Résumé du contenu de la page N° 1
R
E
B
E
W
Owners Guide
DANGER
If you smell gas:
1. Shut off gas to the appliance.
Natural Gas
2. Extinguish any open flames.
3. Open lid
4. If odor continues, keep away from the
appliance and immediately call your
®®
gas supplier or your fire department.
Leaking gas may cause a fire or explosion
which can cause serious bodily injury or
death, or damage to property.
WARNING
Do not store or use gasoline or other
flammable liquids or vapors within 25 feet
(8m) of this appliance.
WARNING: Foll
Résumé du contenu de la page N° 2
DANGER Failure to follow the Dangers, Warnings and Cautions contained in this Owner’s Manual may result in serious bodily injury or death, or in a fire or an explosion causing damage to property. WARNINGS Do not store a spare or disconnected liquid propane cylinder under or near this barbecue. Improper assembly may be dangerous. Please carefully follow the assembly instructions in this manual. After a period of storage, and/or nonuse, the Weber Gas Barbecue should be checked for gas le
Résumé du contenu de la page N° 3
Warranty Weber-Stephen Products Co. (Weber) hereby warrants There are no other express warrants except as set forth to the ORIGINAL PURCHASER of this Weber Gas Grill herein and any applicable implied warranties of that it will be free of defects in material and merchantability and fitness are limited in duration to the workmanship from the date of purchase as follows: period of coverage of this express written Limited Warranty. Some regions do not allow limitation on how Aluminum Castings, life
Résumé du contenu de la page N° 4
Contents Danger & Warnings ................................ A-2 Warranty ................................................. A-3 General Instructions ............................... A-5 Exploded View ....................................... A-6 Parts List ................................................ A-9 Assembly Instructions ............................ B-1 Installing Features .................................. C-1 Operating ............................................... D-1 Lighting..........
Résumé du contenu de la page N° 5
Storage General Instructions • The gas must be turned OFF at the natural gas Your Weber Gas Barbecue is a portable outdoor supply when the Weber Gas Barbecue is not in cooking appliance. With the Weber Gas Barbecue you use. can grill, barbecue, roast and bake with results that are • When the Weber Gas Barbecue is stored indoors, difficult to duplicate with indoor kitchen appliances. the gas supply must be disconnected. The closed lid and Flavorizer® Bars produce that “outdoor” flavor in the food
Résumé du contenu de la page N° 6
Genesis Silver-B NG 011901 1 2 26 3 27 4 28 5 6 7 29 8 30 31 32 9 33 34 35 10 11 36 12 37 13 38 14 39 15 40 16 41 32 17 42 43 18 44 19 20 45 21 22 46 23 24 47 25 A-6
Résumé du contenu de la page N° 7
1. Hinge Pin 26. Hair Pin Cotter 2. Left Endcap 27. Thermometer 3. Shroud 28. Right Endcap 4. Handle 29. Burner Control Knobs 5. Warm-Up Basket 30. Control Panel 6. Warming Rack 31. Ignitor Button 7. Cooking Grates 32. Control Panel Hardware 8. Flavorizer Bars 33. Crossover tube 9. Cooking Box 34. Front and Back Burners 10. 1/4-20 keps nut 35. Center Burner 11. Slide Out Bottom Tray 36. Manifold Hardware 12. Catch pan holder 37. Manifold 13. Left Trim Piece 38. Catch Pan 14. Work Surface 39. Dis
Résumé du contenu de la page N° 8
© 1999 Weber-Stephen Products Co., Weber, the silhouette, and the kettle configuration are registered trademarks ® of Weber-Stephen Products Co., 200 East Daniels Road, Palatine, IL, 60067-6266, U.S.A. This product is covered by one or more United States patents and patents in other nations globally. Printed in the U.S.A. A-8
Résumé du contenu de la page N° 9
® ® ® ® ® Screwdriver Left Frame - 1 Phillips screwdriver Hammer Right Frame -1 7/16 open-end or an adjustable wrench Wheel Frame - 1 Pliers Caster Frame - 1 Block of wood Lid -1 Frame Connectors - 2 Left Trim Piece - 1 Right Trim Piece - 1 Cooking Box - 1 Work Surface - 1 Swing-Up Work Surface - 1 Cooking grates - 2 Hinge Rod - 1 Bottom Shelf - 1 Control panel - 1 A-9
Résumé du contenu de la page N° 10
Warming Rack - 1 Burner Control Knobs - 3 Warm-Up Basket - 1 Hinge Pins (1/4 x 1 1/2 inch clevis pin) - 2 2 inch bolts (1/4 x 20 x 2 inch bolts) - 5 Flavorizer Bars - 5 1/2 inch bolts (1/4 x 20 x 1/2 inch bolts) - 8 Wrap-Around Trim Piece - 1 Keps Nut (1/4 x 20 Keps Nut) - 1 Bottom tray - 1 Nylon Washers - 15 Cotter Pin - 2 Catch Pan Holder - 1 Hubcaps - 3 Catch-Pan -1 Control Panel Hardware (Phillips screws/washers) - 2 Disposable Drip Pans - 2 Axle Rod - 1 Thermometer -1 Casters - 2 Wheels - 2
Résumé du contenu de la page N° 11
Addendum Sheet You may have a different style manifold bracket and Spider Stopper Guard listed in your instruction manual. If you do, please follow these steps below in place of the steps included in the manual. Assembly Instructions * See Section B * Install manifold bracket You will need: manifold bracket Hook the bracket(2) onto the manifold at the center * See Section A * burner valve. Place your hand underneath the bracket. Lift the manifold and cooking box slightly, then hook the tab of th
