Résumé du contenu de la page N° 1
ASSEMBLY & OPERATING INSTRUCTIONS FOR OUTDOORS
STAINLESS STEEL GAS GRILL
FOR MODEL 720-0025 LP OUTDOOR GRILL
Résumé du contenu de la page N° 2
TABLE OF CONTENTS SECTION ONE: SECTION FIVE: Precaution -------------------------------2-3 Care and Maintenance ---------------------14 Placement of The Grill -----------------3 Troubleshooting ----------------------------15 SECTION TWO: SECTION SIX: Assembly Instructions ----------------4-9 Grill Parts List-------------------------------16-17 SECTION THREE: SECTION SEVEN: Gas Hook-UP & Leak Testing--
Résumé du contenu de la page N° 3
PRECAUTIONS intense heat and can increase accident potential. FOR YOUR SAFETY When using this appliance basic safety practices must If you smell gas: be followed, including the following: 1. Shut off gas to the appliance. 2. Extinguish any open flames. Read this Care and Use Manual carefully and 3. Open lid. completely before using your grill to reduce the risk 4. If odor continues, immediately call your gas of fire, burn hazard or other injury. supplier. Begin by ensuring
Résumé du contenu de la page N° 4
PRECAUTIONS When using the grill, do not touch the grill rack, burner around the grill. The chemical that produces the spraying grate or immediate surrounding area as these areas action could, in the presence of heat, ignite or cause become extremely hot and could cause burns. Use only metal parts to corrode. dry potholders. Moist or damp potholders on hot surfaces may cause burns from steam. Do not use a towel or Do not use the grill for cooking excessively fatty meats bulky cloth in
Résumé du contenu de la page N° 5
Assembly Instructions PLEASE READ THE INSTRUCTIONS CAREFULLY AND FOLLOW STEP BY STEP. TOOLS REQUIRED: Step 1: Assemble casters to bottom panel with ¼”-20x3/4” screws. Casters with brakes should be assembled on the mark “L” side of bottom panel. “L” Step 2: Assemble bottom panel to side panels with 5/32”-32x1/2” screws. 4
Résumé du contenu de la page N° 6
Step 3: Align the holes on the mark “rear panel - b” to the bottom panel. Then, assemble it with 5/32”-32x1/2” screws. Align the holes on the mark “rear panel - a” to the mark “rear panel - b”. Then, assemble it with 5/32”-32x1/2” screws. Finished Step 3: “rear panel – a” “rear panel - b” Step 4: Align the door holes to the side panels as picture shown. Assemble it with ¼”-20”x1/2” screws. 5
Résumé du contenu de la page N° 7
Step 5: Assemble the door handles with 5/32”-32x1/4” screws as picture shown below. Step 6: Remove the upper portion of grill from carton. Insert the upper portion of the grill onto the cart from the top. Insert from the top 6
Résumé du contenu de la page N° 8
Step 7: Assemble side burner with ¼”-20x1/2” screws. Align the holes on the right side of grill housing and screw through the holes in the right side. Tighten into the grill housing as per the diagram below. Then tighten the gas hose to side burner valve. Repeat this step for the left side shelf. Step 8: Assemble push bar with ¼”-20x1/2” screws to the left side shelf. 7
Résumé du contenu de la page N° 9
Step 9: SIDE BURNER GAS HOSE ASSEMBLY The side burner PVC gas hose has attached on the valve manifold inside the grill cart, insert the gas hose to the hole on right panel of the grill, and secure it on the gas hose connector under the side burner as shown in figure below. Step 10: Assemble the rotisserie kit as per the diagram below: First locate the motor bracket on left side of th
Résumé du contenu de la page N° 10
Step 11: TO MATCH LIGHT THE GRILL If the burner will not light after several attempts then the burner can be match lit. If you’ve just attempted to light the burner with the igniter, allow 5 minutes for any accumulated gas to dissipate. Keep your face and hands as far away from the grill as possible. Insert a lit extended match or lighter through the cooking grids to the burner. Press the control knob and rotate left to the HI
