Résumé du contenu de la page N° 1
®
OWNER’S MANUAL
ASSEMBLY AND OPERATING INSTRUCTIONS
SAVE THIS MANUAL FOR FUTURE REFERENCE
WARNING
HAZARDOUS EXPLOSION MAY
NOTICE TO INSTALLER:
RESULT IF THESE WARNINGS AND
LEAVE THESE INSTRUCTIONS
INSTRUCTIONS ARE IGNORED. READ
WITH THE GRILL OWNER FOR
AND FOLLOW ALL WARNINGS AND
FUTURE REFERENCE.
INSTRUCTIONS IN THIS MANUAL TO
AVOID PERSONAL INJURY, INCLUDING
DEATH OR PROPERTY DAMAGE.
Résumé du contenu de la page N° 2
IMPORTANT SAFETY WARNINGS WE WANT YOU TO ASSEMBLE AND USE YOUR GRILL AS SAFELY AS POSSIBLE. THE PURPOSE OF THIS SAFETY ALERT SYMBOL IS TO ATTRACT YOUR ATTENTION TO POSSIBLE HAZARDS AS YOU ASSEMBLE AND USE YOUR GRILL. WHEN YOU SEE THE SAFETY ALERT SYMBOL PAY CLOSE ATTENTION TO THE INFORMATION WHICH FOLLOWS! READ ALL SAFETY WARNINGS AND INSTRUCTIONS CAREFULLY BEFORE ASSEMBLING AND OPERATING YOUR GRILL. DANGER FOR YOUR SAFETY: IF YOU SMELL GAS: 1. Shut off gas to the appliance at the LP cylinder a
Résumé du contenu de la page N° 3
WARNING • Never use natural gas in a unit designed for liquid propane gas. • Never use charcoal briquets or lighter fluid in a gas grill. • Leak test all connections before first use, even if grill was purchased fully assembled and after each tank refill. • Never check for leaks using a match or open flame. CAUTION! Strong odors, colds, sinus congestion, etc. may prevent the detection of propane. Use caution and common sense when testing for leaks. • Always keep gasoline, paint thinner, or othe
Résumé du contenu de la page N° 4
WARNING • FOR OUTDOOR USE ONLY. DO NOT operate indoors or in an enclosed area such as garage, shed or breezeway. • Use your grill OUTDOORS in a well ventilated space away from dwellings or other buildings to prevent dangers associated with gas accumulation and toxic vapors. We recommend your grill be situated at least 10 feet from buildings. • Maintain a minimum clearance of 24 inches (60 cm) between all sides of grill and walls or other combustible material. • DO NOT install in or on a recreati
Résumé du contenu de la page N° 5
The cylinder must also be equipped with: • A shut-off valve terminating in a Type 1 gas cylinder valve outlet. • A Type 1 valve that prevents gas flow until a positive seal is obtained. • An arrangement for vapor withdrawal. • A collar to protect the cylinder shut off valve. • A safety relief device having direct communication with the vapor space of the cylinder. • A listed over-filling prevention device (OPD). WARNING • Turn off the cylinder valve when your grill is not in use. • Handle the t
Résumé du contenu de la page N° 6
WARNING FILLING THE LP GAS CYLINDER: • Allow only qualified LP gas dealers to properly fill or repair your LP gas cylinder. • New tanks should be purged prior to filling; inform LP gas dealer if you are using a new tank. • DO NOT allow the cylinder to be filled beyond 80% capacity. Over-filled tanks can create a dangerous condition. Over-filled tanks can build-up pressure and cause the relief valve to expel propane gas vapors. The vapor is combustible and if it comes in contact with a spark sour
Résumé du contenu de la page N° 7
WARNING • Never use your grill without leak testing all gas connections and hoses. See the section on "Leak Testing" in this manual for proper procedures. WARNING The pressure regulator and hose assembly supplied with your gas grill is designed to work with an LP gas supply cylinder. • DO NOT attempt to connect it to any other fuel supply source such as a natural gas line. • DO NOT use any other pressure regulator/hose assembly other than the one supplied with your grill. • DO NOT attempt to adj
Résumé du contenu de la page N° 8
DANGER LEAK TESTING: To prevent fire or explosion hazard: • DO NOT smoke or permit ignition sources in the area while conducting a leak test. • Perform test OUTDOORS only in a well ventilated area. • Never perform a leak test with a match or open flame. • Never perform a leak test while the grill is in use. WARNING WHEN TO PERFORM A LEAK TEST: • After assembling your grill and before lighting for the first time, even if purchased fully assembled. • Every time the LP gas cylinder is refilled or i
Résumé du contenu de la page N° 9
6. Check each place listed (A -K) for growing bubbles which indicates a leak. 7. Turn OFF gas supply at cylinder valve. 8. Turn on control knobs to release gas pressure in hose. 9. Turn control knobs to “off” position. 10. Tighten any leaking connections. 11. Repeat soapy water test until no leaks are detected. DO NOT use the grill if leaks cannot be stopped. Contact a qualified gas appliance repair service. 12. Turn OFF gas supply at cylinder valve until you are ready to use your grill. 13. Was
Résumé du contenu de la page N° 10
WARNING Read, understand and follow all warnings and instructions contained in this manual. DO NOT skip any of the warnings and instructions contained in the preceding sections of this manual. WARNING LIGHTING INSTRUCTIONS: Follow the instructions exactly. 1. OPEN THE GRILL LID before attempting to light the burner so that fumes do not accumulate inside the grill. An explosion could occur if grill lid is down. 2. Check that all burner control knobs and the cylinder valve are turned to the OFF po
