Résumé du contenu de la page N° 1
STAINLESS STEEL NATURAL GAS GRILL
MODEL NO.: 730-0165 ITEM NO: 31012
Jenn-Air is a Trademark of the Maytag Corporation and is used under license to Lowe’s Companies, Incorporated.
FOR OUTDOOR USE ONLY
PLEASE CONTACT 1-800-554-5799 FOR ASSISTANCE
DO NOT RETURN TO PLACE OF PURCHASE
Résumé du contenu de la page N° 2
TABLE OF CONTENTS SECTION ONE SECTION FIVE Safety Instructions………………………….. 1-5 Exploded View………………………….. 18 Placement of the Grill………………………. 5 Parts List……………………………….. 19 SECTION TWO SECTION SIX Side Shelf Assembly…………………………. 6 Grilling Hints……………………………….. 20 Side Shelf Handle & Battery Installation
Résumé du contenu de la page N° 3
SAFETY INSTRUCTIONS RECOGNIZED SAFETY SYMBOLS, WORDS AND LABELS WARNING WARNING Do not try lighting this appliance without first reading the “LIGHTING INSTRUCTIONS” section of this manual. WARNING – Hazards or unsafe practices which COULD result in severe personal injury or death. WARNING Spiders and insects can nest inside the burners of CAUTION the grill and disrupt gas flow. This very dangerous condition could cause a fire behind the valve panel
Résumé du contenu de la page N° 4
SAFETY INSTRUCTIONS CAUTION WARNING When using a match to light the grill make Do not use the grill if the odor of gas is present. Contact customer service at 1- sure to use the attached lighting rod. 800-554-5799. CAUTION Before cleaning, make sure the gas supply WARNING and control knobs are in the “OFF” position When lighting, keep your face and hands and the burners have cooled. as far away from the grill as possible. WARNING WARNI NG Failure to prop
Résumé du contenu de la page N° 5
SAFETY INSTRUCTIONS USING THE SIDE BURNER WARNING Inspect the gas supply hose prior to turning on Do not attempt to light the grill if gas odor is the gas. If there is evidence of cuts, wear or present. Contact customer service at 1-800- abrasion, it must be replaced prior to use. Do 554-5799. not use the side burner if gas odor is present. When lighting, keep your face and body as far Keep a spray bottle of soapy water near the away from the burner as possible. gas supply val
Résumé du contenu de la page N° 6
SAFETY INSTRUCTIONS The grill is not intended to be installed in or on WARNING recreational vehicles and/or boats. Do not try lighting this appliance without first reading the “LIGHTING INSTRUCTIONS” section Children should not be left alone or unattended in of this manual. an area where the grill is being used. Do not allow children to sit, stand or play on or around the grill TESTED IN ACCORDANCE WITH ANSI Z21.58 at any time. LATEST STANDARD and CSA 1.6 LATEST STANDARD FOR
Résumé du contenu de la page N° 7
SAFETY INSTRUCTIONS When using the grill, do not touch the grill rack, Turn off all control knobs and make certain the grill burner grate or immediate surroundings as these is cool before using any type of aerosol cleaner on areas become extremely hot and could cause or around it. The chemical that produces the burns. Use only dry potholders. Moist or damp spraying action could, in the presence of heat, potholders on hot surfaces may cause steam burns. ignite or cause metal parts to corrod
Résumé du contenu de la page N° 8
SIDE SHELF ASSEMBLY Estimated Assembly Time: Approximately 5-7 minutes Required Tools: Phillips Screwdriver 1. Open the grill lid and remove the side shelf from the fire box. 2. The screws used to attach the side shelves are already screwed into the side panels of the grill cart. Remove the screws from the side panels. 3. Align the holes of the left side shelf with the holes in the grill cart. Insert the screws and tighten. Note: The top two screws insert from i
Résumé du contenu de la page N° 9
SIDE SHELF HANDLE ASSEMBLY Estimated Assembly Time: Approximately 5-7 minutes Required Tools: Phillips Screwdriver 1. Remove the four side shelf handle screws from the side of the shelf. 2. Align the holes in the handle with the holes in the side shelf. 3. Insert the screws and tighten. BATTERY INSTALLATION 1. Remove the ignition button housing. 2. Insert the battery into the housing with the positive terminal facing outward. 3. Replace the igniti
Résumé du contenu de la page N° 10
BRAKING SYSTEM OPERATION Push right to lock. 1 1 Push left to unlock. INSTALLATION OF NATURAL GAS REGULATOR 1. Connect the PVC Natural Gas Hose to the house gas supply line using the quick-connect fitting as show in the figure A. Check all gas supply fittings for leaks before each use. 2. Do not use the grill until all connections have been checked and do not leak. A. B. 3. The Natural Gas regulator has been attached to the manifold. 4
Résumé du contenu de la page N° 11