Résumé du contenu de la page N° 11
Your gas grill is ready to use. 10
Résumé du contenu de la page N° 12
GAS HOOK-UP NEVER CONNECT AN UNREGULATED GAS SUPPLY L.P. GAS HOOK-UP: LINE TO THE APPLIANCE. USE THE REGULATOR Ensure that the black plastic grommets are in place and ASSEMBLY SUPPLIED. that the hose does not come into contact with the heat shield or the grill head. This is a liquid propane configured grill. Do not attempt to use a natural gas supply unless the grill has been CONNECTION: reconfigured got natural gas use. Orifices for use with L.P. gas come equipped with a high ca
Résumé du contenu de la page N° 13
ALWAYS CHECK FOR LEAKS AFTER TO TEST EVERY L.P. TANK CHANGE Make sure all control valves are in the “OFF” position. Turn the gas supply on. Check all connections from the Check all gas supply fittings for leaks before each use. It L.P. cylinder up to and including the connection to the is handy to keep a spray bottle of soapy water near the manifold pipe assembly (the pipe that goes to the shut-off valve of the gas supply line. Spray all the burner). Soap bubbles will appear wher
Résumé du contenu de la page N° 14
OPERATING INSTRUCTION General use of the grill and rotisserie Each burner is rated at 12,000 Btu/hr. The grill burners Place the food on the grill and cook to the desired encompass the entire cooking area and are side ported to doneness. Adjust heat setting, if necessary. The control minimize blockage from falling grease and debris. knob may be set to any position between “HI” and “LO”. Above the burners are stainless steel radiated. The igniter knobs are located on the lower center
Résumé du contenu de la page N° 15
Résumé du contenu de la page N° 16
sand very lightly with dry 100 grit emery papers in the direction of the grain. Specks of grease can gather on the GRILL BURNERS surfaces of the stainless steel and bake on to the surface Extreme care should be taken when moving a burner as it and give the appearance of rust. For removal use an must be correctly centered on the orifice before any abrasive pad in conjunction with a stainless steel cleaner. attempt is made to relight the grill. Frequency of cleaning will depend on how oft
Résumé du contenu de la page N° 17
CHECKLIST PROBLEMS WHAT TO DO Grill won’t light when the ignition Remove the grill rack and the radiant tray. With a mirror, watch the igniter button is pushed. tip. You should see a spark jump from the tip of the igniter when the button is pressed. You should also hear a repeating click. If there is no spark and no click, replace the battery under the ignition button housing. If you replace the battery and there is still no sparks, can you match light the burner? If the burner l
Résumé du contenu de la page N° 18
Part List ILLUSTRATED PARTS BREAKDOWN Model 720-0025 LP Outdoors Gas Grill 17
Résumé du contenu de la page N° 19
MODEL 720-0025 PARTS LIST REF# DESCRIPTION QTY PART# REF# DESCRIPTION QTY PART# 1 DOUBLE LAYER LID 1PIECE BBQ49001 21 ROTSSERIE KIT 1PIECE BBQ49023 2 THERMOMETRE 1PIECE BBQ49002 22 PUSH BAR, SIDE SHELF 1PIECE BBQ49024 3 LOGO 1PIECE BBQ49003 23 SIDE SHELF 2PIECES BBQ49025 4 HANDLE, FRONT LID 1PIECE BBQ49004 24 RIGHT DOOR W/ CONDIMENT 1SET BBQ49026 TRAY 5 WARMING RACK 1PIECE BBQ49005 25 LEFT DOOR W/ CONDIMENT 1SET BBQ49027 TRAY 6 CAST IRON COOKING 3PIECES BBQ49006 26 DOOR BRACKET
Résumé du contenu de la page N° 20
GRILL COOKING CHART WEIGHT OR APPROXIMATE SPECIAL INSTRUCTIONS FOOD THICKNESS FLAME SIZE TIME AND TIPS VEGETABLES Slice. Dot with butter or margarine. Wrap in heavy-duty foil. Fresh Grill, turning occasionally. Beets Medium 12 to 20 minutes Carrots Grill, turning once. Brush occasionally with melted butter or margarine. Turnips Onion 1/2 inch slices Medium 8 to 20 minutes Wrap individually in heavy- duty foil. Grill, rotating Potatoes
