Résumé du contenu de la page N° 1
LCD TV
OWNER’S MANUAL
LCD TV MODELS
15LS1RA
20LS1RA
Please read this manual carefully before operating
your set.
Retain it for future reference.
Record model number and serial number of the set.
See the label attached on the back cover and quote
this information to your dealer
when you require service.
P/NO : MFL34797015 (0705-REV00)
Printed in Korea
www.lge.com
Résumé du contenu de la page N° 2
Résumé du contenu de la page N° 3
Owner Manual Owner Manual Owner Manual Owner Manual Owner Manual Owner Manual Owner Manual Owner Manual WARNING IMPORTANT SAFETY INSTRUCTIONS Important safety instructions shall be provided with each apparatus. This information shall be given in a separate booklet or sheet, or be located before any operating instructions in an instruction for installation for use and supplied with the apparatus. This information shall be given in a language acceptable to the country where the apparatus is inte
Résumé du contenu de la page N° 4
Owner Manual Owner Manual Owner Manual Owner Manual WARNING IMPORTANT SAFETY INSTRUCTIONS WARNING W NOTE W Do not use water the product while cleaning. Never touch the power plug with a wet hand. 9 1 This may cause damaged the product or could give an elec- This may cause an electric shock. tric shock. Disconnect from the mains and remove all 2 connections before moving. Do not place the product in a built-in 3 installation such as a bookcase or rack. In case of smoke or strange smell from the
Résumé du contenu de la page N° 5
NOTE W Ensure the power cord doesn’t trail across Contact the service center once a year to 13 8 any hot objects like a heater. clean the internal part of the product. This may cause a fire or an electric shock. Accumulated dust can cause mechanical failure. Do not plug when the power cord or the plug The distance between eyes and the screen 14 9 is damaged or the connecting part of the should be about 5 - 7 times as long as diag- power outlet is loose. onal length of the screen. This may cause
Résumé du contenu de la page N° 6
CONTENTS WARNING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 PICTURE CONTROL Important Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Preset Picture Settings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 33 - Auto Picture Control (APC) - Preset . . . . . . . . . . 33 - Color Tone - Preset. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34 PREPARATION Manual
Résumé du contenu de la page N° 7
PREPARATION PREPARATION ACCESSORIES Ensure that the following accessories are included with your product. If an accessory is missing, please contact the dealer where you purchased the product. POWER TV INPUT Owner's Manual MTS A.PROG MEMORY/ERASE CAPTION 12 3 45 6 78 9 1.5V 1.5V 0 MUTE FCR CH Owner’s Manual Remote Control Batteries Power Cord Cable Management 5
Résumé du contenu de la page N° 8
PREPARATION PREPARATION FRONT PANEL INFORMATION Here shown may be somewhat different from your TV. Front Panel Controls MENU VOLUME POWER INPUT ENTER CHANNEL Button Button Button Button (F F,G G)Buttons (E E,D D)Buttons /I INPUT MENU ENTER VOL CH Remote Control Sensor Power Standby Indicator Illuminates red in standby mode. When the TV is turned on, the indicator blinks green and then illuminates green before the picture is displayed. 6
Résumé du contenu de la page N° 9
PREPARATION BACK PANEL INFORMATION Here shown may be somewhat different from your TV. Back Connection Panel 7 2 3 1 15 inches model ANTENNA IN RGB (PC/DTV) IN COMPONENT IN (480i/480p/720p) AUDIO VIDEO AUDIO (RGB) IN ( ) H/P VIDEO AUDIO S-VIDEO ( ) MONO ( ) AV IN 5 4 6 3 1 20 inches model SERVICE ONLY ANTENNA IN COMPONENT IN (480i/480p) VIDEO AUDIO ( ) H/P VIDEO AUDIO S-VIDEO (MONO ) AV IN ( ) 5 4 1 5 COMPONENT IN AV (Audio/Video
Résumé du contenu de la page N° 10
PREPARATION PREPARATION STAND INSTALLATION Here shown may be somewhat different from your TV. Assemble parts of the stand body with cover base of the stand. Insert the stand body into a cover base 1 until clicking sound. stand body cover base Carefully place the product screen side down on a cushioned surface that will protect product and screen 2 from damage. Place the product stand on the product as shown. 3 Make sure that the stand body is bent upward. 8
Résumé du contenu de la page N° 11
PREPARATION DETACHING STAND Here shown may be somewhat different from your TV. Carefully place the product screen side down on Hold the stand with both hands and bend it 1 2 a cushioned surface that will protect product and upward. screen from damage. Hold cover base and pull with shake it backward Pull each side of cover base backward during 3 4 to separate from stand body. pressing latch upward. Pull stand body to separate from set while press- 5 ing the 2 latches. 9
Résumé du contenu de la page N° 12
PREPARATION PREPARATION BACK COVER FOR WIRE ARRANGEMENT Here shown may be somewhat different from your TV. Connect the cables as necessary. 1 To connect an additional equipment, see the E EX XT TE ER RN NA AL L E EQ QU UIIP PM ME EN NT T S SE ET TU UP P section. Install the C CA AB BL LE E M MA AN NA AG GE EM ME EN NT T as shown. 2 How to remove the CABLE MANAGEMENT First, press the cable management. Hold the C CA AB BL LE E M MA AN NA AG GE EM ME EN NT T with both hands and pull it upward. !
