Résumé du contenu de la page N° 1
Model Number 465630003
Owner’s Manual
Assembly, Operation,
Use and Care
Read and follow all safety
WARNING
statements, assembly
instructions, and use and
Failure to follow all manufacturer’s instructions could
care directions before
result in fire or explosion which could cause property
attempting to assemble
damage, personal injury or death.
and cook.
Installer/assembler:
Leave these instructions
with consumer.
CAUTION
Consumer: Keep this
Some parts may contain sharp edges – especially as
manua
Résumé du contenu de la page N° 2
WARNING FOR YOUR SAFETY 1. Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. 2. An LP tank not connected for use shall not be stored in the vicinity of this or any other appliance. FOR YOUR SAFETY If you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flame. 3. Open lid. 4. If odor continues, immediately call your gas supplier or your fire department. Safety Symbols The symbols and boxes shown below explain what
Résumé du contenu de la page N° 3
LP (Liquefied Petroleum Gas) Is nontoxic, odorless and colorless when produced. For Your Safety, LP gas has been given an odor (similar to rotten cabbage) so that it can be smelled. LP gas is highly flammable and may ignite unexpectedly when mixed with air. CAUTION For residential use only. Do not use for commercial cooking. Call Grill Service Center for Help and Parts If you need help or warranty parts call 1-800-435-5194 U.S., 1-800-387-6057 CAN, or send a FAX to 1-706-576-6355. Business
Résumé du contenu de la page N° 4
Warranty Thermos warrants to the original consumer-purchaser that this product shall be free from defects in workmanship and materials under normal and reasonable use and correct assembly (If assembled by consumer-purchaser) as follows: (1) The aluminized top and bottom for a period of three (3) years from date of purchase; excluding the paint finish; (2) The burner/venturi assembly for a period of three (3) years from date of purchase; (3) The cooler and lifting mechanism for a period of one (1
Résumé du contenu de la page N° 5
TABLE OF CONTENTS For Your Safety.............................................................2 Safety Symbols LP (Liquefied Petroleum Gas).................................................3 Grill Service Center Installation Safety Precautions Warranty Information Warranty ..................................................................4 Table of Contents...........................................................5 Grill Features.............................................................6-7 Pa
Résumé du contenu de la page N° 6
FEATURES Heat indicator Viewing glass Ignitor Bottle opener Level indicator Lift handle Cooler lid Foot pedal Cooler shelf support Pull handle/Cooler shelf 6 Fire & Ice
Résumé du contenu de la page N° 7
FEATURES Tool holders Match lighting stick Cup/can holders Tool set Grease bottle Lift handle Storage net Fire & Ice 7
Résumé du contenu de la page N° 8
PARTS LIST Key Quantity Description Part Number 1 1 Torsion Bar 21-6047-009-200 2 2 Upper Hinge 22-6047-004-200 3 1 Grill Lid 65-6048-018-200 4 2 Side Lid Spacer 13-6047-397-200 5 1 Center Lid Spacer 13-6047-399-200 6 1 Upper Latch 22-6047-040-200 7 1 Handle Assembly 69-6047-246-200 8 1 Heat Shield 21-6047-082-200 9 1 Grate 65-6047-339-200 10 1 Burner 69-6047-029-200 11 1 Collector Box 21-6047-338-200 12 1 Electrode 69-6047-331-200 13 1 Lower Heat Shield 21-6047-023-200 14 1 Side Shelf - Left 69
Résumé du contenu de la page N° 9
PARTS DIAGRAM 2 44 2 4 7 1 3 44 6 5 4 44 8 9 10 11 14 12 13 18 15 16 16 17 15 43 19 20 25 21 26 27 22 23 24 28 Fire & Ice 9
Résumé du contenu de la page N° 10
PARTS DIAGRAM 30 31 29 32 32 33 42 34 35 36 37 38 41 40 39 10 Fire & Ice
Résumé du contenu de la page N° 11
ASSEMBLY To raise grill... PRESS and RELEASE foot pedal on front of cooler. Foot pedal MUST BE RELEASED once the grill begins to rise so that the grill will lock into position. Release Pedal Press Slide cooler lid back to open and lift grill lid to remove packed components. Contents: Side shelves Tools (3) Grease bottle Regulator Wheels/screws Fire & Ice 11
