Instruction d'utilisation SkyLink Model UR-100

Résumé du contenu de la page N° 1

PROGRAMMING THE RECEIVER INSTALLATION
from the garage door
The Universal receiver works with Skylink remote transmitters Refer to the chart below. If any of the DIP switches in the Universal Receiver 1. Disconnect the power from proper operation.
model #66, #66C, #36, #36C, #68, #68C, #68B, #68G, #68R, are set to “ON” position, set the switches in the Skylink transmitter to the “+” your existing garage door opener is connected to.
Existing wall
position. If DIP switches on the Universal Receiver

Résumé du contenu de la page N° 2

PROGRAMMING THE SKYLINK MODEL #38, #38C PROGRAMMING THE SKYLINK MODEL #68, #68C, #68B, #68G, #68R 6. To move the connectors, slide an 7. Set the connectors num- 1. Locate frequency switch 2. To program the model 3. The transmitter has 12 rows 4. Use an opened paper clip to set the connectors numbered bered 1 through 9 so that opened paper clip into the side of on the top of the trans- #68, #68C, #68B, #68G, of posts, each row has 3 1 through 9 so that the switches on the transmitter match a con