Résumé du contenu de la page N° 12
1) The smell of gas in conjunction with the burner flames the crossover tube(1) from the burners. Remove the appearing yellow and lazy. burners from the cooking box. 2) Barbecue does not reach temperature. 3) Barbecue heats unevenly. (1) 4) One or more of the burners do not ignite. DANGER Failure to correct the above mentioned symptoms may result in a fire, which can cause serious bodily injury or death, and cause damage to property. 8) To reinstall the burners, reverse 3) through 7). Replacin
Résumé du contenu de la page N° 13
R E B E W Assembly Instructions Assemble wheel frame Assemble frame You will need: axle rod, two wheel hubcaps, two You will need: left frame, right frame, two 1/2 inch wheels, wheel frame, hammer and a block of wood. bolts, two nylon washers and a 7/16 inch or adjustable Place one end of the axle rod on the block of wood (or wrench. other protected surface). Tap one hubcap onto the end Note - Work on carpeted area (on grass or one of the of the axle rod. Slide one wheel onto the axle, WEBER box
Résumé du contenu de la page N° 14
Continue frame assembly Complete frame assembly You will need: caster frame, wheel frame, four 1/2 inch You will need: partial frame assembly, two frame bolts, four nylon washers and a 7/16 inch or adjustable connectors, four 2 inch bolts, four nylon wrench. washers and a 7/16 inch or adjustable wrench. Place the caster frame onto the tabs of the left frame, Hold one frame connector between the caster frame so that the swing table locking latch(1) is to the rear. and wheel frame. Add the nylon w
Résumé du contenu de la page N° 15
Insert casters Add Wrap-around Frame Panel You will need: frame assembly and two casters. You will need: wrap around frame panel and a wrench. Push the casters firmly into the inserts in the ends of Place wrap-around frame panel in place: the caster frame. 1) The cut-out tabs should fit between the washer and the frame, as shown. 2) The square cut-out holes fit around the white plugs in the frame as shown Tighten Bolts with wrench. Turn the frame over and continue with assembly. (1) (2) B-3
Résumé du contenu de la page N° 16
Add cooking box (assembly) Your Weber Gas Grill Manifold assembly consisting of You will need: frame assembly, cooking box gas manifold, valves and gas burners has been factory (assembly), 2 inch bolt, nylon washer, keps nut, pliers assembled, pressure- and flame- tested. As a safety and a 7/16 inch or adjustable wrench. precaution, we recommend you check the burner Place the cooking box (assembly) in the frame alignment: assembly so the burner tubes(1) are under the frame 1) Are the ends of the
Résumé du contenu de la page N° 17
Install manifold brackets Install igniter The manifold brackets(2) are already in place on the Note - The igniter wires are already attached to the manifold between the valves. Gas Catcher Ignition Chamber and the igniter. This Place your hand underneath the manifold. Lift the was done to factory test the ignition system. manifold and cooking box slightly and hook the The igniter lock nut is on the igniter. manifold bracket(2) onto the frame brace(1). 1) Loosen the igniter lock nut. 2) Insert t
Résumé du contenu de la page N° 18
Install Gas Supply Gas Line Piping General Specifications for Piping If the length of the line required does not exceed 50 Note - Contact your local municipality for building feet, use a 5/8" O.D. tube. One size larger should be codes regulating outdoor gas barbecue used for lengths greater than 50 feet. installations. In absence of Local Codes, you must Gas piping may be copper tubing, type K or L; confirm to the latest edition of ANSI Z223.1. WE polyethylene plastic tube, with a minimum wa
Résumé du contenu de la page N° 19
Check that all burner valves are off Connect flexible hose to manifold You will need: burner control knobs. You will need: the 12 foot natural supply hose and a 3/ Valves are shipped in the OFF position, but you should 4 inch wrench. check to be sure that they are turned OFF. Put the Thread fitting end of hose onto manifold. Tighten with knob on each valve. Check by pushing down and wrench. turning clockwise. If they do not turn, they are off. Proceed to the next step. If they do turn continue t
Résumé du contenu de la page N° 20
Check for gas leaks Check: 1) Hose to manifold connection. DANGER WARNING: If there is a leak a connection(1), Do not use an open flame to check for gas retighten the fitting with a wrench and recheck for leaks. Be sure there are no sparks or open leaks with soap and water solution. flames in the area while you check for If a leak persists after retightening the fitting, turn leaks. Sparks or open flames will result in OFF the gas. DO NOT OPERATE THE BARBECUE. Contact the Customer Service Re