Résumé du contenu de la page N° 12
To lower grill and begin assembly . . . Make DO NOT press sure cooler lid is in the closed position. PRESS center of grill lid. foot pedal and push grill down by pressing on OUTER EDGES of grill lid. RELEASE foot pedal BEFORE grill reaches the cooler so that it will lock into position. IMPORTANT: DO NOT attach gas regulator to grill at this point. Mechanism will not close if regulator is in place. Release Press Slide wheels onto axle. Secure with axle screw into each end of the axle. Axle screw
Résumé du contenu de la page N° 13
Attach grease bottle by sliding bottle bracket over tabs on left side of plinth. Grease bottle Twist 1 lb. LP gas cylinder (sold separately) into regulator. Regulator 1 lb. LP gas cylinder Fire & Ice 13
Résumé du contenu de la page N° 14
PRESS and RELEASE foot pedal on front of cooler. Foot pedal MUST BE RELEASED once the grill begins to rise so that the grill will lock into position. To install regulator/cylinder... 3 1. Push and hold regulator 1 lock to right. 2. Push and hold the gas interlock 2 downward. 3. Insert regulator tube straight into burner tube. 4. Release regulator lock and gas interlock. Regulator lock should spring back to original position to lock regulator in place. NOTE: Gas cylinder and regulator MUST be r
Résumé du contenu de la page N° 15
Attach side shelves by sliding shelf rods into holes on each side of grill. NOTE: Shelf with regulator cut-out attaches to right side. Fire & Ice 15
Résumé du contenu de la page N° 16
The pull handle on your cooler may converted for use as a shelf by utlizing the built-in support in the handle. To use the pull handle as a shelf... 1. Raise pull handle to horizontal position. 2. Lower the support wire (built into handle). 3. Place support wire into slot in cooler body. 2 1 3 16 Fire & Ice
Résumé du contenu de la page N° 17
TABLETOP MODE To remove grill from cooler for tabletop use... Begin with grill in the lowered position. Grasp the plinth on each side (see arrows) and lift grill from cooler. NOTE: Grill should not be removed when grill is in raised position. Do not press pedal when grill is removed. If pedal is accidentally pressed after grill is removed, the grill skirts will raise. If this happens, align and place grill properly back on skirts prior to lowering (see page 12 for lowering instructions). Ben
Résumé du contenu de la page N° 18
To close legs and return grill to cooler... Press legs inward to release from locked position, then fold legs under plinth. NOTE: Regulator and gas cylinder MUST be removed from grill before placing grill onto cooler. Align posts beneath plinth with holes on top of cooler and slide grill downward onto cooler. 18 Fire & Ice
Résumé du contenu de la page N° 19
USE AND CARE Propane Cylinder Use (1 lb. Disposable) Use only cylinder marked “Propane Fuel”. Size should be 4” diameter, 8” height, or 3” diameter, 10” height. Save cylinder cap and reinstall when not in use. Cylinder supply system must be arranged for vapor withdrawal. Gas cylinder must be upright in use. WARNING Use only 1 lb. propane bottles as specified above. Use of other gas bottles could cause gas leak or fire. Leak Testing (1 lb. Disposable) IMPORTANT! During leak test, keep g
Résumé du contenu de la page N° 20
Propane Cylinder Use (20 lb. Refillable) The 20 lb. LP tank used with your grill must meet the following requirements: Purchase LP tanks only with these required measurements:12" (30.5cm) (diameter) x 18" (45.7 cm) (tall) with 20 lb. (9 kg.) capacity maximum. Tank must be constructed and marked in accordance with specifications for LP tank of the U.S. Department of Transportation (DOT) or for Canada, CAN/CSA B-339, cylinders, spheres, and tubes for transportation of dangerous goods, Transpor
