Résumé du contenu de la page N° 1
OUTDOOR GRILLS
FREESTANDING AND BUILT-IN
Installation Instructions and Use & Care Guide
For questions about features, operation/performance, parts, accessories or service, call: 1-800-422-1230
or visit our website at www.kitchenaid.com
In Canada, for assistance, installation and service, call: 1-800-807-6777
or visit our website at www.KitchenAid.ca
GRILS D’EXTÉRIEUR
AUTOPORTANTS ET ENCASTRÉS
Instructions d’installation et Guide d’utilisation et d’entretien
Au Canada, pour assistance, installa
Résumé du contenu de la page N° 2
TABLE OF CONTENTS TABLE DES MATIÈRES OUTDOOR GRILL SAFETY............................................................3 SÉCURITÉ DU GRIL D'EXTÉRIEUR ...........................................31 INSTALLATION REQUIREMENTS ................................................5 EXIGENCES D'INSTALLATION...................................................33 Tools and Parts ............................................................................5 Outillage et pièces.......................................
Résumé du contenu de la page N° 3
OUTDOOR GRILL SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.” These words mean: You can be killed or seriously injured if you don't immediate
Résumé du contenu de la page N° 4
IMPORTANT: This grill is manufactured for outdoor use only. For grills that are to be used at elevations above 2000 ft (609.6 m) orifice conversion is required. See “Gas Supply Requirements” section. It is the responsibility of the installer to comply with the minimum installation clearances specified on the model/serial rating plate. The model/serial rating plate for built-in models can be found on the right-hand side of the grill. The model/serial rating plate for freestanding models can be
Résumé du contenu de la page N° 5
INSTALLATION REQUIREMENTS T ools and Parts Location Requirements Style 1 - Freestanding Outdoor Grills Gather the required tools and parts before starting installation. WARNING Read and follow the instructions provided with any tools listed here. Tools Needed ■ Tape measure ■ Wrench or pliers ■ Small, flat-blade screwdriver ■ Pipe wrench ■ Flat-blade screwdriver ■ Scissors or cutting pliers Explosion Hazard (to remove tiedowns) ■ #2 and #3 Phillips screwdriver Do not store fuel tank in a ga
Résumé du contenu de la page N° 6
Product Dimensions Built-In Outdoor Grill Enclosure Style 1 - Freestanding Outdoor Grill WARNING A 17¼" 17¼" (43.8 cm) (43.8 cm) B Fire Hazard Do not install grill on or near combustible materials. 62¹⁄₂" Doing so can result in death or fire. (158.8 cm) The enclosure for the built-in outdoor grill is to be a minimum of 50" (127.0 cm) 11" (28.0 cm) high x 23" (58.4 cm) deep x (30" [76.0 cm] for 27" [68.6 cm] grill and 39" [99.0 cm] for 36" [91.4 cm] grill) wide. This built-in outdoor grill is o
Résumé du contenu de la page N° 7
Built-in Outdoor Grill Enclosure Ventilation for LP Gas: A An enclosure for an LP gas fuel tank is to be ventilated by 2¼" openings at both the top and lower levels of the enclosure. (5.7 cm) 12" (30.5 cm) If converting to LP gas these vents are to be in the enclosure: min to any An enclosure for use with an LP gas fuel tank for built-in 3" (7.6 cm) accessory 7 ³⁄₈" min to (18.7 cm) installation is to have at least one ventilation opening on an open hood exposed exterior side located within
Résumé du contenu de la page N° 8
On freestanding models, the model/serial number rating plate is located inside the grill cabinet on the right-hand cabinet side. Gas Supply Requirements See the following illustration. WARNING A Explosion Hazard Use a new CSA International approved “outdoor” gas supply line. Securely tighten all gas connections. A. Model/serial number plate If connected to LP, have a qualified person make sure gas pressure does not exceed 11” (28 cm) water On built-in models, the model/serial number rating
Résumé du contenu de la page N° 9
4. Tighten the locking screw against the bottom collar of the Burner Requirements for High Altitude 20 lb LP gas fuel tank to secure. Input ratings shown on the model/serial rating plate are for elevations up to 2,000 ft (609.6 m). A For elevations above 2,000 ft (609.6 m), ratings are reduced at a rate of 4% for each 1,000 ft (304.8 m) above sea level. Orifice conversion is required. See “Assistance or Service” section to order. Gas Supply Line Pressure Testing B C A. Locking screw Testing
Résumé du contenu de la page N° 10
To convert to Natural gas, the Natural Gas Conversion Kit Part The supply line shall be equipped with an approved shutoff valve. Number W10118098 must be used. Follow instructions included This valve should be located in the same area as the grill and with the kit. should be in a location that allows ease of opening and closing. Do not block access to the shutoff valve. The valve is for turning on or shutting off gas to the grill. A B B A C C A. Gas supply line B. Shutoff valve “open” positi
Résumé du contenu de la page N° 11