GAS HOOK-UP Only the pressure regulator and hose assembly Main burners 52,000 BTU/Hr. supplied with the grill should be used. Any Sear Burner 23,000 BTU/Hr. replacement pressure regulator and hose assembly Rear burner 16,000 BTU/Hr. must be specified by the grill manufacturer. Side burner 12,000 BTU/Hr. Total 103,000 BTU/Hr. Total gas consumption (per hour) of the 730-0165 Natural gas grill with all burners set on “H
Résumé du contenu de la page N° 12
INSTALLER FINAL CHECK Specified clearance maintained of 24 inches The unit has been tested and is free of leaks. from combustible materials/constructions. The gas supply shut off valve has been All internal packaging has been removed. located. The hose and regulator are properly All burners are factory installed. connected. WARNING 1. The gas grill and its individual shutoff valve must be disconnected from the gas supply piping system during any
Résumé du contenu de la page N° 13
OPERATING INSTRUCTIONS GENERAL USE OF THE GRILL AND ROTISSERIE Each main burner is rated at 13,000 BTU/Hr. The After its first use, the stainless steel adjacent to the main grill burners encompass the entire cooking rotisserie burner will most likely turn dark blue. This area and are side ported to minimize blockage from is a normal property of the non-rusting type falling grease and debris. Above the burners are stainless steel used on the grill. stainless steel flame tamers. The ignit
Résumé du contenu de la page N° 14
NOTE Adjust the counter balance weight to balance the It is normal for the skewer to flex when larger cuts heavier side of the meat and avoid lopsided rotation of meat are being cooked. of the rotisserie motor. If the meat scrapes on the cooking grids during any CAUTION part of the rotation, the cooking grids must be When using the rotisserie burner, remove the removed. Test this clearance before lighting the grill warming rack. High heat from the burner may cause as the cooking
Résumé du contenu de la page N° 15
TO MATCH LIGHT THE GRILL If the burner will not light after several attempts using the control knobs, the burner may be lit with a match. 1. If you have already attempted to light the burner with the igniter, allow 5 minutes for any accumulated gas to dissipate. 2. Insert a match into the lighting rod. Ignite the match and insert through the cooking grids to the burner. 3. Press and turn the control knob to the “HI” setting. Continue pressing the control knob until the burner
Résumé du contenu de la page N° 16
LIGHTING ILLUSTRATIONS MAIN, SIDE BURNER, ROTISSERIE & REAR BURNER LIGHTING 1. Open the top cover or lid. 2. Push and turn the main, side, rotisserie or rear burner control knobs to the “HI” setting. Push the control knob until the burner ignites. The burner should ignite within 4 seconds (if burner does not ignite follow match lighting instructions on Page 13. 3. After the burner ignites, adjust the temperat
Résumé du contenu de la page N° 17
USING THE SIDE BURNER Inspect the gas supply hose prior to turning on 4. If the smell of gas is detected and the igniter the gas. If there is evidence of cuts, wear or is not functioning, immediately turn the control abrasion, it must be replaced prior to use. Do not knob to the “OFF” position. use the side burner if gas odor is present. 5. Allow 5 minutes for any accumulated gas to dissipate. If the side burner igniter will not WARNING function, follow the match light
Résumé du contenu de la page N° 18
CARE & MAINTENANCE OF THE GRILL STAINLESS STEEL GRILL BURNERS Grease specks can gather and bake onto the Extreme care should be taken when moving a surfaces of the stainless steel, giving the burner. It must be correctly centered on the appearance of rust. For removal, use an abrasive orifice before any attempt is made to relight the pad with a stainless steel cleaner. grill. Frequency of cleaning will depend on how often you use the grill. GRILL RACK The easiest way to cle
Résumé du contenu de la page N° 19
TROUBLESHOOTING WHEN TO LOOK FOR SPIDERS You should inspect the burners at least twice a WARNING year or immediately after any of the following Spiders and insects can nest inside the burners conditions occur: of the grill and disrupt gas flow. This very dangerous condition could cause a fire behind 1. The smell of gas in conjunction with burner the valve panel, thereby damaging the grill and flames appearing yellow. making it unsafe for operation. 2. The
Résumé du contenu de la page N° 20
EXPLODED VIEW 01 02 03 04 35 05 34 06 07 36 75 37 38 09 08 39 10 40 11 12 41 13 14 15 16 17 43 42 18 19 71 20 76 48 28 44 21 49 29 50 45 51 30 52 73 53 31 47 54 32 46 22 55 56 57 33 63 23 58 64 72 74 24 59 25 60 61 26 62 27 65 67 66 68 69 70 16 18
