Résumé du contenu de la page N° 1
Installation Instructions
®
Epicure Outdoor Grill
Models: OB36, OBS36, OB52
OBS52, OBSB162
TesTed in accordance wiTh The la TesT ediTion of
ANSI Z21.58 2006 ● cSA 1.6-2006 St ANdArd for outdoor
cookINg gAS ApplIANceS. IN cANAdA: INSt AllA tIoNS MuSt
Be IN AccordANce WItH tHe curreNt cAN/cgA-B149.1.
NAturAl gAS INSt AllA tIoN code cAN/cgA-B149.2. prop ANe
INSt AllA tIoN code ANd/or locAl code.
Part No. 102032 Rev. E
Résumé du contenu de la page N° 2
Résumé du contenu de la page N° 3
Table of Contents Before You Begin... ........................................................... 1 installation instructions .................................................. 10 important safety instructions .......................................... 1 Preparing for Installation ................................................ 10 Important Information About Safety Instructions .............. 1 Cabinet Installation ......................................................... 12 General Safety Prec
Résumé du contenu de la page N° 4
Important Safety Instructions warninG warninG If the information in this manual is not followed exactly, This outdoor cooking appliance is not intended to be a fire or explosion may result causing property damage, installed in or on a recreational vehicle and/or boats. personal injury or death. warninG warninG Use this outdoor gas cooking appliance outdoors only. NEVER use this appliance as a space heater to heat or Do not use it in a building, garage or any other enclosed warm a room. Do
Résumé du contenu de la page N° 5
Important Safety Instructions warninG warninG 17. Keep items that could explode, such as aerosol 34. Non-stick coatings, when heated, can be harmful to cans away from the grill and burners. Do not store birds. Remove birds to a separate, well-ventilated flammable or explosive materials in adjacent area during cooking cabinets or areas. 35. Make sure that all of the appliance’s parts are dry 18. Do not use towels or bulky cloth as pot holders. before lighting a burner. Do not cover the bu
Résumé du contenu de la page N° 6
Important Safety Instructions General Safety Precautions (continued) To reduce risk of fire, electric shock, serious injury or death when using your appliance, follow basic precautions, including the following: warninG TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A GREASE FIRE: • SMOTHER FLAMES with a close-fitting lid, cookie sheet or metal tray, then turn off the burner. BE CAREFUL TO PREVENT BURNS. If the flames do not go out immediately, EVACUATE AND CALL THE FIRE DEPARTMENT.
Résumé du contenu de la page N° 7
Planning the Installation 26" (660mm) oB52 and o Bs52 9 1/8" (232mm) 52" (1321mm) 23 3/4" (603mm) 26 1/2" (673mm) 27 1/8" (689mm) 9 1/8" (232mm) 23 3/4" oBsB162 16" (603mm) (406mm) 26 1/2" (673mm) 27 1/8" (689mm) Cut-Out for Outdoor Grill accessory doors 21” (533mm) door Model w idth OBAD20 19 1/2” (495mm) OBAD36 35 7/8” (911mm) Door Depth: 1/4” (6mm) Width deep return on frame edge
Résumé du contenu de la page N° 8
Planning the Installation Location Planning - General warninG • This installation must conform to local codes or, in Gas and Electric Power Requirements the absence of local codes, with either the National Fuel Gas Code, ANSI Z223.1/NFPA 54, Natural • Prior to installation, the gas supply for natural gas Gas and Propane Installation Code, CSA B149.1, or or whole house LP installations must meet the Propane Storage and Handling Code, B149.2. specifications below. • Prevent grill combustion
Résumé du contenu de la page N° 9
Planning the Installation Location Planning - Enclosed 10" (254mm) Min. to combustibles 1 1/4" (32mm) Min. to non-combustible Cabinets • Maintain all minimum clearances specified on pages 7 28 1/2" (724mm) To finished and 8. countertop Junction • For proper outdoor grill operation, provide a flat, level Box mounting surface with minimum 3/4” thickness. Trim frame (accessory) • All models are designed to allow installation in combustible or non-combustible base material Rotisserie mounting s
Résumé du contenu de la page N° 10
Planning the Installation Location Planning - Enclosed Cabinets (continued) 6" x 6" 6" x 7" (152mm x 152mm) (152mm x 178mm) Utility Cutout Utility Cutout for OBSB162 6” (152mm) 12 1/8" (308mm) 7” 25" (178mm) (635mm) 3/8" (10mm)ø Both sides OB(S)36 - 33 1/2" (851mm) OB(S)52 - 49 1/2" (1257mm) 8" (203mm) Min. to combustibles above 1 1/4" 2" (51mm) the countertop surface (32mm) cutout dimensions - t op View OBSB162 OB(S)36 - 36 1/2" (927mm) 16 1/8" (410mm) OB(S)52 - 52 1/2" (1334mm) 9" (228mm
