Résumé du contenu de la page N° 1
STAINLESS STEEL BUILT-IN GAS GRILL
MODEL #s: 720-0138-NG / 720-0141-LP LOWE’S ITEM #s: 168932/168931
Jenn-Air is a Trademark of the Maytag Corporation and is used under license to Lowe’s Companies, Incorporated.
FOR OUTDOOR USE ONLY
PLEASE CONTACT 1-800-554-5799 FOR ASSISTANCE
DO NOT RETURN TO PLACE OF PURCHASE
Résumé du contenu de la page N° 2
TABLE OF CONTENTS SECTION ONE Important Warnings … … … …. ………… 1 Safety Instructions … … … ….................. 2-4 Placement of the Grill … … ……………… 4 SECTION TWO Model Specifications… … … …………….. 5 Island Construction … … … ….................. 6 Front View of Opening … ………………… 7 Rear View of Opening………………………8 SECTION THREE Battery Installation … … ... … …………… 9 LP Gas Hook-up … … … … …………….. 10 Propane Tank Assembly … ……………....11 Installation of NG Regulator ….......
Résumé du contenu de la page N° 3
IMPORTANT WARNINGS WARNING FOR YOUR SAFETY If you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flames. 3. Open the top cover or lid. 4. If the odor continues, immediately call your gas supplier or local fire department. 5. Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. 1
Résumé du contenu de la page N° 4
SAFETY INSTRUCTIONS SAFETY SYMBOLS WARNING CAUTION Hazardous or unsafe practices that Hazardous or unsafe practices that could result in personal injury or death. could result in personal injury. COMMON CAUTIONS AND WARNINGS INSECT WARNING CAUTION Spiders and insects can nest inside the burners of Remove the warming rack when using the this and other grills, which could disrupt gas flow. rotisserie burner. High heat from the burner could This dange
Résumé du contenu de la page N° 5
Résumé du contenu de la page N° 6
SAFETY INSTRUCTIONS When using the grill, do not touch the grill rack, Turn off grill controls and make certain the grill is burner grate or immediate surroundings as these cool before using any type of aerosol cleaner on or areas become extremely hot and could cause around the grill. The chemical that produces the burns. Use only dry potholders. Moist or damp spraying action could, in the presence of heat, potholders on hot surfaces may cause steam burns. ignite or cause metal parts to c
Résumé du contenu de la page N° 7
GRILL SPECIFICATIONS Description 720-0138-NG and 720-0141-LP Cutout Width 32 1/2 in. (82.55 cm) Cutout Depth 23 in. (58.42 cm) Cutout Height 10 1/4 in.(26.04 cm) Natural Gas: Standard residential 1/2 in. (1.3 cm) ID gas service line. Natural gas hose/regulator assembly included with quick- connect fitting for attachment to house natural gas line. Gas Requirements Liquid Propane: Supplied with hose/regulator assembly for connection to standard 5 gal, 20 lb. liquid propane gas
Résumé du contenu de la page N° 8
GRILL SPECIFICATIONS Description 720-0138-NG and 720-0141-LP Cutout Width 32 1/2 in. (82.55 cm) Cutout Depth 21 1/2 in. (54.61 cm) Cutout Height 10 3/4 in.(27.31 cm) Natural Gas: Standard residential 1/2 in. (1.3 cm) ID gas service line. Natural gas hose/regulator assembly included with quick- connect fitting for attachment to house natural gas line. Gas Requirements Liquid Propane: Supplied with hose/regulator assembly for connection to standard 5 gal, 20 lb. liquid propane g
Résumé du contenu de la page N° 9
32 1/2 in.(82.55cm) ISLAND CONSTRUCTION A minimum of 3 in.(7.62cm) clearance from the back of the grill is required to non-combustible material. 10 3/4 in.(27.31cm) WARNING 5 in.(12.70cm) Do not install this unit into combustible enclosures. There should be a minimum clearance of at least 24 in.(60.96cm) from all sides to combustible materials. Island cutout dimensions for Jenn-Air 4 burner LP and NG built-in grills: Width 32 1/2 in. (82.55 cm) Depth 21
Résumé du contenu de la page N° 10
Résumé du contenu de la page N° 11
BATTERY INSTALLATION 1. To install the battery, remove the ignition button housing. 2. Insert the battery into the housing with the positive pole of the battery facing outward. 3. Replace the ignition button housing after the battery has been installed (See the image below). 9
Résumé du contenu de la page N° 12
LP GAS HOOK-UP Only the pressure regulator and hose assembly LP GAS SUPPLY CYLINDER CONNECTION supplied with the grill should be used. Any Your grill is equipped with gas supply orifices for replacement pressure regulator and hose assembly use only with liquid propane gas. It is also equipped must be specified by the grill manufacturer. with a high capacity hose/regulator assembly for connection to a standard 20lb. LP cylinder (18-1/4 This is a liquid propane configured grill. Do n
Résumé du contenu de la page N° 13
10
Résumé du contenu de la page N° 14
CLOSE PROPANE TANK ASSEMBLY 1. Attach the regulator to the propane tank by turning the regulator handle clockwise. 2. Turn off the LP supply at the cylinder when the grill is not in use. g 11 OPEN
Résumé du contenu de la page N° 15
Résumé du contenu de la page N° 16
NATURAL GAS HOOK-UP XXXXXXXXXXXXXXXXXXXXXXXX Only the pressure regulator and hose assembly supplied with the grill should be used. Any replacement pressure regulator and hose assembly must be specified by the grill manufacturer. The installation of this appliance must conform with the local codes or, in the absence of local codes, to the national fuel gas code, ANSI Z223.1. Total gas consumption (per hour) of the 720-0138-NG grill with all burners on the “HI” setting: Main bu
Résumé du contenu de la page N° 17
LEAK TESTING XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX GENERAL Although all gas connections on the grill are leak Only those parts recommended by the tested at the factory prior to shipment, a complete manufacturer should be used on the grill. gas tightness check must be performed at the Substitutions will void the warranty. installation site. Periodically check the whole system for leaks following the procedures listed GAS FLOW CHECK below. Each grill burner is tested and adjusted
Résumé du contenu de la page N° 18
CAUTION Burner adjustments should only be performed after the burners have cooled. Always tighten the locking nut before relighting the burner Locking Nut GAS FLOW ADJUSTMENTS • If the flames have yellow tips, loosen the locking nut and move the bolt in a clockwise direction. • If the flames are making excessive noise or Adjustment Bolt lifting, loosen the locking nut and turn the bolt in a counter-clockwise direction. • For questions regarding flame stability
Résumé du contenu de la page N° 19
OPERATING INSTRUCTIONS GENERAL USE OF THE GRILL AND ROTISSERIE Each main burner is rated at 12,000 BTU/Hr. The The grill is designed to grill efficiently without the main grill burners encompass the entire cooking use of lava rocks or briquettes of any kind. Heat is area and are side ported to minimize blockage from radiated by the stainless steel flame tamers falling grease and debris. Above the burners are positioned above each burner. stainless steel flame tamers. The igniter knobs
Résumé du contenu de la page N° 20
LOADING THE ROTISSERIE SKEWER It is normal for the skewer to flex when larger cuts 1. Screw the bushing into the skewer rod at the of meat are being cooked. It may also be necessary opposite end from the point. to remove the cooking grids for larger cuts of meat. 2. Slide and tighten the counter balance apparatus If the meat scrapes on the cooking grids during any onto the skewer rod approximately 2-4 in. from part of the rotation, the cooking grids must be the bushing. removed.