INSTALLATION INSTRUCTIONS Style 1 - Freestanding Outdoor Grill Installation Attach Cabinet Doors (on some models) WARNING 1. Remove foam wrapping from both cabinet doors. Excessive Weight Hazard 2. Position hinge pins on the door with the hinge brackets on Use two or more people to move and install grill. the cabinet. Gently push down to slide the pins into place. Failure to do so can result in back or other injury. 1. Unpack grill. Remove all packaging materials and remove grill from wooden s
Résumé du contenu de la page N° 12
5. Place warming shelf on brackets as shown. LP Gas: IMPORTANT: A 20 lb LP gas fuel tank must be purchased B separately. IMPORTANT: The gas pressure regulator/hose assembly A A supplied with the grill must be used. Replacement gas pressure regulator/hose assembly specific to your model, is available from your outdoor grill dealer. To Install the 20 lb LP Gas Fuel Tank: 1. Open cabinet doors. 2. Press the locking tab on the tank tray and pull out the tray. A. Warming shelf brackets B. Warming
Résumé du contenu de la page N° 13
9. The igniter battery is not factory installed. A 1.5-volt “D” size ■ Pipe-joint compounds suitable for use with Natural gas ®† must be used. Do not use TEFLON tape. alkaline battery is located in the accessory box on the grill grate. Install battery at this time following the instructions in the “Replacing the Igniter Battery” section. A 10. Go to “Check and Adjust the Burners” section. If Converted to Natural Gas B WARNING C D Explosion Hazard Use a new CSA International approved “outdoor”
Résumé du contenu de la page N° 14
Style 2 - Built-In Outdoor Grill Installation Make Gas Connection WARNING NOTE: If grill has been converted to LP gas, follow instructions in Excessive Weight Hazard “If Converting to LP Gas” at the end of this section. Use two or more people to move and install grill. Failure to do so can result in back or other injury. WARNING ■ Unpack grill. Remove all packaging materials and remove grill from carton. ■ Move grill close to desired outdoor location. ■ Open the hood. Fire Hazard Remove Packag
Résumé du contenu de la page N° 15
■ Pipe-joint compounds suitable for use with Natural gas ® must be used. Do not use Teflon tape. WARNING A B Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. C D Do not use an extension cord. A. Grill gas pipe Failure to follow these instructions can result in death, B. New CSA International approved “outdoor” flexible gas supply line fire, or electrical shock. C. Rear of grill D. To Natural gas supply 2. Plug into a grounded 3-p
Résumé du contenu de la page N° 16
To Install the 20 lb LP Gas Fuel Tank: 5. Remove the 2 screws that hold the burner in place. Remove gas burner from the grill. 1. Install the 20 lb LP gas fuel tank into the compartment below the grill. 2. Screw the gas pressure regulator/hose assembly to the 20 lb LP gas fuel tank as shown. B A A. 2 screws A 6. If flame is yellow (not enough air), turn air shutter adjustment screw counterclockwise. If flame is noisy or lifts away from burner (too much air), turn air shutter adjustment scr
Résumé du contenu de la page N° 17
OUTDOOR GRILL USE This manual covers several different models. The grill you have purchased may have some or all of the features listed. The locations and appearances of the features shown here may not match those of your model. Control Panel B A C E F D A. Rotisserie burner control knob D. Sear burner control knob B. Left grill burner control knob E. Hood lights C. Center grill burner control knob F. Side burner control knob Using Your Outdoor Grill WARNING WARNING Food Poisoning Hazard Do not
Résumé du contenu de la page N° 18
Prepare the Gas Supply Manually Lighting Main Grill and Infrared Sear Burners 1. Open the hood completely. Do not light burners with the hood 1. Do not lean over the grill. closed. 2. Remove the manual lighting extension (see following 2. Make sure control knobs are turned to OFF. The drip pan illustration) and attach a match to the split ring. must be in place and pushed all the way to the back. A Freestanding grills - right- Built-in grills - right-hand A. Drip pan hand cabinet door side fl
Résumé du contenu de la page N° 19
4. You will hear the “snapping” sound of the spark igniter. When burner is lit, release the knob. Turn knob to desired setting. Using Your Infrared Sear Burner 5. Repeat for each of the other burners as needed. Infrared grilling produces intense heat which quickly sears the IMPORTANT: If burner does not light immediately, turn the meat. Searing locks in flavor and juices while allowing the outer burner knob to OFF and wait 5 minutes before relighting. surface to absorb smoke and food aroma t
Résumé du contenu de la page N° 20
Using Your Rotisserie (Optional Accessory) A rotisserie kit can be purchased as an accessory for the grill. 6. Once the food is positioned on spit rod, place pointed end of See “accessories” in the “Assistance or Service” section.) rod through the hole in the left side of the grill and into the rotisserie motor, then lower the notched end of the spit rod onto the support bracket on the opposite side. C D A B A B A. Pointed end of spit rod B. Notched end of spit rod A. Rotisserie motor B. Spit