Résumé du contenu de la page N° 11
Planning the Installation Location Planning - Cart Installations • Maintain all minimum clearances shown between the • For proper grill and drawer operation, use the outdoor appliance and all surfaces behind and to the side of the grill and cart only on a level surface. appliance. • Side distances exclude optional shelves. • Allow 26 inches minimum in front to open and close the cabinet drawers. Above the cooking surface, both sides: Above cooking surface, behind unit: 3” (76mm) Min. to non-co
Résumé du contenu de la page N° 12
Installation Instructions Parts List warninG Models oB36, oBs36, oB52 & oBs52: • Before installing the appliance, make sure the A Drip tray G Rotisserie rod and forks electrical and gas (on tank-less installations) service B Smoker box H Rotisserie motor meets the requirements specified in the Planning C Warming rack J Light lens prystick the installation section of this manual. D Regulator assembly Match holder • This appliance must be installed by a licensed plumber or gas fit
Résumé du contenu de la page N° 13
Installation Instructions whole house natural Gas or D D D l P regulator lP cylinder regulator lP cylinder regulator oBs162, oB36, oBs36 oB52, oBs52 (Pn 72310) (Pn 101578) F E G K H J N L P M
Résumé du contenu de la page N° 14
Installation Instructions Cabinet Installation Cart Installation warninG warninG • Attach the appliance to the cart with all of the To avoid an explosion hazard, do not connect the cart or supplied bolts before use. appliance(s) to electrical power until after the gas supply system has been checked for leaks. • All gas and electrical connections should be made after the grill is installed and bolted to the cart. • To avoid an explosion hazard, do not connect the iMPorT anT cart or applia
Résumé du contenu de la page N° 15
Installation Instructions Optional Side Shelf Installation 2. Slide the slot on the inside of the shelf over the pin on 1. Install the front mounting bracket for the right side the mounting bracket. shelf. Use two (2) of the provided button head fasteners and two (2) lock washers. Tighten into place using a 5/32” allen wrench. Pin 3. While holding the shelf in place, insert the pin on the back mounting bracket into the slot on the back side of the shelf. 4. While holding the shelf and back
Résumé du contenu de la page N° 16
Installation Instructions 3. Install an approved flexible gas line from the regulator Connecting the Gas to the gas line shut off valve. Gas Connection - Natural Gas whole house lP Gas connection noTes • Units equipped for use with natural gas ship with a regulator assembly with 3/4” pipe attached and an additional 3/4” nipple. • The regulator assembly is also equipped with a 3/4” to 1/2” reducer on the inlet side. 1. Connect the factory supplied regulator assembly to the gas inlet at th
Résumé du contenu de la page N° 17
Installation Instructions Final Assembly and Test Assemble the Side Burner - Some Models Assemble the Grill 7. Put the burner heads on to the burner bases. Line up 1. Open the hood on the unit. the slots on each head with the pins on the base so 2. Insert the drip tray completely into the slot on the front that it lies flat. Put the burner caps on top of the burner of the unit. heads. Line up the slots on each cap with the pins on 3. Put the flame spreaders on the floor of the appliance, t
Résumé du contenu de la page N° 18
Installation Instructions Final Assembly and Test (cont.) 1. For units that will use a LP cylinder, start by making LP Cylinder Installation - Some Models sure the main valve is completely closed 2. Place the tank into the final position within the cabinet warninG or cart. • The largest recommended LP cylinder size for the rollout tank shelf on the cart is five gallons. A five Gas Connection at Right Rear Corner gallon portable liquid propane cylinder should be Under Outdoor Grill approxima
Résumé du contenu de la page N° 19
Installation Instructions 2. With the tank shelf open, connect the power cord from 6. If the second or third attempt to ignite the burner is the outdoor grill and the warming oven (if equipped with not successful then turn all burner controls to the OFF one) to the electrical outlet on the back panel inside the position. cart. 7. If the grill or cooktop fails to operate properly, ensure that the electrical power supply and gas supply are turned on and that all installation steps have been c
Résumé du contenu de la page N° 20
Web Site: www.Dacor.com Phone: (800) 793-0093 Copyright © 2007 by Dacor Inc. All rights reserved.