Résumé du contenu de la page N° 13
PREPARATION 0 3 POSITIONING YOUR DISPLAY Here shown may be somewhat different from your TV. Adjust the position of the panel in various ways for maximum comfort. • • T Tiillt t r ra an ng ge e DESKTOP PEDESTAL INSTALLATION For proper ventilation, allow a clearance of 4inches on all four sides from the wall. 4 inches 4 inches 4 inches 4 inches R CAUTION G G Ensure adequate ventilation by following the clearance recommendations. 11 12~10
Résumé du contenu de la page N° 14
PREPARATION PREPARATION KENSINGTON SECURITY SYSTEM - The TV is equipped with a Kensington Security System connector on the back panel. Connect the Kensington Security System cable as shown below. - For the detailed installation and use of the Kensington Security System, refer to the user’s guide provided with the Kensington Security System. For further information, contact h ht tt tp p::/ // /w ww ww w..k ke en ns siin ng gt to on n..c co om m, the internet homepage of the Kensington company. Ke
Résumé du contenu de la page N° 15
PREPARATION ANTENNA OR CABLE CONNECTION 1. Antenna (Analog or Digital) Wall Antenna Socket or Outdoor Antenna without a Cable Box ( ) Connections. For optimum picture quality, adjust antenna direction if needed. Multi-family Dwellings/Apartments Wall (Connect to wall antenna socket) Antenna Socket ANTENNA IN ( ) RF Coaxial Wire (75 ohm) Outdoor ( ) Antenna Single-family Dwellings /Houses (VHF, UHF) ( ) Copper Wire (Connect to wall jack for outdoor ante
Résumé du contenu de la page N° 16
EXTERNAL EQUIPMENT SETUP EXTERNAL EQUIPMENT SETUP To prevent the equipment damage, never plug in any power cords until you have finished connecting all equipment. This part of EXTERNAL EQUIPMENT SETUP mainly use picture for the 15 inches model. HD RECEIVER SETUP To watch digitally broadcast programs, purchase and connect a digital set-top box. When connecting Component cable 1. How to connect ( ) Connect the video outputs Y, PB, PR of the digital set RGB (PC/D 1 COMPONENT IN top box to the
Résumé du contenu de la page N° 17
EXTERNAL EQUIPMENT SETUP When connecting with a D-sub 15 pin cable (15 inches only) 1. How to connect ANTENNA IN RGB (PC/DTV) IN Connect the RGB output of the digital set-top box to 1 the R RG GB B ( (P PC C/ /D DT TV V) ) IIN N jack on the set. AUDIO UDIO (RGB) IN Connect the audio outputs of the set-top box to the 2 A AU UD DIIO O ( (R RG GB B) ) IIN N jack on the set. VIDEO AUDIO S-VIDEO (MONO ) AV IN 2. How to use 2 1 Turn on the digital set-top box. ( ) Refer to the owner’s ma
Résumé du contenu de la page N° 18
EXTERNAL EQUIPMENT SETUP EXTERNAL EQUIPMENT SETUP DVD SETUP When connecting Component cable 1. How to connect RGB (PC COMPONENT IN ( ) Connect the video outputs Y, PB, PR of the DVD to (480i/480p/720p) 1 VIDEO AUDIO the C CO OM MP PO ON NE EN NT T IIN N V VIID DE EO O jacks on the set. Match the jack colors ( ) Y = green, PB = blue, and PR = red . VID Connect the audio outputs of the DVD to the 2 C CO OM MP PO ON NE EN NT T IIN N A AU UD DIIO O jacks on the set. 1 2 2. How to use Turn on th
Résumé du contenu de la page N° 19
EXTERNAL EQUIPMENT SETUP When connecting with an S-Video cable 1. How to connect Connect the S-VIDEO output of the DVD to the AUDIO 1 L R S-VIDEO S S - -V VIID DE EO O input on the set. Connect the audio outputs of the DVD to the A AU UD DIIO O 2 input jacks on the set. 2 1 2. How to use Turn on the DVD player, insert a DVD. ANTENNA IN RGB (PC/DTV) IN Select A AV V input source by using the IIN NP PU UT T button on the AUDIO remote control. (RGB) IN Refer to the DVD player's manual for ope
Résumé du contenu de la page N° 20
EXTERNAL EQUIPMENT SETUP EXTERNAL EQUIPMENT SETUP VCR SETUP ( ) To avoid picture noise interference , leave an adequate distance between the VCR and TV. If the 4:3 picture format is used; the fixed images on the sides of the screen may remain visible on the screen. This phenomenon is common to all manufactures and in consequence the manufactures warranty does not cover the product bearing this phenomenon. When connecting with an antenna ANTENNA IN RGB (PC/DTV) IN 1 AUDIO O ANT OUT L R VIDEO
