Instruction d'utilisation Havis-Shields K-9 Kit KK-K9-C15-K

Résumé du contenu de la page N° 1

INSTALLATION INSTRUCTIONS
KK-K9-C15-K K-9 KIT
1998-2003 S10 BLAZER

TOOLS REQUIRED:
Power Drill Drill Bits – 1/8” Through 3/8”
Standard And Metric Socket Sets Phillips Screwdriver
6” Extension Wire Cutters and Crimping Tool
7/16” Wrench Ratcheting Wrench

COMPONENTS:
1 K9 Main Housing
1 Dome Light Kit
1 Rubber Mat
1 Front Mounting Adjustable Legs
1 Set Of Tunnel Assemblies
1 Set Of Hinged Window Guards
1 Set Of Aluminum Door Panels
1 Rubber Edge Molding

HARDWARE:
QTY: D

Résumé du contenu de la page N° 2

REMOVE INTERIOR: • Remove rear seats in vehicle • Remove door panels and handles • Remove seat belt assembly • Remove carpet in rear. Note: If doors have electric door switches, they must be reattached to original plug assembly. Switch assembly must then be wire tied down so it does not interfere with window or door latch operations. REMOVE OEM DOOR PANELS: • Remove plastic arm rest section that has window switch in it. • Remove switch assembly from plastic housing (leave plu

Résumé du contenu de la page N° 3

INSTALL DOOR PANELS AND WINDOW GAURDS: • Install aluminum door panels with hardware provided • Install hinge and window guard on top of door panel with hardware provided • Lift window guard to installed position and mark mounting holes • Install top mounting bracket with #10 x ½ “ screws, making sure that holes in window guards align with holes in mounting bracket. Note: It will be necessary to bend the window guards to fit the contour of the vehicle door. • Install window guard into m

Résumé du contenu de la page N° 4

INSTALL CEILING AND WALLS: • Install ceiling with ¼-20 x ½” carriage bolts and serrated nuts. • Install front wall with ¼-20 x ½” carriage bolts • Install rear wall of K9 unit with ¼-20 x ½” carriage bolts. INSTALL TUNNELS & DOORS: • Loosely attach side tunnels to main housing 1/4-20 x ½” carriage bolts or 1/4-20 x ¾”carriage bolts depending on location. • Attach step to tunnel. Driver Side Tunnel MAIN HOUSING FINAL STEPS: • Mount rear housing use ¼-20 x 1-½” lag bolts. • Ti

Résumé du contenu de la page N° 5

OPTIONAL FAN: If optional fan has been purchased, install at this time. • Mount dome light switch as desired. A switch box is provided so switch can be mounted to K9 housing in various locations. (side of tunnel housing at top works very well). Wire to 12 volt power source. • Sheet metal seams and gaps need to be carefully silicone at floor area. (proper sealing of compartment will eliminate water from getting under K9 unit) • Allow silicone to dry overnight before placing in rubbe