Résumé du contenu de la page N° 11
TURNING OFF THE GRILL: 1. Turn OFF the LP tank valve. 2. Turn all burner control knobs to the OFF position. NOTE: Turn off LP cylinder first to prevent gas from being left in the system under pressure. CAUTION! • The LP tank valve should always be in the off, or closed, position when the grill is not in use. To turn off the LP tank valve, turn knob clockwise until it stops. WARNING OPERATING THE GRILL: Never use Charcoal or Lighter Fluid inside your Gas Grill. Read and follow all warnings and in
Résumé du contenu de la page N° 12
WARNING • DO NOT leave your grill unattended while in use. • DO NOT move grill when in use. • DO NOT use water to extinguish flare-ups. • Have fire extinguisher readily accessible suitable for use with gas appliances. • Only use ceramic briquets that are large enough so they do not fall through the rock grate to the burner. This will prevent grease build-up. TO MINIMIZE FLARE-UPS: • Trim excess fat from meats prior to cooking. • Cook meats with high fat contents (chicken or pork) on Low settings
Résumé du contenu de la page N° 13
Follow the instructions listed below. BEFORE STORING YOUR GRILL: • Ensure that the fuel supply tank valve is fully closed. • Clean all surfaces. • Lightly coat the burner with cooking oil to prevent excess rusting. • If storing the grill indoors, disconnect the LP tank and leave the LP tank OUTDOORS. • Place a protective cap cover on the LP tank and store the tank outdoors in a well ventilated area out of direct sunlight. • If storing the grill outdoors, cover the grill with a grill cover for
Résumé du contenu de la page N° 14
COOKING GRILLS • Clean with mild soap detergent and water. A brass bristled brush or a nylon cleaning pad can be used to remove residue from the cooking surface. DO NOT use a commercial oven cleaner. CERAMIC BRIQUETS • Periodically, it may be necessary to inspect and clean the ceramic briquets to prevent excess grease build-up. When the grill is cold, remove the cooking grill. Inspect each briquet and replace briquets that are broken, chipped or damaged to the extent that it may fall through the
Résumé du contenu de la page N° 15
PROPER CARE & MAINTENANCE • To protect your grill from excessive rust, the unit must be kept clean and covered at all times when not in use. A grill cover may be ordered directly from Brinkmann by calling 1-800-468-5252 or 1-800-527-0717. • Wash cooking grill and rock grate with hot, soapy water, rinse well and dry. Lightly coat cooking grill with vegetable oil or vegetable oil spray. • Clean inside and outside of grill by wiping off with a damp cloth. Apply a light coat of vegetable oil or vege
Résumé du contenu de la page N° 16
ASSEMBLY INSTRUCTIONS READ ALL SAFETY WARNINGS & ASSEMBLY INSTRUCTIONS CAREFULLY BEFORE ASSEMBLING OR OPERATING YOUR GRILL. WE RECOMMEND TWO PEOPLE WORK TOGETHER WHEN ASSEMBLING THIS UNIT. The following tools are required to assemble this Brinkmann Gas Grill King Deluxe: • Pliers • Phillips & Flathead Screwdrivers • Adjustable Wrench PARTS LIST: PARTS BAG CONTAINS: 1 2 Handle spacers 2 Cooking grills 16 3/4 X 16 1/4 2 1 Bag of ceramic briquets 1 Temperature gauge 3 2 Hinges 1 Briquet grate 33 1/
Résumé du contenu de la page N° 17
1 2 4 3 6 5 7 9 8 8 10 12 12 11 13 17 14 18 15 16 20 19 21 23 22 28 27 25 24 26 FOR MISSING PARTS, PLEASE CALL CUSTOMER SERVICE AT 1-800-527-0717. (Proof of purchase will be required.) Inspect contents of the box to ensure all parts are included and undamaged. 16
Résumé du contenu de la page N° 18
Choose a good, cleared assembly area and get a friend to help you put your grill together. Lay cardboard down to protect grill finish and assembly area. Step 1 Stand lower grill housing on right side, as shown. The wheels can only be assembled to the left side of the grill. Align the bolt holes in the longer set of legs to the bolt holes in the side of the lower grill housing. The two welded brackets on the bottom end of the legs should face toward the grill and the side table pivot studs shoul
Résumé du contenu de la page N° 19
Step 4 Insert axle into one wheel hub, then insert a wheel over the axle (flat side of the wheel should face outward toward the wheel hub.) Slide the axle assembly through the holes in the short legs with the tank support bracket. Place the second wheel onto the axle and push the second wheel hub into place. Step 5 With the help of a friend, turn the assembly upright. Assemble the wire wood rack onto the welded brackets on the inside of the legs. Note: Use caution when lifting the lower grill ho
Résumé du contenu de la page N° 20
Step 6 Orient the grill so that the hood hinge holes are at the back of the grill. Align the control panel with the upper set of holes on the legs just below the bottom grill housing. Fasten the control panel using two 6x50mm bolts and nuts. Step 7 Align the tank hook strap to the legs (on side with tank support bracket). The threaded studs must be facing away from the grill bottom housing. Secure control panel and tank strap using 6x50mm bolts and nuts. Place the tank hook over the threaded st
