Instruction d'utilisation SkyLink MT-18

Résumé du contenu de la page N° 1

6 0 7
0 4 5 0 0
3 0 8 0
9 0
2 0
0 1 0 0
1 1 1 0
0
Motorcycle Garage Door
Remote Control Model MT-18
1. INTRODUCTION
2. INSTALLATION (CONT)
Plug in the connector end of the Red/Black wire to the MT-18R
In this package, you will find a transmitter with 12V alkaline battery and a 2
receiver. Note the orientation of the male & female connector.
mounting bracket, a garage door receiver, a red / black wire.
Garage
Door
Receiver
Keychain
Transmitter
(Battery inside)
Red/Black Wire
2. INSTALLATION
Pl

Résumé du contenu de la page N° 2

4. PROGRAM A TRANSMITTER TO THE RECEIVER 9. FCC This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: The transmitter in this kit has been programmed to the receiver in the (1) This device may not cause harmful interference, and (2) This device must accept any interference factory. You need to do the programming only if you add additional received, including interference that may cause undesired operation. transmitters to the receiver. WARNING