contenu de la page N° 6
6 EXPLODED VIEW LIST - PLATINUM D4 1. Hinge Pin 39. Lid Assembly 2. Thermometer Hardware 40. 1/4 - 20 x 1 1/4 inch Bolt 3. Thermometer Bezel 41. IR Rain Cover Hardware ™ 4. Warm-Up Basket 42. 12 inch Cook Grate 5. Smoker Assembly 43. IR Rain Cover ® 6. Flavorizer Bar Assembly w/ Smoker 44. 10 - 24 x 1/2 inch Stainless Steel Screw ® 7. Smoker Box Chip Grate 45. Right Flavorizer Bar Assembly 8. Rotisserie Motor 46. IR Burner 9. Motor Bracket 47. IR Cover Box 10. Motor Bracket Screw 48. Warming R
Résumé du contenu de la page N° 7
7 EXPLODED VIEW - PLATINUM D6 ® 5390501 - Summit Platinum D6 NG Built-In 092005 1 2 3 42 4 5 43 6 7 44 45 46 8 47 48 9 49 50 10 51 11 52 12 13 53 54 55 14 56 15 16 57 17 58 18 19 59 20 60 21 22 61 23 24 25 26 27 62 28 29 63 30 64 65 66 67 68 69 31 70 32 71 33 72 34 35 73 36 74 37 75 38 76 39 77 40 78 41 79 42370_NG BIinstll.indd 7 9/23/05 11:08:24 AM
Résumé du contenu de la page N° 8
8 EXPLODED VIEW LIST - PLATINUM D6 1. Hinge Pin 40. Left Door Assembly 2. Thermometer Hardware 41. Right Door Assembly 3. Thermometer Bezel 42. Hair Pin Cotter ™ 4. Warm-Up Basket 43. Lid Assembly 5. 8 inch Cooking Grate 44. 1/4 - 20 x 1 1/4 inch Bolt 6. Smoker Assembly 45. 12 inch Cook Grate 7. Smoker Box Chip Grate 46. IR Rain Cover Hardware ® ® 8. Flavorizer Bar Assembly w/ Smoker 47. Right Flavorizer Bar Assembly 9. Rotisserie Fork 48. IR Rain Cover 10. Rotisserie Motor 49. 10 - 24 x 1/2
Résumé du contenu de la page N° 9
9 ASSEMBLY 2 1 1 2 1 Arrow stickers on Frame Rail (1) and Left Side Panel (2) should point toward each other (shown above). Door Stop Bracket (3) should be positioned as 3 shown (left). 2 ATTENTION! Do not fully tighten screws. Clips should slide freely when installed 42370_NG BIinstll.indd 9 9/23/05 11:08:25 AM
Résumé du contenu de la page N° 10
10 ASSEMBLY 3 4 42370_NG BIinstll.indd 10 9/23/05 11:08:26 AM
Résumé du contenu de la page N° 11
11 ASSEMBLY 5 42370_NG BIinstll.indd 11 9/23/05 11:08:27 AM
Résumé du contenu de la page N° 12
24 inches 24 inches (610mm) (610mm) 12 ASSEMBLY ® CAUTION: Use two people to lift and install the Summit Built-In frame assembly. a.) Lift the frame assembly into the “island” structure opening. Make sure the frame is resting level on the fi nished surface of the structure. 6 b.) Adjust the Front Vent to rest squarely on ground. c.) Apply a bead of silicone sealant (1) around the perimeter and front edges of the grill that are in contact with the “island” structure. This will prevent moistur
Résumé du contenu de la page N° 13
13 ASSEMBLY 7 4B 6B (1) (2) (3) 42370_NG BIinstll.indd 13 9/23/05 11:08:28 AM
Résumé du contenu de la page N° 14
14 ASSEMBLY 8 4B 6B (1) (2) 42370_NG BIinstll.indd 14 9/23/05 11:08:28 AM
Résumé du contenu de la page N° 15
15 ASSEMBLY 4B 6B 9 a b Match Holder c 42370_NG BIinstll.indd 15 9/23/05 11:08:29 AM
Résumé du contenu de la page N° 16
16 ASSEMBLY 10 1/4" Drill Bit 11 42370_NG BIinstll.indd 16 9/23/05 11:08:32 AM
Résumé du contenu de la page N° 17
17 ASSEMBLY 12 13 14 15 42370_NG BIinstll.indd 17 9/23/05 11:08:32 AM
Résumé du contenu de la page N° 18
18 GAS SUPPLY TYPICAL NATURAL GAS SUPPLY INSTALLATION BUILT-IN GAS LINE LOCATIONS Note: Leave an access in the “island” structure for gas supply and regulator We recommend that this installation be done by a LICENSED professional. ® service that is not inside the grill structure. Weber has a gas line and regulator access door (part # 36311) available from your dealer or call Customer Service at 1-800-446-1071. GENERAL SPECIFICATIONS FOR PIPING Note: Area should be kept clear of sharp, jagged,
Résumé du contenu de la page N° 19
19 GAS SUPPLY GAS LINE PIPING CONNECT GAS SUPPLY Refer to the piping chart at the bottom of previous page. A 58 inch corrugated gas line is supplied with the grill. This line needs to pass The corrugated gas line from the manifold is 58 inches long. Do not through the gas inlet opening to the main gas supply. extend the gas line. We have provided the means to make an SAE 45° fl are connection. Do 1) Connect the corrugated gas line to the regulator (a). Use the 1/2” fl ared not use pipe
Résumé du contenu de la page N° 20
20 GAS SUPPLY 4) Connect the corrugated gas line to the manifold located on the right hand side of grill under the control panel. Use the 1/2” fl ared gasket (1) to ensure proper seal. Note: Leave an access in the “island” structure for gas supply and regulator ® service not inside the grill structure. Weber has a gas line and regulator access door (part # 36311) available from your dealer or call Customer Service at 1-800-446-1071. OR Right Side Left Side Front View (1) top view Note: Th
